Inhaltszusammenfassung zur Seite Nr. 1
STAINLESS STEEL LP GAS GRILL
MODEL NO.: 720-0163 ITEM NO: 18852
Jenn-Air is a Trademark of the Maytag Corporation and is used under license to Lowe’s Companies, Incorporated.
FOR OUTDOOR USE ONLY
PLEASE CONTACT 1-800-554-5799 FOR ASSISTANCE
DO NOT RETURN TO PLACE OF PURCHASE
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS SECTION ONE SECTION FIVE Safety Instructions…………………………… 1-5 Exploded View……………………………… 21 Placement of the Grill ……………………… 5 Parts List…………………………………… 22 SECTION TWO SECTION SIX Side Burner & Side Shelf Assembly……….. 6 Grilling Hints……………………………….. 23 Side Burner Hose Quick-Connect Assembly
Inhaltszusammenfassung zur Seite Nr. 3
SAFETY INSTRUCTIONS RECOGNIZED SAFETY SYMBOLS, WORDS AND LABELS WARNING WARNING Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section of this manual. WARNING – Hazards or unsafe practices which COULD result in severe personal injury or death. WARNING Spiders and insects can nest inside the burners of CAUTION the grill and disrupt gas flow. This very dangerous condition could cause a fire behind the valve pane
Inhaltszusammenfassung zur Seite Nr. 4
SAFETY INSTRUCTIONS CAUTION WARNING When using a match to light the grill make Do not use the grill if the odor of gas is present. sure to use the attached lighting rod. Contact customer service at 1-800-554-5799. CAUTION Before cleaning, make sure the gas supply WARNING and control knobs are in the “OFF” position When lighting, keep your face and hands and the burners have cooled. as far away from the grill as possible. WARNING Failure to properly place
Inhaltszusammenfassung zur Seite Nr. 5
SAFETY INSTRUCTIONS USING THE SIDE BURNER WARNING Inspect the gas supply hose prior to turning on Do not attempt to light the grill if gas odor is the gas. If there is evidence of cuts, wear or present. Contact customer service at 1-800- abrasion, it must be replaced prior to use. Do 554-5799. not use the side burner if gas odor is present. When lighting, keep your face and body as far Keep a spray bottle of soapy water near the away from the burner as possible. gas supply val
Inhaltszusammenfassung zur Seite Nr. 6
SAFETY INSTRUCTIONS The grill is not intended to be installed in or on WARNING recreational vehicles and/or boats. Do not try lighting this appliance without first reading the “LIGHTING INSTRUCTIONS” section Children should not be left alone or unattended in of this manual. an area where the grill is being used. Do not allow children to sit, stand or play on or around TESTED IN ACCORDANCE WITH ANSI Z21.58 the grill at any time. LATEST STANDARD and CSA 1.6 LATEST STANDARD FO
Inhaltszusammenfassung zur Seite Nr. 7
SAFETY INSTRUCTIONS When using the grill, do not touch the grill rack, Turn off all control knobs and make certain the grill burner grate or immediate surroundings as these is cool before using any type of aerosol cleaner on areas become extremely hot and could cause or around it. The chemical that produces the burns. Use only dry potholders. Moist or damp spraying action could, in the presence of heat, potholders on hot surfaces may cause steam burns. ignite or cause metal parts to corrod
Inhaltszusammenfassung zur Seite Nr. 8
SIDE BURNER & SIDE SHELF ASSEMBLY Estimated Assembly Time: Approximately 10 minutes Required Tools: Phillips Screwdriver (not included) 1. Remove both side burner and side shelf from inside grill cart. 2. The screws used to attach the side shelf and side burner are already screwed into the side of the grill cart. Remove the screws from the side panels. 3. Align the holes of the left side shelf with those in the grill cart, insert the screws and tighten. Note: The
Inhaltszusammenfassung zur Seite Nr. 9
SIDE BURNER HOSE QUICK-CONNECT ASSEMBLY Estimated Assembly Time: Approximately 5 minutes No Tools Required 1. Insert the side burner hose with female sleeve through side panel of cart (Top drawing). 2. Push the sleeve of the female socket back and insert male end of the connector. Release the sleeve. 3. Push the socket until the female sleeve snaps forward to lock the fitting. 4. To disconnect the fitting, push the female sleeve back and pull the socket off the plug (bott
Inhaltszusammenfassung zur Seite Nr. 10
SIDE SHELF HANDLE ASSEMBLY Estimated Assembly Time: Approximately 5-7 minutes Required Tools: Phillips Screwdriver 1. Remove the four side shelf handle screws from the side of the shelf. 2. Align the holes in the side shelf handle with the holes in the side shelf. 3. Insert the screws and tighten. BATTERY INSTALLATION 1. Remove the ignition button housing. 2. Insert the battery into the housing with the positive terminal facing outward. 3. Replac
Inhaltszusammenfassung zur Seite Nr. 11
