Inhaltszusammenfassung zur Seite Nr. 1
R
Operating Instructions
Commercial Microwave Convection Oven
NE-C1153
MICRO TIME PROGRAM
STAGE
1
2
3
CONV PREHEAT % B B
Microwave Convection
1 6
2 7
3 4 8
4 9
5 0
Preheat
Cooling
Lamp
Stop / Reset Start
Prog Lock Beep
NE C1153
Please read these instructions completely before operating this oven.
Before Calling for Service:
If failure code “F**” appears in the display, unplug oven and wait 1 minute
before reconnecting. If normal operation does not resume,
call the service agent with the inform
Inhaltszusammenfassung zur Seite Nr. 2
Contents PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Installation and Grounding Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4 Caution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inhaltszusammenfassung zur Seite Nr. 3
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY (a) Do not attempt to operate this oven with (c) Do not operate the oven if it is damaged. It is the door open since open-door operation can particularly important that the oven door closes result in harmful exposure to microwave energy. properly and that there is no damage to the : It is important not to defeat or tamper with the (1) door (bent) safety interlocks. Under normal conditions, the (2) hinges and latches (broken or
Inhaltszusammenfassung zur Seite Nr. 4
Installation and GROUNDING INSTRUCTIONS Examine your Oven Unpack oven, retain all packing material, and examine Grounding Instructions the oven for any damage such as dents, broken door This oven must be electrically grounded. In the event of latches or cracks in the door. Notify supplier an electrical short circuit, grounding reduces the risk of immediately if unit is damaged. DO NOT install if unit is electric shock by providing an escape wire for the damaged. electric current. The appliance i
Inhaltszusammenfassung zur Seite Nr. 5
Caution Before Use Storage of Accessories Before using CONVECTION or COMBINATION function When the oven is not being used, do not store any for the first time, operate this oven without food on objects other than oven accessories inside the oven in Convection 500˚F for 20 minutes, removing all case it is accidentally turned on. In case of electronic accessories from the oven.This will cause the oil that is failure, the oven can only be turned off at the wall used for rust protection to be burned
Inhaltszusammenfassung zur Seite Nr. 6
Outline Diagram Door Handle Oven Window External Oven Air Vents (back of oven) Display Window Control Panel Door Safety Lock System Shelf Supports Door Seal Area Air Filter Ceramic Base Shelf Supports Put the shelf supports on left side wall (shelf support marked L) and right side (marked R) as follows. Locate left-hand support marked “L” on left-hand back post. Slide forward to locate front hole over front post and ensure L that it drops into position. Check to see that shelf support is securel
Inhaltszusammenfassung zur Seite Nr. 7
Display Window The cursor will illuminate and flash to indicate the function being set. Always check the cursor position before you press Start Pad. Microwave Power Convection MICRO TIME PROGRAM Time STAGE Preheat 1 Program 2 Microwave Power Level % 3 Cooking Stage Indicator PREHEAT CONV % Control Panel Microwave Pad Convection Pad Microwave Convection Number Pads 1 6 Preheat Pad Cooling Pad 2 7 Lamp Pad Timer Dial 3 8 Stop/Reset Pad Start Pad 4 9 Program Key Program Lock Key 5 0 Beep Key Prehea
Inhaltszusammenfassung zur Seite Nr. 8
Operating Oven in Microwave mode Example: To cook food at 60 % power for 4 min 30 sec CONTROLS TO USE ACTION INFORMATION DISPLAY MICRO TIME PROGRAM 1 Open Door. The oven lamp will come on. STAGE 1 Put in Food. 2 3 Close Door. Oven lamp turns off. PREHEAT % CONV Microwave Convection MICRO TIME PROGRAM STAGE 2 Press. Press Microwave Pad. 1 1 6 2 3 When heating at 100 % Microwave power, skip step 3. CONV PREHEAT % 2 7 MICRO TIME PROGRAM Press Number Pad. 3 Select STAGE 1 Power. 3 8 2 3 6 CONV PREH
Inhaltszusammenfassung zur Seite Nr. 9
Operating Oven in Microwave mode Multi-Stage (Sequential) Heating The oven can be programmed with up to 3 different 2 stage programming functions to operate in sequence. These can be MICRO TIME PROGRAM MICROWAVE, CONVECTION or COMBINATION STAGE 1 programs. If a required heating time is greater than 15 2 minutes on 100-60 % power, use 2 stage 3 programming. CONV PREHEAT % For 2 stage programming: 3 stage programming Repeat steps 1-4 on page 8 before then enter the next MICRO TIME PROGRAM heating
Inhaltszusammenfassung zur Seite Nr. 10
Operating Oven in Convection mode Example: To cook food at 375˚F for 18 minutes CONTROLS TO USE ACTION INFORMATION DISPLAY If required, preheat oven to desired temperature. (See page 18.) MICRO TIME PROGRAM 1 Open Door. STAGE The oven lamp will come on. 1 Put in Food. 2 Microwave Convection 3 Close Door. Oven lamp turns off. CONV PREHEAT % 1 6 MICRO TIME PROGRAM Select required oven STAGE 2 Press temperature. 1 2 Convection 7 2 Continue to press Pad. 3 Convection Pad until PREHEAT % CONV temp
Inhaltszusammenfassung zur Seite Nr. 11
Operating Oven in Convection mode Hot Surfaces Exterior oven surface and the oven door is very hot after heating. Take great care when removing hot food. Use oven gloves. Multi-Stage (Sequential) Heating 2 stage programming The oven can be programmed with up to 3 different MICRO TIME PROGRAM functions to operate in sequence. These can be STAGE 1 MICROWAVE, CONVECTION or COMBINATION 2 programs. 3 For 2 stage programming: PREHEAT CONV % Repeat steps 1-3 on page 10, enter the next heating 3 stage p
Inhaltszusammenfassung zur Seite Nr. 12
Operating Oven in Combination mode Example: To cook food at 375˚F and 30 % power for 12 minutes CONTROLS TO USE ACTION INFORMATION DISPLAY If required, preheat oven to desired temperature. (See page 18.) MICRO TIME PROGRAM 1 Open Door. The oven lamp will come on. STAGE 1 Put in Food. 2 Microwave Convection 3 Close Door. Oven lamp turns off. PREHEAT % CONV 1 6 MICRO TIME PROGRAM 2 Press Press Convection Pad until STAGE 2 7 Convection required temperature appears 1 2 Pad. in display window. 3 3 CO
Inhaltszusammenfassung zur Seite Nr. 13
Operating Oven in Combination mode Multi-Stage (Sequential) Heating The oven can be programmed with up to 3 different 2 stage programming MICRO TIME PROGRAM functions to operate in sequence. These can be STAGE 1 MICROWAVE, CONVECTION or COMBINATION 2 programs. 3 For 2 stage programming: PREHEAT CONV % Repeat steps 1-3 on page 12, enter the next heating 3 stage programming program, then press Start Pad. MICRO TIME PROGRAM For 3 stage programming: STAGE 1 Follow 2 stage programming and enter a 3rd
Inhaltszusammenfassung zur Seite Nr. 14
