Inhaltszusammenfassung zur Seite Nr. 1
Model MX690
Wireless Boundary Microphone
The Shure MX690 microphone offers cable-free installation for
corporate boardrooms or other applications requiring flexible
configurations. The MX690 operates within the 518–865 MHz
bands and is compatible with Shure SLX wireless systems.
©2008 Shure Incorporated
Printed in U.S.A.
27EN3240 (Rev. 3)
Inhaltszusammenfassung zur Seite Nr. 2
Features • Sleek, low profile design • Frequency agile, microprocessor controlled transmitter • IR link to SLX receiver for automatic frequency synchronization • Programmable frequency Group/Channel display • Programmable mute function • Operates on two AA batteries • Compatible with all Shure SLX Wireless systems • Commshield™ technology for protection from RF interference 2
Inhaltszusammenfassung zur Seite Nr. 3
Microphone Placement Place the MX690 within 1.5 m (5 ft.) of a talker. Aim the microphone toward the talkers and away from loudspeakers and noise sources. Use one microphone for every two talkers. Pickup angle with a cardioid cartridge is 130° at –3 dB. Note: To minimize RF interference, maintain a distance of at least 0.3 m (1 ft.) between transmitters. In case of interference, increase the distance between transmitters or change channels. 130º Receiver Make sure the receiver is within sig
Inhaltszusammenfassung zur Seite Nr. 4
Low-Cut Filter The low-cut filter attenuates frequencies below 150 Hz by 6 dB per octave. Filter disabled (as supplied) Low-cut filter 4
Inhaltszusammenfassung zur Seite Nr. 5
Battery Installation 1. Open the battery compartment as shown. 2. Insert two1.5V “AA” batteries. Make sure the +/– terminals are properly oriented. Note: Alkaline batteries last up to 8 hours. Rechargeable, carbon- zinc and zinc-chloride batteries provide less operating time. Power Meter The battery meter on the LCD shows remaining battery life. Low Power Indicator Steady Red: Power low. Replace batteries immediately Pulsing Red: Batteries dead. Transmitter cannot be turned on until b
Inhaltszusammenfassung zur Seite Nr. 6
Power On/Off 1. Press and hold the ON/OFF PROGRAM button for approximately 2 seconds. The LCD illuminates. 2. To turn the transmitter off, press and hold the ON/OFF PROGRAM button again. Note: Use the button on the bottom of the transmitter to power it on without opening the battery compartment. 6
Inhaltszusammenfassung zur Seite Nr. 7
Mute Button The mute button can be configured for toggle or momentary operation. Toggle (as supplied) The PUSH button toggles the microphone between active and muted states. NOTE: The microphone always powers up in the active state. Momentary There are two types of momentary operation: Push-to-Mute: The microphone is muted only while the button is pressed and held. Push-to-Talk: The microphone is active only while the button is pressed and held. To change between toggle and momentary: Hold
Inhaltszusammenfassung zur Seite Nr. 8
Mute Indicator The bi-color LED on the top of the microphone indicates whether the microphone is active or muted. The LED can also be set to flash when muted. Display Mode Status Indicator Steady Active = Green (as supplied) Muted = Red Flashing Active = Green Muted = Flashing Green To toggle between off and flashing, press PUSH and ON/OFF PROGRAM simultaneously. + 8
Inhaltszusammenfassung zur Seite Nr. 9
Locking Settings Press ON/OFF PROGRAM and SELECT simultaneously to lock or unlock transmitter settings. When locked, the current settings cannot be manually changed. Note: Locking the transmitter settings does not disable IR frequency synchronization or the High Pass/Low Cut filter. LOGIC MODE To use with a logic enabled receiver, you must perform an automatic sync. The LCD flashes “log” during sync. Once in logic mode, the LCD flashes “log” when powered up. 9
Inhaltszusammenfassung zur Seite Nr. 10
Automatic Frequency Synchronization 1. Power off all transmitters. 2. Power on all receivers. 3. Begin with the first transmitter. Open the battery cover and power it on. 4. Aim the IR sensor at the first receiver IR port. The transmitter should be no more than 15 cm (6 in.) from the receiver. Press and hold the receiver SYNC button to send group and channel data to the transmitter. The red LED on the transmitter will stop flashing when programming is complete. 5. Power off the first transm
Inhaltszusammenfassung zur Seite Nr. 11
Tips for Optimum Performance • Maintain a direct line of sight between the transmitter and receiver antennas. • Avoid placing the transmitter on metal surfaces. • Avoid placing laptop computers or other obstructions in front of the microphone during use. • Only use with a Shure SLX4 wireless receiver. Troubleshooting If you encounter difficulty with the SLX Wireless System: • Make sure both the transmitter and the receiver are turned on. • Replace the battery if the battery LED is red. • Make
Inhaltszusammenfassung zur Seite Nr. 12
Frequency Selection Shure offers wireless systems in a selection of bands that conform to the different government regulations of specific nations or geographic regions. These regulations help limit radio frequency (RF) interference among different wireless devices and prevent interference with local public communications channels, such as television and emergency broadcasts. The system’s band and frequency range are identified on the receiver and transmitter. For example, “H4 518-578 MHz.
