Inhaltszusammenfassung zur Seite Nr. 6
LY =l ii , = , Read these instructions and this manual in its entirety SIDE DISCHARGING (See Fig, 2B) - before you attempt to assemble or operate your new lawn * Mutcher plug must be installed into rear discharge mower. Your new lawn mower has been assembled at the opening of mower (see above instructions), factory with the exception of those parts left unassembled o Unlock closed discharge guard by lifting latch and allow for shipping purposes. Al! parts such as nuts, washers, guard to swing op
Inhaltszusammenfassung zur Seite Nr. 7
TO ASSEMBLE AND ATTACH GRASS CATCHER (See Figs. 3A thru 4) • To assemble tubular frame to grass bag, work sewn hem of bag out through the front opening of bag to expose the hem° TUBULAR • Thread tubular frame into hem and gather material at FRAME top of frame as shown° (PUsh inside ° Push frame inside bag through the opening until only bag) the ends of frame are exposed out of the front, NOTE: Do not dose the flip lid at this time° ° Assemble lower frame to tubular frame as shown Be sure frames
Inhaltszusammenfassung zur Seite Nr. 8
TO PREPARE BATTERY NOTE: Your'battery must be charged before you can start ENGINE your lawn mower_ CONNECTOR . Connect battery charger connector (male) to battery connector (female), • Plug battery charger into 110 volt A,C_ outteL o Leave battery charger connected for 24 hours before starting your engine for the first time, BATTERY o After charging, connect engine connector to battery CHARGER connector'. Your engine has an integral alternator for partial charging. BATTERY CHARGER Connect your b
Inhaltszusammenfassung zur Seite Nr. 9
OPERATNON nnnnll KNOW YOUR LAWN MOWER READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER, Compare the illustrations with your lawn mower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference_ STARTER BUTTON ENGINEZONECONTROLCABLE OPERATOR PRESENCE CONTROL BAR DRIVE CONTROL LEVER AUXILIARY STARTER HANDLE CABLE CLIP GASOLINE CAP GRASS CATCHER PRIMER MULCHER PLUG SPEED CONTROL DRIVE COVER ENGINE OIL CAP W/DIPSTIC
Inhaltszusammenfassung zur Seite Nr. 10
, I!,HH .... = ..................... =' OPERATION ENGINESPEED HOW TO USE YOUR LAWN MOWER CONTROL LEVER ENGINE SPEED (See Fig. 6) The engine speed is controlled by a lever located on the side of the engine. Fast (=_) position is for starting the engine, normal cutting, and better grass bagging. Slow (,_) positionis for'tight cutting, trimrning and fuel economy ENGINE ZONE CONTROL CAUTION: Federal regulations require an engine control to be installed on this lawn mower in order to minimize the ris
Inhaltszusammenfassung zur Seite Nr. 11
TO EMPTY GRASS CATCHER (See Fig. 9) ,, Simply lift up rear door and remove the grass catcher by the handle_ NOTE: Do not drag the bag when emptying; it witl cause unnecessary wear, BEFORE STARTING ENGINE OIL (See Fig. '10) Your lawn mower is shipped without oil in the engine. o Be sure mower is level and area around oil fill is clean. o Remove engine oil cap w/dipstick and fill to the full line on the dipstick. • Use 20 ozs. of oil, For type and grade of oil to use, see FIG, 9 "ENGINE" in Custom
Inhaltszusammenfassung zur Seite Nr. 12
MOWING T PS MAX 1/3 . Under certain conditionS, such as very tall grass, itmay be necessary to raise the height of cut to reduce pushing effort and to keep from overloading the engine and leaving clumps of grass clfppings. ° For extremely heavy cutting, reduce the width of cut by overlapping previously cut path and mow slowly. o For better grass bagging and most cutting conditions, the engine speed should be set in the fast (,,_) posi- tion. • When using a rear' discharge lawn mower' in moist, h
Inhaltszusammenfassung zur Seite Nr. 13
MAINTENANCE SCHEDULE FILL IN DATES AS YOU COMPLETE REGULAR SERVICE SERVICE DATES Check for Loose Fasteners 6/ ............................ _ ........ clean/inspect Grass Catcher ..... . (If Equipped) __ 6/6/" Clean Lawn Mower i _ l Drive_Wheel----'_ Inspect/Clean .--_ . I ...... (Self-Propelled Mowers) 64" j___..__ _ _ ! R Sharpen/Replace Mower Blade _ ! 6/3 CieanBatie_/Recha_-ge ..... I., -- . I _--- {---- E Check Engine Oil Level N t Change Engine Oil | Inspect Muffler N Replace Spark Plug E i
Inhaltszusammenfassung zur Seite Nr. 14
.... ] i'q ,=,,,1== ......................... i,,,i,i] ......... i, ,, J,u,,t CUSTOME RESPONSnBtLI1TJES i ..... = =,,,,u n,,u ni,,n, .... n I" ,n,, ,,m,,,,, , = LAWN MOWER CRANK_ BLADE Always observe safety rules when performing any mainte- ADAPTER,,,,, nance° KEYWAY TIRES ,, Keep tires free of gasoline, oil, or insect control chemi- BLADE cals which can harm rubber. ° Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage,. BLADE CARE Forbestresults, mower b
Inhaltszusammenfassung zur Seite Nr. 15
IL ....... i. iii ,.u... i I .11i..i ................ i.. ,i.i. u CUSTOMER SLmTBES . .... ,,....11.1.1.1 ii................... ii lUl.. iiii.UlllUl,, i i .................................. _...... ,.11 ENGUNE LUBRICATION Use only high quality detergent oil rated with API service classification SG° Select the oil's SAE viscosity grade according to your expected operating temperature° SAE ViSCOSiTY GRADES "---'-"_'-'_'- CONTAINER °F -20 ° 0_ 30 = 32" 40 _ 60" 80" 100_ FIG. 13 T "c.30" .2o- -1o" o"
Inhaltszusammenfassung zur Seite Nr. 16
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS: Release control bar. Make sure the blade and all moving parts have completely stopped. o Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug. LAWN MOWER TO ADJUST CUTTING HEIGHT See "TO ADJUST CUTTING HEIGHT" in the Operation section of this manual. REAR DEFLECTOR DRIVE COVER The rear deflector, attached between the rear wheels of BELT your lawn mower, is provided to minimize the possibility that ob
Inhaltszusammenfassung zur Seite Nr. 17
r,l,_l, .,., ,,i,,,,,,,,,,i ...... i,,,,,,i, i .................. i,,,,i,ii, ii i, i,,,i ,.rl,ii iii SERVNCE AN ADJUSTMENTS ill'l"' I"' 'L ....................................... I'1111 II ............................ TO ADJUST HANDLE (See Figs, 16 Thru 18) SHIPPING POSITION Your lawn mower handle can be raised or lowered for your MEDIUM LOW MEDIUM HIGH mowing comfort. Four (4) positions are available: high, medium high, medium low and low. Handles are shipped mounted in the medium low position.