Setting the Memory Programs The oven has 100 blank program capacity to meet your heating requirements. Example: To program cooking food at 60 % power for 12 minutes into program 08 CONTROLS TO USE ACTION INFORMATION DISPLAY MICRO TIME PROGRAM STAGE 1 Open Door. The oven lamp will come on. 1 2 3 CONV PREHEAT % Microwave Convection MICRO TIME PROGRAM 2 Press Keep key pressed for 2 STAGE 1 6 1 Program Key. seconds until “P” is displayed. 2 3 Prog 2 KEEP DOOR OPEN 7 CONV PREHEAT % 3 Press Press Numb
Inhaltszusammenfassung zur Seite Nr. 15
Setting the Memory Programs Multi-Stage (Sequential) Cooking It is possible to program into the memory 2 or 3 stage program using MICROWAVE, CONVECTION, or COMBINATION. Changing a Memory Program To change a program simply follow steps 1-6 as before, entering your new program. Using the Memory Programs Example: To select program “08” in which your desired heating program (at 60 % power for 12 minutes) is set ACTION INFORMATION DISPLAY 1 Open Door. The oven lamp will come on. MICRO TIME PROGRAM ST
Inhaltszusammenfassung zur Seite Nr. 16
How to activate the Program Lock CONTROLS TO USE ACTION INFORMATION DISPLAY 1 Open Door. The oven lamp will come on. MICRO TIME PROGRAM STAGE 1 2 3 Microwave Convection CONV PREHEAT % 1 6 2 Press Keep key pressed for MICRO TIME PROGRAM Program 2 seconds until “P” is STAGE 1 Lock Key displayed. 2 7 2 3 LOCK Lock CONV PREHEAT % KEEP DOOR OPEN. 3 8 After 2 seconds, “P L” MICRO TIME PROGRAM STAGE appears in display window. 4 1 9 2 3 CONV PREHEAT % 5 0 MICRO TIME PROGRAM STAGE After 3 seconds, displ
Inhaltszusammenfassung zur Seite Nr. 17
How to release the Program Lock ACTION INFORMATION DISPLAY 1 Open Door. The oven lamp will come on. MICRO TIME PROGRAM STAGE 1 2 3 CONV PREHEAT % MICRO TIME PROGRAM 2 Press Keep key pressed for 2 seconds until “P L” is STAGE Program Lock Key. displayed. 1 2 3 KEEP DOOR OPEN. PREHEAT % CONV LOCK Lock After 2 seconds, “P” appears in display window. MICRO TIME PROGRAM STAGE 1 2 3 PREHEAT CONV % After 3 seconds, display reverts to “o”. MICRO TIME PROGRAM STAGE 1 2 3 CONV PREHEAT % Two Touch Operatin
Inhaltszusammenfassung zur Seite Nr. 18
Keeping the Oven Hot To assist in faster heating and browning results, the PREHEAT feature is designed to keep your oven at 425˚F, 400˚F or 350˚F for a hot start before using CONVECTION or COMBINATION function. CONTROLS TO USE ACTION INFORMATION DISPLAY 1 Press Select the required Preheat MICRO TIME PROGRAM STAGE Preheat Pad. Temperature when display is 1 blank or “0”. 2 3 eg. 350˚F Microwave Convection Preheat CONV PREHEAT % 1 press 425˚F 1 6 2 presses 400˚F 3 presses 350˚F 2 MICRO TIME PROGRA
Inhaltszusammenfassung zur Seite Nr. 19
Keeping the Oven Hot Limit Time for Preheat Function PREHEAT function is preset to limit to 60 minutes, at the factory. You can change the program to keep oven hot endlessly, by using the following instructions. ACTION INFORMATION DISPLAY MICRO TIME PROGRAM 1 Open Door. The oven lamp will come on. STAGE 1 2 3 CONV PREHEAT % MICRO TIME PROGRAM 2 While pressing Start Pad, “H L” appears. STAGE 1 press and hold Cooling Pad. KEEP DOOR OPEN. 2 3 + CONV PREHEAT % Start Cooling MICRO TIME PROGRAM 3 Keep
Inhaltszusammenfassung zur Seite Nr. 20
How to change the Beep Tone When Program Lock is activated, you can not change the Beep Tone. Please release the Program Lock. (See page 17.) ACTION INFORMATION DISPLAY 1 Open Door. The oven lamp will come on. MICRO TIME PROGRAM STAGE 1 2 3 CONV PREHEAT % 2 Press Keep key pressed for 2 seconds until “P” is MICRO TIME PROGRAM STAGE Program Key. displayed. 1 2 3 KEEP DOOR OPEN. Prog CONV PREHEAT % 3 Press Press Beep Key to choose loudness and duration MICRO TIME PROGRAM Beep Key. required. (See be