Inhaltszusammenfassung zur Seite Nr. 13
Frequency Bands Band Range Output H5 518–542 MHz 10 mW J3 572–596 MHz 28 mW L4 638–662 MHz 10 mW P4 702–726 MHz 10 mW R13 794–806 MHz 10 mW R5 800–820 MHz 10 mW S6 838–865 MHz 10 mW JB 806–810 MHz 10 mW Q4 740–752 MHz 10 mW G4 470–494 MHz 10 mW G5 494–518 MHz 10 mW Note: This radio apparatus may be capable of operating on some frequencies not authorized in your region. Please contact your national authority to obtain information on authorized frequencies for wireless microphone products in y
Inhaltszusammenfassung zur Seite Nr. 14
Master List Frequencies The Master List is an index of all frequencies in a band, including those not assigned to a Group or Channel. The Master List can only be accessed through the receiver, so the transmitter must be synchronized via the IR port. When a Master List frequency is in use, “MASTER LIST” appears on the display. Refer to the SLX Wireless System User Guide for more information. Note: Wireless devices such as cellular phones and two-way radios may interfere with wireless microp
Inhaltszusammenfassung zur Seite Nr. 15
Transmitter Specifications Operating Range 30 m (100 ft.) Note: Actual range depends on RF signal absorption, reflection, and interference Frequency Stability ±10 ppm Maximum Frequency Deviation 45 kHz Oscillator Type Phase-locked loop (PLL) controlled synthesizer Power Requirements 3V (2 AA alkaline or rechargeable batteries) Battery Life ≥8 hours (alkaline) Power Consumption 130 mA, ±15 mA Operating Temperature Range -18–57 °C (0–135 °F) Note: Battery may limit this range Dimensions 43 mmH x
Inhaltszusammenfassung zur Seite Nr. 16
Microphone Specifications Type Condenser (electret bias) Frequency Response 50–17000 Hz Polar Pattern (at 1 kHz) Cardioid Sensitivity (at 1 kHz , open circuit voltage) –33 dBV/Pa (22 mV) 1 Pascal=94 dB SPL Dynamic Range (1 kΩ load at 1 kHz) 96 dB Common Mode Rejection (10 Hz to 100 kHz) 45 dB minimum Preamplifier Output Clipping Level (1% THD) –6 dBV (0.5 V) Polarity Positive sound pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector or tip of 1/4”
Inhaltszusammenfassung zur Seite Nr. 17
17
Inhaltszusammenfassung zur Seite Nr. 18
Certification Certified to FCC Part 74 (FCC ID: DD4MX690). Certified by IC in Canada under RSS-123 and RSS-102 (IC: 616A-MX690). Meets essential requirements of the European R&TTE Directive 99/5/EC (ETSI EN 300-422 Parts 1 & 2, EN 301 489 Parts 1 & 9) and eligible to carry the CE marking. Changes or modifications not expressly approved by Shure Incorporated could void your authority to operate this equipment. 18
Inhaltszusammenfassung zur Seite Nr. 19
EU Declaration of Conformity EU DECLARATION OF CONFORMITY We, Shure Incorporated of 5800 Touhy Avenue Niles, Illinois, 60714-4608 U.S.A. Phone: (847) 600-2000 Web: www.Shure.com Declare under our sole responsibility that the following product Model: MX690 Description: Wireless Microphone Transmitter conforms to the essential requirements and other relevant previsions of the R&TTE Directive (1999/5/EC). The product complies with the foll
Inhaltszusammenfassung zur Seite Nr. 20
SHURE Incorporated http://www.shure.com United States, Canada, Latin America, Caribbean: 5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A. Phone: 847-600-2000 U.S. Fax: 847-600-1212 Int’l Fax: 847-600-6446 Europe, Middle East, Africa: Shure Europe GmbH, Phone: 49-7131-72140 Fax: 49-7131-721414 Asia, Pacific: Shure Asia Limited, Phone: 852-2893-4290 Fax: 852-2893-4055
