Inhaltszusammenfassung zur Seite Nr. 1
HDMI Extender SET over Single Fiber
Optic Cable with EMI Shielding
Model #: FO-HDMI-1000M-EMI
© 2010 Avenview Inc. All rights reserved.
The contents of this document are provided in connection with Avenview Inc. (“Avenview”) products. Avenview makes no representations or warranties with
respect to the accuracy or completeness of the contents of this publication and reserves the right to make changes to specifications and product descriptions at
Inhaltszusammenfassung zur Seite Nr. 2
including, but not limited to, the implied warranty of merchantability, fitness for a particular purpose, or infringement of any intellectual property right. Reproduction of this manual, or parts thereof, in any form, without the express written permission of Avenview Inc. is strictly prohibited. Table of Contents Section 1: Gettin
Inhaltszusammenfassung zur Seite Nr. 3
Section 1: Getting Started 1.1 Important Safeguards Please read all of these instructions carefully before you use the device. Save this manual for future reference. What the warranty does not cover Any product, on which the serial number has been defaced, modified or removed. Damage, deterioration or malfunction resulting from: Accident, misuse, neglect, fire, water, lightning, or other acts of nature, unauthorized product modification, or failure to follow instructions suppl
Inhaltszusammenfassung zur Seite Nr. 4
1.3 Regulatory Notices Federal Communications Commission (FCC) This equipment has been tested and found to comply with Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Any changes or modifications made to this equipment may void the user’s authority to operate this equipment. 1.4 Introduction Avenview FO-HDMI-1000M-EMI optical HDMI extension module, is designed to let digital flat panel d
Inhaltszusammenfassung zur Seite Nr. 5
1.7 Installation Avenview FO-HDMI-1000M-EMI is composed of a Transmitter converting the graphic signal of a computer to optical and Optical Fiber propagating the optical signal and Receiver supplying electrical signal to monitor converted from the optical signal to electrical signal. The Transmitter should be connected to computer and the Receiver should be connected to a monitor. Avenview FO-HDMI-1000M-EMI is designed to self-detect the resolution of the monitor and change the reso
Inhaltszusammenfassung zur Seite Nr. 6
Section 2: Specifications Item Description Units FO-HDMI-1000M-EMI (Transmitter) FO-HDMI-1000M-EMI (Receiver Unit Description HDMI Transmitter over Fiber Optic HDMI Receiver over Fiber HDMI Compliance HDMI 1.3a HDCP Compliance HDCP 1.1 Video Bandwidth 2.25 Gbps / Channel WUXGA 1920 x 1200 @ 500 meters ( 1650 feet) Supported Resolution & UXGA 1600 x 1200 @ 700 meters (2300 feet) Distance SXGA 1280 x 1024 @ 1000 meters (3300 feet) 4 Ch 850 nm Transmit OSA 4 Ch 850 nm Transmit OSA Opti
Inhaltszusammenfassung zur Seite Nr. 7
2.2 Absolute Maximum Ratings Parameter Symbol Minimum Maximum Units Power Supply VCC -0.3 5.5 V Operating Temperature VOT 0 50 °C Storage Temperature VST -20 70 °C Relative Humidity HRH 10 80 RH Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operations section for extended periods of time ma
Inhaltszusammenfassung zur Seite Nr. 8
2.4 Optical Fiber Cable The construction of 4 Optical Fibers and 4 Copper wires cable shall be in accordance with Figure and Table below: www.avenview.com 8
Inhaltszusammenfassung zur Seite Nr. 9
Disclaimer While every precaution has been taken in the preparation of this document, Avenview Inc. assumes no liability with respect to the operation or use of Avenview hardware, software or other products and documentation described herein, for any act or omission of Avenview concerning such products or this documentation, for any interruption of service, loss or interruption of business, loss of anticipatory profits, or for punitive, incidental or consequential damages
