Inhaltszusammenfassung zur Seite Nr. 1
H-CMD4005
MULTIMEDIA DVD/CD/MP3 RECEIVER WITH BUILT-IN 3” TFT
DISPLAY AND TV TUNER
Instruction manual
DVD/CD/MP3- 3”
TFT-
Inhaltszusammenfassung zur Seite Nr. 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents........................................................................................................................................2 Important safeguards..............................................................................
Inhaltszusammenfassung zur Seite Nr. 3
Important safeguards Using the device at temperature below -10º may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! Read carefully through this manual to familiarize yourself with this high-quality sound system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating
Inhaltszusammenfassung zur Seite Nr. 4
Installation/ connection Din front-mount (method 1) After inserting the holder into the dashboard, select the appropriate tab and bend them inwards to secure the holder in place. Insert fingers into the groove in the front of frame and remove it. Insert the levers supplied with the unit to the grooves at both sides. The unit can be installed or removed from the dashboard. 1. Dashboard 2. Spring washer 3. Screw (5 x 25mm) 4. Screw 5. Strap 6. Plain washer frame Removing the unit Insert finger
Inhaltszusammenfassung zur Seite Nr. 5
Din rear-mount (method 2) Installation using the screw holes at both sides of the unit. 1. Select a position where the screw holes of the main unit are fitted for aligned, and tighten the screws at 2 positions at each side. Use either truss screws (5 x 5 mm), depending on the shape of the screw holes in the bracket. 2. Screw. 3. Factory radio mounting bracket. 4. Dashboard or Console. 5. Hook (Remove this parts). Note: The mounting box, outer trim ring and the half-sleeve are not used for this m
Inhaltszusammenfassung zur Seite Nr. 6
Detachable control panel Detaching the front panel 1. Press the REL button to remove the panel. Attaching the control panel 1. Insert the left side of the control panel into the main unit. 2. Press the control panel on to the right side of middle of it until a “click” sound is heard. Caution: DO NOT insert the control panel from the right side. It can damage the control panel. The control panel can easily be damaged by shocks. After removing it, place it in a protective case and be careful not t
Inhaltszusammenfassung zur Seite Nr. 7
Electrical connection Note: For your driving safety, please link your parking wire with low power level, and keep it controlled by manual brake switch. Wire should be high power level and the unit cannot play video disc. 7
Inhaltszusammenfassung zur Seite Nr. 8
Caution: Do not interchange the connection of the wiring!!! For some car models you may need to modify wiring of the supplied power cord. Contact your authorized car dealer before installing this unit. Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit. 3. Cut
Inhaltszusammenfassung zur Seite Nr. 9
Panel controls Front panel 1. MD button Press it to select the mode: =>TUNER (radio) => DISC (the type of disc in the unit) => USB => SD/MMC => AUX => TV=>. 2. VOL knob+/- Rotate VOL knob clockwise to increase the volume level; rotate anticlockwise to decrease the volume level. 3. ANG button Use it to adjust the panel angle. 4. 2/INT button In Tuner mode use it as tuner preset button. 9
Inhaltszusammenfassung zur Seite Nr. 10
In Disc mode press it to start Intro playing. 5. 1/PLAY/PAUSE button In Tuner mode use it as tuner preset button. In Disc mode press it to start playback. Press during playback to pause it. Press again to resume. 6. TFT display 7. Infra red sensor 8. 4/RDM button In Tuner mode use it as tuner preset button. In Disc mode press it to start random playing. 9. APS button In Tuner mode press it to scan the preset memorized stations. Press it and hold for 2 seconds to store the programs with the best
Inhaltszusammenfassung zur Seite Nr. 11
16. 3/RPT button In Tuner mode use it as tuner preset button. In Disc mode press it to start repeat playing. 17. 6/+10 button In Tuner mode use it as tuner preset button. In MP3/WMA mode, long press it to go to the next 10 track. 18. 5/-10 button In Tuner mode use it as tuner preset button. In MP3/WMA mode, long press it to go to the last 10 track. 19. USB jack 20. UP/DN/AF/TA buttons In Disc mode press the UP/DN buttons to go to the next/previous track. Press and hold for 2 second