Inhaltszusammenfassung zur Seite Nr. 18
STORAGE Immediately prepare your lawn mower for sto_age at the ENGINE end of the season or' if the unit will not be used for 30 days or more_ FUEL SYSTEM IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL LAWN MOWER SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, When lawn mower is to be stored for a period of time, clean FUEL HOSE, OR TANK DURING STORAGE. ALSO, EXPERIENCE INDICATES THAT ALCOHOL BLENDED it thoroughly, remove all dirt, grease, leaves, etc.. Store in F
Inhaltszusammenfassung zur Seite Nr. 19
REPAIR PARTS 22" ROTARY LAWN MOWER - - MODEL NO. 917.373841 GEAR CASE ASSEMBLY PART NUMBER 702511 J /- 11 17 15 t7 10 14 lO I 9 19 /f' J KEY PART KEY PART NO. NO. DESCRIPTION NO, NO. DESCRIPTION 1 17490416 t3 86447 Plug Tapping Screw 1/4-20 x lq/4 14 137050 Helical Gear 2 I37055X004 Engagement Bracket 15 750436X Clutch Jaw 3 137O53 Shifter 16 750369 Grease 4 57072 Seal Grooved Pin 1/8 x 5/8 5 702710 17 12000003 E-Ring 6 48373 Gear Case Halves Kit (Includes Key 18 850848 Hi-Pro Key Nos 4, 5, and
Inhaltszusammenfassung zur Seite Nr. 20
REPAIR PARTS CRAFTSMAN 22" ROTARY LAWN MOWER MODEL NUMBER 917.373841 27 10 3O 22 13 12 35 62 55 28 51 24- 3O
Inhaltszusammenfassung zur Seite Nr. 1
®
MODEL NUMBER 917.373841
OWNER'S MANUAL
o Assembly
Operation
Customer
Responsibilities
Service
Adjustments
®Repair Parts
Caution:
Read and Follow
all Safety Rules
and Instructions
Before Operating
This Equipment
144812 03/21/94
Printed in UoSA
IIIIIIIIIII IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII III IIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIIII
, .,...., ii m ..... . , .
,i u-, , __uJ L ....
Inhaltszusammenfassung zur Seite Nr. 2
SAFETY RULES PLUG TO PREVENT ACCIDENTAL STARTINGWHEN SETTING UP, TRANSPORTING, ADJUSTING OR MAKING REPAIRS. IMPORTANT SAFETY STANDARDS REQUIRE OPERATOR PRESENCE CONTROLS TO MINIMIZE THE RISK OF INJURY° YOUR UNIT IS EQUIPPED WITH SUCH CONTROLS° DO NOT ATTEMPT TO DEFEAT THE FUNCTION OF THE OPERATOR PRESENCE CONTROLS UNDER ANY ClRCUM- STANCES_ TRAINING: ° Always stop the blade whenever you leave or are not using " Read this operator's manual carefully Become familiar with your mower, or before cros
Inhaltszusammenfassung zur Seite Nr. 3
CONGRATULATIONS on you r purchase of a Sears Lawn PRODUCT SPECIFICATIONS Mower. it has been designed, engineered and manufac- HORSEPOWER: 5°5 tured to give you the best possible dependability and performance_ DISPLACEMENT: 126 cu in. Should you experience any problem you cannot easily GASOLINE CAPACITY 1.,25quart remedy, please contact your nearest Sears Authorized AND TYPE: UNLEADED REGULAR Service Center/Departmento We have competent, well- trained technicians and the proper tools to service o
Inhaltszusammenfassung zur Seite Nr. 4
TABLE OF CONTENTS SAFETY RULES ............................................................ 2 MAINTENANCE SCHEDU LE ...................................... 13 PRODUCT SPECIFICATIONS ....................................... 3 SERVICE AND ADJUSTMENTS ................................. 16 CUSTOMER RESPONSIBILITIES ..................... 3, 13-15 STORAGE .................................................................... 18 WARRANTY ................................................................... 3
Inhaltszusammenfassung zur Seite Nr. 5
......................... i=,,,,11 ........ ,i,,, =,,,,=,, ,,i =,=, =., i ...... HI,,,=,=1 ,=1,, i i i =............................. These accessories were available when this lawn mower was produced° They are also available at most Sears retail outlets and service centers. Most Sears stores can also order repair parts for you, when you provide the model number of your lawn mower° Some of these accessories may not apply to your lawn mower_ ENGINE i,,H,, ................ i SPARK PLUG MUFFLER AIR
