Inhaltszusammenfassung zur Seite Nr. 1
Gas hob
INSTR INSTRUCTION BOOKLET UCTION BOOKLET
INSTR INSTR INSTRUCTION BOOKLET UCTION BOOKLET UCTION BOOKLET
Please read this instruction booklet before using the appliance
Mod. EHG 6762
35687-8401
GB
Inhaltszusammenfassung zur Seite Nr. 2
Important Safety Information You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 950 950 Installation Perishable food, plastic items and aerosols may be This appliance must be installed and serviced by a affected by heat and should not be stored above or competent person as stated in the Gas Safety ( below the hob unit. Installation and Use) Regulations Current Editions and the IEE Wiring Regulations.
Inhaltszusammenfassung zur Seite Nr. 3
Contents For the Installer For the User Instructions for the Installer 8 Important Safety Information 2 Description of the Hob 3 Important safety requirements 9 Operation 4 Installation 10 Electrical connections 12 Maintenance and Cleaning 5 Wiring Diagram 13 Something Not Working? 6 Fault Finding 13 Service and Spare Parts 6 Commissioning 15 Customer Care 7 Conversion from Natural Gas to LPG 15 Guarantee Conditions 7 Description of the Hob 3 2 3 1 4 5 1. Hob Top 2. Auxiliary Burner 3. Semi-rapi
Inhaltszusammenfassung zur Seite Nr. 4
Operation Hob burners To light a burner: turn the relevant control knob anticlockwise to the maximum position, then push it down to ignite the burner; upon ignition, keep the knob pushed down about 5 seconds. This will allow the "thermocouple" (Fig. 1, lett. D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted. then, check the flame is regular and adjust it as required. If you cannot light the flame even after several attempts, check t
Inhaltszusammenfassung zur Seite Nr. 5
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The Hob Top Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. Avoid the use of the following: - household detergent and bleaches; - impregnated pads unsuitable for n
Inhaltszusammenfassung zur Seite Nr. 6
Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Electrolux Service Force Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM SOLUTION There is no spark when lighting the gas Check that the unit is plugged in and the electrical supply is switched on Check that
Inhaltszusammenfassung zur Seite Nr. 7
Customer Care Department For general enquiries concerning your Electrolux appli- For Customer Service in the Republic of Ireland please ance or for further information on Electrolux products, contact us at the address below: please contact our Customer Care Department by letter Electrolux or telephone at the address below or visit our website at Electrolux Group (Ire) Ltd. www.electrolux.co.uk Long Mile Road Customer Care Department Dublin 12 Republic of Ireland Electrolux Tel: + 353 (0) 1 40907
Inhaltszusammenfassung zur Seite Nr. 8
Instructions for the Installer Ignition HT Spark Engineers technical data Spark Generator Ispra Control's BF 50046-06 Overall dimensions 230-240V 0.6 VA T 120 Spark Gap Fixed Width: 580 mm Depth: 510 mm Rear Left Burner (semi rapid) Cut out dimensions Heat Input 2.0 kW (6824 BTU/HR) Width: 560 mm Depth: 480 mm Front Left Burner (auxiliary) Heat Input 1.0 kW (3412 BTU/HR) Supply connections Rear Right Burner (semi rapid) Gas: Heat Input 2.0 kW (6824 BTU/HR) RC 1/2 inch (1/2 inch male) Rear rig
Inhaltszusammenfassung zur Seite Nr. 9
50 mm 100 mm 50 mm 100 mm 50 mm 50 mm 600 mm Important safety requirements This hob must be installed in accordance with the Gas Location Safety (Installation and Use) Regulations (Current Edition) The hob may be located in a kitchen, a kitchen/diner or and the IEE Wiring Regulations (Current Edition). bed sitting room, but not in a bathroom, shower room or For appliances installed in the Republic of Ireland please garage. refer to NSAI- Domestic Gas Installation I.S. 813 Current Before making t
Inhaltszusammenfassung zur Seite Nr. 10
Installation IMPORTANT: This hob must be installed by a competent person to the relevant Gas Standards. Please, ensure that, once the hob is installed, it is easily accessible for the engineer in the event of a breakdown. WHEN THE HOB IS FIRST INSTALLED Once the hob has been installed, it is important to remove any protective materials, which were put on in the factory. Any gas installation must be carried out by a competent person. The manufacturer will not accept liability, should the above i
Inhaltszusammenfassung zur Seite Nr. 11
Building In Building over a cupboard or drawer If the hob is to be installed above a cupboard or drawer it It is also recommended to carry out the electrical will be necessary to fit a heat resistant board below the connection to the hob as shown in diagrams 1 and 2. base of the hob on the underside of the work surface. 1 2 3
FO 2564 FO 0763 FO 2044 Dimensions are given in mm. Building over a kitchen unit with door Proper arrangements must be t
Inhaltszusammenfassung zur Seite Nr. 12
Electrical connections Any electrical work required to install this hob Permanent Connection should be carried out by a qualified electrician or In the case of a permanent connection, it is necessary competent person, in accordance with the current that you install a double pole switch between the hob regulations. and the electricity supply (mains), with a minimum gap of 3 mm. between the switch contacts and of a type THIS HOB MUST BE EARTHED. suitable for the required load in compliance with th
Inhaltszusammenfassung zur Seite Nr. 13
Wiring Diagram N 1. TAPS IGNITOR SWITCHES 2. IGNITOR UNIT 220 1 240 2 3 0 4 2 1 L Fault Finding Preliminary Electrical Systems Check SOCKET PLUG (with cover removed) (face view) Earth Wire ( ) Green/Yellow ( ) E Brown Blue START Neutral Wire Isolate appliance Blue and carry out: A: Earth Continuity N L check. Blue Green Brown Yellow Carry out: Electricity supply NO YES Carry out: D: Resistance to should now be C: Polarity check. Earth check. satisfactory. A. EARTH CONTINUITY CHECK - Applianc
Inhaltszusammenfassung zur Seite Nr. 14
Ignition System / Gas Ignition YES Check gas supply at Ignitor does not spark burner NO Check plug top fuse and Light burner manually replace if necessary Check by pass Check polarity and simmer earth continuity of supply point Check position of the Check earth continuity electrode of appliance Check continuity from the tip Check fitting of burners Check continuity from 'N' on the of each electrode to the mains connector block and "O" on terminals 1 to 4 on the ignitor the ignitor unit unit Chec
Inhaltszusammenfassung zur Seite Nr. 15
Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - Turn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extinguished follow the procedure below. Procedure: - Re-ignite the burner and set to MIN. - Remove the control knob and use a thin bladed screwdriver to turn the ad
Inhaltszusammenfassung zur Seite Nr. 16
CUSTOMER CARE Electrolux 55-77 High Street Slough Berkshire, SL1 1DZ Tel: 08705 950950 © Electrolux plc 2003 The Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in more than 150 count
