Bedienungsanleitung Dakota Alert WIRELESS RECEIVER WR-3000

Inhaltszusammenfassung zur Seite Nr. 1

™
Dakota Alert
WR-3000
Wireless
Receiver

Owner’s Manual

Inhaltszusammenfassung zur Seite Nr. 2

} } WR-3000 RECEIVER INSTRUCTIONS OPERATION 1. Connect the end of the power supply to the receiver. (1) WARNING 2. Plug the power supply into a wall outlet This device complies with Part 15 of the FCC rules, operation of this device is 3. Locate the off/on switch (2) and move to the “on” position. subject to the following conditions: 1. This device may not cause harmful in- 4. Press the “test” button (3) on the side of the receiver to determine the terference. 2. This device must accept

Inhaltszusammenfassung zur Seite Nr. 3

For maximum range between the transmitter and receiver, the receiver 2. The fi rst 8 dip switches (6) are for the frequency setting (256 combina- should be mounted horizontally on a wall and as high off the fl oor as pos- tions). Set the fi rst 8 switches to match the 8 switches in the receiver. sible. Although the maximum range is about 3000 feet, things such as hills, 3. Switches 9 & 10 (7) are for the zone/channel setting on the transmitter. trees, metal siding and stucco can all reduce the r

Inhaltszusammenfassung zur Seite Nr. 4

4. The channel 1 relay and the 12 VDC output can be set to operate for TECHNICAL SUPPORT 4 seconds or 10 minutes. To change the duration, locate the jumper (8) If you encounter any diffi culty in the operation of this product after reading on the upper right hand corner of the circuit board. When the jumper is the manual, please contact us. You can reach us by phone at 605-356-2772 covering both pins, the output time is 4 seconds. When the jumper is only from 8:30 AM to 5:00 PM Monday thro

Inhaltszusammenfassung zur Seite Nr. 5

Dakota Alert, Inc. 109 W. Main St. P0 Box 130 Elk Point, SD 57025 Phone: (605) 356-2772 Fax: (605) 356-2584 Web: www.dakotaalert.com