Inhaltszusammenfassung zur Seite Nr. 1
EPSON Stylus Photo 750
Media
paper support
edge
Part
guides
printer cover Paper name Size number
EPSON 360 dpi Ink Jet Paper Letter S041060
A4 S041059
EPSON Iron-On Cool Peel Transfer Letter S041153/
output tray
Paper S041155
EPSON High Quality Ink Jet Paper Letter S041111
A4 S041117
EPSON Photo Quality Ink Jet Letter S041062
Paper A4 S041061
output tray extensions
Legal S041067
EPSON Photo Quality Ink Jet A6 S041054
Cards 8 × 10 inches S041122
paper thickness lever
EPSON Photo Quality Self A4
Inhaltszusammenfassung zur Seite Nr. 2
EPSON Stylus Photo 750 Paper Paper Size Types Thickness Weight Single sheets Letter (8.5 × 11 inches) Plain paper and 0.003 to 0.004 inch (0.08 to 0.11 17 to 24 lb 2 A4 (210 × 297 mm) special ink jet papers mm) (64 to 90 g/m ) A5 (148 × 210 mm) distributed by B5 (182 × 257 mm) EPSON Legal (8.5 × 14 inches) Half letter (5.5 × 8.5 inches) Executive (7.5 × 10 inches) Transparencies and Letter (8.5 × 11 inches) Transparencies and —— glossy film A4 (210 × 297 mm) glossy film A6 (105 × 148 mm, gl
Inhaltszusammenfassung zur Seite Nr. 3
EPSON Stylus Photo 750 Printable area Ink Cartridges A Black ink cartridge Color ink cartridge Specification (S020187) (S020193) Color(s) Black Cyan, magenta, B-R B-L yellow, light cyan, light magenta Print capacity* 540 pages (ISO/IEC letter 220 pages (15% pattern at 360 dpi) coverage at 360 dpi) C C Cartridge life 2 years from production date and within 6 months of opening package at 77 °C (25 °F) Single sheets and cards Storage –4 to 104 °F (–20 to 40 °C) temperature 1 month at 104 °F (4
Inhaltszusammenfassung zur Seite Nr. 4
EPSON Stylus Photo 750 Environmental Reverse channel Temperature Specification Description Transmission mode IEEE-1284 Nibble mode Operation 50 to 95 °F (10 to 35 °C) Storage* –4 to 104 °F (–20 to 40 °C) Adaptable connector 57-30360 Amphenol connector or equivalent 1 month at 104 °F (40 °C) Transit* –4 to 140 °F (–20 to 60 °C) Synchronization Refer to the IEEE-1284 specification 120 hours at 140 °F (60 °C) Handshaking Refer to the IEEE-1284 specification Humidity Signal level IEEE-1284 Level 1
Inhaltszusammenfassung zur Seite Nr. 5
EPSON Stylus Photo 750 Control Panel Installing Ink Cartridges for the First Time power power button light 1. Make sure the printer is turned off (the Ppower button level is raised above the control panel level). Then plug the printer’s power cord into a grounded outlet. paper out light Don’t use an outlet that can be turned off by a wall switch or timer, or one on the same circuit as a large black ink appliance to avoid damaging the printer’s power out ligh
Inhaltszusammenfassung zur Seite Nr. 6
EPSON Stylus Photo 750 5. Remove the ink cartridges from their packages. Then Loading Paper remove only the yellow part of the tape seal on top. Don’t pull off the blue portion or remove the clear seal on the 1. Open the output tray extensions. Slide the left edge guide bottom of the cartridge. right until it is a little wider than your paper. Remove the yellow tape Left edge guide black cartridge color cartridge You must remove the yellow tape seal from the 2. Load a stack of
Inhaltszusammenfassung zur Seite Nr. 7
EPSON Stylus Photo 750 ❏ If your media has a cut corner, position it in the upper right Printing on Special Media corner in the sheet feeder. When you print on special paper, you need to choose the Cut corner correct Media Type and Paper Size settings in your printer software. The table below lists the available EPSON papers and the corresponding Media Type setting for each one. Paper name Media Type setting EPSON 360 dpi Ink Jet Paper 360 dpi Ink Jet Paper EPSON Iron-On Cool Peel Transfer P
Inhaltszusammenfassung zur Seite Nr. 8
EPSON Stylus Photo 750 6. Remove only the yellow part of the tape seal on top as Replacing an Ink Cartridge shown below. Don’t pull off the blue portion or try to remove the clear seal underneath the cartridge. You can replace a cartridge when the B black or A color ink Remove the yellow tape out light is either flashing or on. (If you perform these steps when both ink out lights are off, the printer cleans the print heads, as described in “Cleaning the Print Head” on page 9.) Use
Inhaltszusammenfassung zur Seite Nr. 9
EPSON Stylus Photo 750 You must remove the yellow tape from the top of the Replacing an Outdated Ink Cartridge cartridge or you will permanently damage it. Do not remove the clear seal from the bottom of the cartridge; ink will leak out If an ink cartridge is more than six months old and your printouts don’t look as good as they used to, you may need to 7. Lower the new ink cartridge into its holder with the label replace it the cartridge. If print quality doesn’t improve after f
Inhaltszusammenfassung zur Seite Nr. 10
EPSON Stylus Photo 750 If you’re printing over a network, open an application and Using the Head Cleaning Utility print a document containing black and color data. Then go Follow these steps to run the Head Cleaning utility: to step 8. 1. Make sure the printer is turned on but not printing, and 4. Start an application, open a document, and access the both the B black and A color ink out lights are off. printer settings dialog box. 2. Start an application and open a document. 5.
Inhaltszusammenfassung zur Seite Nr. 11
EPSON Stylus Photo 750 Aligning the Print Head Transporting the Printer If your printouts contain misaligned vertical lines, you may If you move your printer some distance, you need to prepare it need to align the print head. Your printer must be connected for transportation in its original box. Follow these steps: to a local port, not on a network, to use the Print Head 1. Turn on the printer and wait until the print head locks in Alignment utility. Follow these steps: the far right position
