Bedienungsanleitung Demco HONDA CIVIC TP20111

Inhaltszusammenfassung zur Seite Nr. 1

11-02
TP20111, REV.1
ASSEMBLY
2001-03 HONDA CIVIC
OPERATION
REPLACEMENT PARTS
BOLT TORQUE SPECIFICATIONS READ complete manual CAREFULLY
BEFORE attempting operation.
STANDARD BOLTS:
METRIC BOLTS:
Size Grade Torque
Size Torque
5
1
5/16" 5 20 ft/lbs.
8mm 22 ft/lbs.
3/8" 5 35 ft/lbs.
10mm 42 ft/lbs.
7/16" 5 56 ft/lbs. 13
12mm 70 ft/lbs.
11
1/2" 5 85 ft/lbs. 2
14mm 95 ft/lbs. 12
3
10
1
Pin Height - 13
Center - 24

15
9
14
1
4
2
8
3
7
6
2
3
7
6
14
3
15
16
2
3
2
1
1
4
5
1
2
3
9517111 PARTS LIST
REF

Inhaltszusammenfassung zur Seite Nr. 2

WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN LOSS OF TOWING VEHICLE CONTROL, SEPARATION OF THE TOW BAR FROM THE TOWING VEHICLE, SEPARATION OF THE TOWED VEHICLE FROM THE TOW BAR, CAUSING SEVERE PERSONAL INJURY, DEATH, OR PROPERTY DAMAGE. IMPORTANT INSTALLATION ITEMS DEMCO products and accessories are intended to

 be installed by professional installers with experi- Safety is of utmost importance at all times. There are several items ence, proper equipment and the ability t

Inhaltszusammenfassung zur Seite Nr. 3

5. Remove six bolts that hold bumper on, four on the top 2. Remove one screw from each side, facia to fender. side and two underneath. Set bumper aside tempo- rarily. 3. Remove six plastic push fasteners from bottom side of facia and one screw from each side that attaches to wheel well extension. 6. Remove three bolts that hold windshield washer tank and also remove bolt that holds horn and let horn hang. NOTE: The horn bolt will not be reused. 7. Drill out two holes on front of vehicle, one o

Inhaltszusammenfassung zur Seite Nr. 4

8. Slide spacer bushing into large hole in frame, on each side, from inside of frame outwards. 11. Drill 3/8
holes, two on each side, through sides of base plate as shown in pictures. Use 3/8
x 1
bolts, 3/8
lock washers, and 3/8
hex nuts. Tighten these bolts. 12. Reinstall bumper with the six bolts 9. With an assistant, slide base plate on frame and install 1/2
x 3-1/2
bolt through base plate and previously installed spacer bushing. On inside of frame, use heavy frame washer, 1/2
lock