BRAKING SYSTEM OPERATIONS Push right to lock. 1 1 Push left to unlock. LIQUID PROPANE CYLINDER RETENTION SYSTEM 1. Attach the liquid propane gas cylinder to the slide-out tray using the gas cylinder retention screw. Turn the retention screw clockwise to tighten the gas cylinder. Retention Screw 9 2 2
Inhaltszusammenfassung zur Seite Nr. 12
CLOSE SLIDE-OUT TRAY LOCKING SYSTEM 1. To lock and unlock the liquid propane gas cylinder tray, press the gas cylinder tray’s top button to lock. Press the side button to unlock. PROPANE REGULATOR HOOK-UP 1. Attach the regulator to the propane cylinder by turning the regulator handle clockwise. 2. Turn off the gas supply at the cylinder when the appliance is not in use. g 10 OPEN
Inhaltszusammenfassung zur Seite Nr. 13
GAS HOOK-UP Only the pressure regulator and hose assembly The liquid propane cylinder must be fitted with an supplied with the grill should be used. Any Overfill Protection Device (OPD). replacement pressure regulator and hose assembly must be specified by the grill manufacturer. Remove the plastic valve cover from the liquid propane cylinder. Make sure the grill’s gas hoses This is a liquid propane configured grill. Do not do not contact the grease tray or grill firebox when a
Inhaltszusammenfassung zur Seite Nr. 14
LEAK TESTING GENERAL Only those parts recommended by the Although gas connections on the grill are leak manufacturer should be used on the grill. tested prior to shipment, a complete gas tightness Substitutions will void the warranty. check must be performed at the installation site. Periodically check the whole system for leaks GAS FLOW CHECK following the procedures listed below. Each grill burner is tested and adjusted at the factory prior to shipment. However, variations in
Inhaltszusammenfassung zur Seite Nr. 15
INSTALLER FINAL CHECK Specified clearance maintained 24 inches The unit has been tested and is free of leaks. from combustible materials/construction. The gas supply shut off valve has been All internal packaging has been removed. located. The hose and regulator are properly All burners are factory installed. connected. WARNING 1. Do not store spare liquid propane cylinders under or near this appliance. 2. Never fill the cylinder beyo
Inhaltszusammenfassung zur Seite Nr. 16
OPERATING INSTRUCTIONS GENERAL USE OF THE GRILL AND ROTISSERIE Each main burner is rated at 15,000 BTU/Hr. The After its first use, the stainless steel adjacent to the main grill burners encompass the entire cooking rotisserie burner will most likely turn dark blue. This area and are side ported to minimize blockage from is a normal property of the non-rusting type falling grease and debris. Above the burners are stainless steel used on the grill. stainless steel flame tamers. The igni
Inhaltszusammenfassung zur Seite Nr. 17
NOTE Adjust the counter balance weight to balance the It is normal for the skewer to flex when larger cuts heavier side of the meat and avoid lopsided rotation of meat are being cooked. of the rotisserie motor. If the meat scrapes on the cooking grids during any CAUTION part of the rotation, the cooking grids must be When using the rotisserie burner, remove the removed. Test this clearance before lighting the warming rack. High heat from the burner may cause grill as the cooking
Inhaltszusammenfassung zur Seite Nr. 18
TO MATCH LIGHT THE GRILL If the burner will not light after several attempts using the control knobs, the burner may be lit with a match. 1. If you have already attempted to light the burner with the igniter, allow 5 minutes for any accumulated gas to dissipate. 2. Insert a match into the lighting rod. Ignite the match and insert through the cooking grids to the burner. 3. Press the control knob and rotate left to the “HI” setting, continue to press the knob until the burner
Inhaltszusammenfassung zur Seite Nr. 19
LIGHTING ILLUSTRATIONS MAIN, SIDE & ROTISSERIE BURNER LIGHTING 1. Open the top cover or lid. 2. Push and turn the main, side, or rotisserie burner control knobs to the “HI” setting. Push the control knob until the burner ignites. The burner should ignite within 4 seconds (if burner does not ignite follow match lighting instructions on Page 16). 3. Once the burner ignites, adjust t
Inhaltszusammenfassung zur Seite Nr. 20
USING THE SIDE BURNER 4. If the smell of gas is detected and the igniter Inspect the gas supply hose prior to turning on is not functioning, immediately turn the control the gas. If there is evidence of cuts, wear or knob to the “OFF” position. abrasion, it must be replaced prior to use. Do not use the side burner if gas odor is present. 5. Allow 5 minutes for any accumulated gas to dissipate. If the side burner igniter will not function, follow the match lighting instruct
