Bedienungsanleitung Chief Manufacturing MWC Series

Inhaltszusammenfassung zur Seite Nr. 1

INSTALLATION INSTRUCTIONS
MEDIUM FLAT PANEL TILT WALL MOUNT WITH
INTEGRATED CPU
Model: MWC Series
Specifications:
 Accommodates three installation options:
- Dual Wood Stud (16" on-center; requires
5/16" x 2-1/2" long hex head lag screws -
included)
- Dual Steel Stud (requires Chief PAC-115
Steel Stud / Drywall Anchor Kit - not included)
- Drywall (1/2" minimum; requires Chief PAC-
115 Steel Stud / Drywall Anchor Kit - not
included)
 Accommodates CPU up to approximately 18-3/4"
x 3-3/4"; see "

Inhaltszusammenfassung zur Seite Nr. 2

Model: MWC Series Installation Instructions IMPORTANT WARNINGS AND CAUTIONS! WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions. CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the corresponding instructions. WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury or damage to equipment! It is the installer’s respon

Inhaltszusammenfassung zur Seite Nr. 3

Installation Instructions Model: MWC Series TOOLS REQUIRED FOR INSTALLATION PARTS  Stud Sensor After unpacking carton, inspect and verify contents (See Figure 1). If any listed parts are missing or  Drill damaged, contact Chief Customer Service at 1-800-582-  5/32" Drill Bit 6480.  1/2" Wrench  5/32" Security Hex Key (included) Table 1: Parts NOTE: Other tools may be required depending on your method of installation. Item Description Qty 10 MOUNT, MWC Series 1 20 STRAP, 1" x 6’ Polypropyl

Inhaltszusammenfassung zur Seite Nr. 4

Model: MWC Series Installation Instructions INSTALLATION CPU INSTALLATION MOUNT INSTALLATION WARNING: Exceeding the weight capacity can result Three installation options exist: in serious personal injury or damage to equipment! It is  Dual Wood Stud (16" on-center; requires 5/16" x the installer’s responsibility to make sure the combined 2-1/2" long hex head lag screws) weight of all components attached to the MWC Series  Dual Steel Stud (requires Chief PAC-115 Steel Wall Mount, including the

Inhaltszusammenfassung zur Seite Nr. 5

Installation Instructions Model: MWC Series DISPLAY INSTALLATION WARNING: Exceeding the weight capacity can result Side Plates in serious personal injury or damage to equipment! It is the installer’s responsibility to make sure the combined weight of all components attached to the MWC Series Wall Mount, including the CPU and display, does not exceed 100 lbs (45 kg). 1. Install interface (providing 200x200mm mounting button pattern) to display. See instructions supplied 20 with interface. 2. Ro

Inhaltszusammenfassung zur Seite Nr. 6

Model: MWC Series Installation Instructions NOTE: If Q-Latch does not fully close, ensure mounting TILT LOCK buttons are fully seated in the button openings. 1. If desired, the display may be locked at 0°, 5°, or 10°. NOTE: A hole is provided in both the Q-Latch and the NOTE: A positive stop exists at 15° without the use of an front plate to accommodate the insertion of a additional locking screw. padlock or similar locking device.  Slightly loosen the upper front plate attach screws. Do NOT re