Bedienungsanleitung Metra Electronics 99-8208

Inhaltszusammenfassung zur Seite Nr. 1

INSTALLATION INSTRUCTIONS FOR PART 99-8208
Applications
TOYOTA Sienna
2004-2010
99-8208
KIT FEATURES
• DIN Head Unit Provisions with Pocket
• ISO DIN Head Unit Provision with Pocket
KIT COMPONENTS
A) Radio Housing • B) ISO Brackets • C) Trim Plate
B
C
A
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
• 70-1761 - Toyota harness 1987-up
• TYTO-01 - Toyota amp interface harness 2003-up
Antenna Adapter:
• Not required
TOOLS REQUIRED:
Small Flat Blade Screwdriver • Socket W

Inhaltszusammenfassung zur Seite Nr. 2

99-8208 • Dash Disassembly - 2004-2010 Toyota Sienna ---------------------------------------- 1 •Kit Assembly - DIN Head Unit Provision with Pocket ---------------------------- 2 - ISO DIN Head Unit Provision with Pocket ------------------------ 3 •Final Assembly ------------------------------------------------------ 4 •Notes ----------------------------------------------------------------- 5 KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized

Inhaltszusammenfassung zur Seite Nr. 3

DASH DISASSEMBLY 99-8208 2004-2010 TOYOTA SIENNA Disconnect the negative battery terminal 1 A to prevent an accidental short circuit. Unclip and remove panels from left and 2 right side of radio. Figure A 3 Unclip and remove panel or speaker cover B above radio. Figure B 4 Remove (4) 10MM bolts from radio to remove. Figure C C 1

Inhaltszusammenfassung zur Seite Nr. 4

99-8208 DIN Head Unit Provision with Pocket Slide the DIN cage into the Radio 1 Housing and secure by bending the metal locking tabs down. Slide the after-market head unit 2 into the cage until secure. 2 KIT ASSEMBLY

Inhaltszusammenfassung zur Seite Nr. 5

KIT ASSEMBLY 99-8208 ISO DIN HEAD UNIT PROVISIONS Mount the ISO Brackets to the head 1 unit with the screw supplied with the unit. Slide the head unit into the radio 2 opening until the side clips engage. 3 Snap the trim plate into the radio Housing. 3

Inhaltszusammenfassung zur Seite Nr. 6

99-8208 A A) Strip wire ends back 1/2" B B) Twist ends together C) Solder C D) Tape D Locate the factory wiring harness in the dash. 1 Metra recommends using the proper mating adapter and making the connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit) 2 Re-connect the negative battery terminal and test the unit for proper operation. 3 Reassemble in reverse order of disassembly. 4 FINAL ASSEMBLY

Inhaltszusammenfassung zur Seite Nr. 7

NOTES 99-8208 5

Inhaltszusammenfassung zur Seite Nr. 8

INST99-8208 1-800-221-0932 www.metraonline.com REV. 04-27-10 © COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION INST99-8208