Inhaltszusammenfassung zur Seite Nr. 12
Remote control 1. EQ button – press to select the corresponding equalizer preset modes to adjust the sound quality. 2. PWR button - press it to turn the power on, press again to turn the power off. 3. MODE button - press it to select the mode: => TUNER => DISC (the type of disc in the unit) => USB => SD/MMC => AUX => TV =>. 4. MU button - press it to cut down the volume output, press it again or press +/- buttons to resume volume. 5. SEL button - press SEL button repeatedly to select the modes:
Inhaltszusammenfassung zur Seite Nr. 13
15. AUDIO button – In DVD mode press it to select audio language. In VCD mode press it to select the channel. 16. A-B button - press it to start repeating of the A-B fragment. 17. OSD button - Press it to show the information on display. 18. PROG button - During playback press this button to enter the program window. Use the buttons to select items of program list and adjust them. 19. P/N / BAND button – in Tuner mode press it to select the desired band. In DVD mode press it to choose TV
Inhaltszusammenfassung zur Seite Nr. 14
During video CD playback press it to open the disc menu. 31. SUBTITLE button - Press it to select the subtitle language. 32. LOUD button - Press it to turn the LOUD function on or off. 33. STEP button - Press it consecutively to display the still frame forward with step by step. Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the
Inhaltszusammenfassung zur Seite Nr. 15
General operation Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press the RESET button on the panel to restore the unit to the original factory settings. Power on/off Press POWER button on the panel or PWR button on the RC to turn the unit on. Long press the POWER button on the front panel or briefly press the PWR button on the RC to turn the unit off. Note: After the unit is off, the volume level and radio current settings will
Inhaltszusammenfassung zur Seite Nr. 16
Mode control Press the MD button on the panel or MODE button on the RC to select the different playing modes: => TUNER => DISC (the type of disc in the unit if there is any) => USB (if the USB device is inserted) => CARD (if the SD/ MMC card is inserted) => AUX => TV =>. Clock setting 1. Press the CLK button on the RC to show the clock on the display. 2. Press and hold for 2 seconds the CLK button, the hour will change its color. 3. Press the +/- buttons on RC or rotate the VOL knob on the panel
Inhaltszusammenfassung zur Seite Nr. 17
Digital tuner Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Band selection Press the MD button on the panel or MODE button on the RC to select the TUNER mode. Press P/N / BAND button on the RC or BD button on the panel once or more to select: FM1, FM2, FM3, AM1, AM2. Display will show the wave band, frequency and preset station number if already stored. Manual/ a
Inhaltszusammenfassung zur Seite Nr. 18
Preset scan function Press the APS button to scan all preset stations in the memory of the current band and stay on each memory stations for about 5 seconds. To stop preset scan, press this button again. Auto memory store function Press the APS button on the panel and hold for 2 seconds to enter auto store mode. The radio will automatically store the 6 strongest available stations to the 6 preset memories of the current band. To stop auto store, press this button again. Mono/Stereo selection Pre
Inhaltszusammenfassung zur Seite Nr. 19
AF (Alternative Frequencies) function Press the AF button briefly to switch on/ off mode. Symbol “AF” will appear on the display. Note: The tuner will return to Alternative Frequencies whenever the reception signals getting worse. “Alarm” will be displayed when an emergency broadcasting is received. Meanwhile sound output level will be adjusted to the preset output level automatically when the volume control is set at minimum. PTY (Program Type) function 1. Press the PTY button on the RC to turn
Inhaltszusammenfassung zur Seite Nr. 20
Disc operations Disc glossary PBC (PlayBack Control) PBC is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc. For example, if a disc contains three films, th
