Bedienungsanleitung AudioSource 10" In-Wall Subwoofer

Inhaltszusammenfassung zur Seite Nr. 1

AS10SW
10” In-Wall Subwoofer
wall surface to allow room for the “Easy-In” bracket that
retains the frame to the wall surface.
Congratulations on your purchase of the Audio-
Use a stud fi nder to locate the vertical studs behind the
Source AS10SW In-Wall Subwoofer. This product
wall surface. You should now check for obstructions like
is designed to reproduce the Low Frequency audio
cross bracing above and below the desired speaker
portion of your home entertainment system with ac-
location.

Inhaltszusammenfassung zur Seite Nr. 2

Next, run your speaker wire to your speaker locations. out, the top of the “Easy-In” bracket should just clear A UL rated CL3 speaker wire is recommended when the top of the drywall cut-out. Next gently lift and center running wire inside your walls (such as Phoenix Gold the AS10SW into the cutout, and begin to tighten the 4 Innovative Home SS162W*). In many areas it may be “Easy-In” bracket screws. (Fig. 5) required by code. When running your speaker wire you should avoid having the speaker

Inhaltszusammenfassung zur Seite Nr. 3

The AS10SW is designed to be used with the sub output Removing the AS10SW Subwoofer of any 5.1 or 7.1 surround receiver/amplifi er. If not using a sub output with active low pass crossover, we recom- Should it ever become necessary to remove the AS10SW mend using an external active crossover or a passive speaker from the wall, simply remove the grill and turn crossover with a minimum crossover slope of 12db per the four mounting screws counter-clockwise. Gently pull octave @ 100 Hz. the AS

Inhaltszusammenfassung zur Seite Nr. 4

AS10SW Specifi cations Woofer 10” Carbon Poly Cone with Butyl Surround Frequency Response 40 Hz to 200 Hz Impedance 8 Ohm Sensitivity 86dB@2.83V Recommended Amp Power 25 to 150 Watts Continuous Cut Out Dimension 10 11/16” x 10 11/16” (27.2cm x 27.2cm) Two Year Limited Warranty AudioSource, a division of Rodin, warrants this product against defects in materials and workmanship for a limited period of time. For a period of two (2) years from date of original purchase, we will repa