Bedienungsanleitung Chamberlain PIR2300R

Inhaltszusammenfassung zur Seite Nr. 1

®
Model PIR2300R
Wireless Pedestrian & Vehicle Sensor
Overview
Step 2
The Wireless Pedestrian & Vehicle Sensor is a
Passive Infra-Red sensor that detects movement of
people and vehicles, while allowing small animals to
pass through undetected. Each PIR Motion Sensor
has its own unique ID, for a secure radio link.
Base Station (not provided) can learn the signals of
up to four PIR Motion Sensors. The Base Station will
give a single beep for the first Sensor that it learns, a
double beep for the s

Inhaltszusammenfassung zur Seite Nr. 2

Programming PIR Motion Step 3 Sensor to Base Station Step 5 A Ensure Base A Station and PIR Motion Sensor are in close proximity to each other. Press and release learn button on Base Station. Buzzer will sound. B Insert battery pack facing away from circuit board and B Within 5 seconds, wave hand in front of PIR Motion attach cover. Sensor. Test light will illuminate and Base Station NOTE: Ensure the batteries do not touch the circuit will buzz. board and the antenna and battery wires are not p

Inhaltszusammenfassung zur Seite Nr. 3

Vehicle Alert Installation: For cars, the best mounting position is about 4' high, between 10-20' back, and angled to see the back of car after passing the sensor. 10' - 20' 3' - 5' Troubleshooting The PIR Motion Sensor lights up, but the Base Base Station beeps every ten minutes. Station does not respond. The battery in the Base Station is low. Replace with The PIR Motion Sensor must be programmed to Base 9-Volt battery or operate it using AC Adapter. Station (See Step 5). Ensure Base Station

Inhaltszusammenfassung zur Seite Nr. 4

FOR TECHNICAL SUPPORT DIAL OUR TOLL FREE NUMBER: 1-800-528-9131 www.chamberlain-DIY.com NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference