Inhaltszusammenfassung zur Seite Nr. 1
PCM2000
Configuration Guide
50 Spring Street, Ramsey, NJ 07446 U.S.A.
Tel. 201-934-8500 / Fax 201-934-9832/ www.bogen.com
Downloaded from: http://www.guardianalarms.net
Inhaltszusammenfassung zur Seite Nr. 2
.................... .................... ...................... ....................... .................. ...................... MADE IN KOREA S/N SYS-ID SWITCH SETTINGS CHART FOR ADDITIONAL SATELLITE SYSTEMS Contents Zone #’s S1 S2 S3 S4 SECTION I - APPLICATON CONFIGURATIONS....................................................................................................................................................4-33 Master 1-9 0000 Configuration 1. Page Port Contact Closure - 3-Zone -
Inhaltszusammenfassung zur Seite Nr. 3
Time Trigger 6 SECTION I: APPLICATION CONFIGURATIONS Zone Group *86 Zone Numbers No Zones SETUP FOR CONFIGURATION 1: PAGE PORT CONTACT CLOSURE - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS Inhibit 160 Inhibit Enable 161 HHMM (See Note 3 - below) 2-Second Tone 162 3-Second Tone 163 3-Second Tone 4-Second Tone 164 5-Second Tone 165 6-Second Tone 166 7-Second Tone 167 8-Second Tone 168 Chime 169 Time Trigger 7 Zone Group *87 Zone Numbers No Zones Inhibit 170 Inhibit Enable 171 H
Inhaltszusammenfassung zur Seite Nr. 4
Clock Set 060 HHMM 00:00 CONFIGURATION 1: Clock Sync. 067 HHMM (See Note 3 - p. 37) PAGE PORT CONTACT CLOSURE - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS Inhibit 068 Inhibit In this configuration, the PCM unit responds to a contact closure on pins 2 & 5 of the TEL LINE jack on the PCMTIM module shorting the Enable 069 +5V source to its ground.When the closure is removed, the page ends.Audio is provided to the system through a separate pair of leads on Time Trigger 1 pins 3
Inhaltszusammenfassung zur Seite Nr. 5
SETUP FOR CONFIGURATION 2: PAGE PORT VOX CIRCUIT - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS FEATURE CODES AND DEFAULTS Feature Feature Code Additional Data Default Privacy Beep Inhibit 006 Enable 007 Enable Pre-announce T one Inhibit 003 Beep 004 Chime 005 Chime Confirmation T one Inhibit 001 Inhibit Enable 002 Emergency O/R Tone Inhibit 008 Inhibit Enable 009 All-Call Inhibit 010 Enable 011 Enable Dialing Time-out Inhibit 012 Enable 013 Enable Trunk Disconnect Inhibit 014
Inhaltszusammenfassung zur Seite Nr. 6
CONFIGURATION 2: SECTION II - PROGRAMMING PAGE PORT VOX CIRCUIT - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS SYSTEM PROGRAMMING This configuration is for Page Ports without Contact Closures.A dry audio pair connected to pins 3 & 4 of the TEL LINE jack on the System programming lets you set certain PCM options and tone features using the DTMF keys of a telephone. It also lets you program pag- PCMTIM module is used to detect audio and activate the system. Paging ends when the
Inhaltszusammenfassung zur Seite Nr. 7
SETUP FOR CONFIGURATION 3: LOOP START TRUNK - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS CONFIGURATION 16: RELAY DRIVER OUTPUT PCM ZPM ZONE A ZONE B ZONE C OFF ON TALKBACK SUPRESSION DIODES POWER LPBGM VOLUME BGM OUT IN RELAY ZONE A ZONE B ZONE C GLOBL BGM RELAY LO PWR OUTPUT HI PWR RELAY IN LOCAL BGM RT + ZONE A - + ZONE B - + ZONE C - RD A RD B RD C POWER RD COM SUPPLY 12VDC - + Each PCMZPM module has three relay driver outputs - RD A, RD B, and RD C - one for e
Inhaltszusammenfassung zur Seite Nr. 8
CONFIGURATION 15: CONFIGURATION 3: SINGLE AMPLIFIER BACKGROUND MUSIC LINE-LEVEL SIGNAL LOOP START TRUNK - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS Single amplifier BGM operation is a programmable feature that lets the PCM2000 use the paging amplifier to provide high-power BGM to the In this configuration, the PCM unit supplies a 48V talk battery and loop current detection from pins 3 & 4 of the TEL LINE jack on the 25/70V AC speakers when the paging system is idle. PCMTIM
Inhaltszusammenfassung zur Seite Nr. 9
SETUP FOR CONFIGURATION 4: GROUND START TRUNK - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS CONFIGURATION 14: DTMF MICROPHONE ZONE PAGING This section will describe the configuration for the use of a Shure microphone Model 885TT with DTMF dialing capabilities and the MODULINK five- conductor coil-cord model ALM-1. In addition to the PCM2000 system and associated amplifiers, the model numbers and components required for this configuration are: 1- Shure Microphone model 885TT 1
Inhaltszusammenfassung zur Seite Nr. 10
SETUP FOR CONFIGURATION 14: DTMF MICROPHONE ZONE PAGING CONFIGURATION 4: GROUND START TRUNK - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS In this configuration, the PCM unit supplies a 48V talk battery and loop current detection from pins 3 & 4 of the TEL LINE jack on the PCMTIM module to the ground start trunk in the telephone system.There are two modes of operation for ground start trunk. (1) When the ground start trunk grounds Ring, the unit responds by closing the connec
Inhaltszusammenfassung zur Seite Nr. 11
SETUP FOR CONFIGURATION 5: STATION LEVEL/CENTREX - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS CONFIGURATION 13: EMERGENCY VOICE ANNOUNCEMENT OVERRIDE Voice Announcement Override is a non-programmable feature that lets the caller take priority over all paging functions and make a system- wide emergency voice announcement page to all speakers. In addition to the PCM modules, this option requires a ProHold (digital announc- er) and a normally open momentary switch supplied by t
Inhaltszusammenfassung zur Seite Nr. 12
SETUP FOR CONFIGURATION 13: EMERGENCY VOICE ANNOUNCEMENT OVERRIDE CONFIGURATION 5: STATION LEVEL/CENTREX - 3-ZONE - ONE-WAY PAGING - SINGLE AMPLIFIER - 25/70V AC SPEAKERS In this configuration, the PCM unit responds to a 90V AC 20Hz ringing signal in pins 3 & 4 of the TEL LINE jack on the PCMTIM module and answers after the first full ring.As soon as it answers, the default timer is started.The default timer determines the maximum length of any page.When a paging zone is selected, the VOX timer
Inhaltszusammenfassung zur Seite Nr. 13
SETUP FOR CONFIGURATION 6: EXTENDED PAGING SYSTEM CONFIGURATION 12: DFT120 & TAMB WIRING DIAGRAM - LOOP START TRUNK, GROUND START TRUNK, OR STATION LEVEL In this configuration, the telephone output is connected to the Bogen Telephone Access Module model TAMB; the TAMB module is connected to the Bogen Digital Feedback Terminator model DFT120; and the DFT120 is connected to the PCM2000 system. The TAMB module is acti- vated by the telephone system and, at the same time, the DFT120 is activated by
Inhaltszusammenfassung zur Seite Nr. 14
SETUP FOR CONFIGURATION 12: DFT120 & TAMB WIRING DIAGRAM - LOOP START TRUNK, GROUND START TRUNK OR STATION LEVEL CONFIGURATION 6: EXTENDED PAGING SYSTEM This illustration shows the wiring between a master assembly and a satellite assembly in a PCM system with a satellite assembly for one-way paging. As described previously, the required setup for one-way basic configuration includes: PCMTIM, PCMCPU, PCMZPM, and the power supply PCMPS2. For PCM systems with satellites (more than 9 zones), the num
Inhaltszusammenfassung zur Seite Nr. 15
SETUP FOR CONFIGURATION 7:TWO-WAY TALK BACK PAGING SYSTEM CONFIGURATION 11: MICROPHONE OVERRIDE Microphone Override is a feature that lets the system designer take priority over all paging functions and make a system-wide page to all speakers. In addition to the PCM modules, setup requires a Bogen VAR1 (voice-activated relay), PRS40C (12V DC power supply) and an MBS1000 or DDU250 (desktop microphone). The Override feature includes a quad beep pre-announce tone which can be enabled or inhibited.
Inhaltszusammenfassung zur Seite Nr. 16
SETUP FOR CONFIGURATION 11: MICROPHONE OVERRIDE CONFIGURATION 7: TWO-WAY TALK BACK PAGING SYSTEM This configuration is essentially the same as the one-way paging system described previously.The main difference between the one-way con- figuration and this configuration is that the centralized high-power amplifier is connected to the PCMTBM module instead of the PCMCPU module.The required setup includes: PCMTIM - PCMCPU - PCMTBM - PCMZPM - PCMPS2. Modules must be assembled, from left to right, in
Inhaltszusammenfassung zur Seite Nr. 17
SETUP FOR CONFIGURATION 8:TWO-WAY TALK BACK EXTENDED PAGING SYSTEM CONFIGURATION 10: 6 ZONES - ONE-WAY PAGING - MIXED HIGH- AND LOW-POWER ZONES - 25/70V AC OR SELF-AMPLIFIED SPEAKERS High- and Low-Power Mixed System is a non-programmable feature that lets the system designer use a dedicated amplifier or self-amplified speaker per zone and at the same time use a centralized amplifier for zones requiring less than 250 watts of power*.The PCMZPM module to be used as a low-power module must have all
Inhaltszusammenfassung zur Seite Nr. 18
SETUP FOR CONFIGURATION 10: 6 ZONES - ONE-WAY PAGING - MIXED HIGH- AND LOW-POWER ZONES - CONFIGURATION 8: 25/70V AC OR SELF-AMPLIFIED SPEAKERS TWO-WAY TALK BACK EXTENDED PAGING SYSTEM This configuration is essentially the same as the two-way paging system described previously on page 17.The main difference is the addition of a satellite assembly. The required setup includes: PCMTIM - 2 PCMCPU - PCMTBM - 4 PCMZPM - 2 PCMPS2 Note: Talk Back is only available in High-Power Zones with 25/70V AC spea
Inhaltszusammenfassung zur Seite Nr. 19
SETUP FOR CONFIGURATION 9: 3-ZONE - ONE-WAY PAGING - LOW-POWER SYSTEM - DEDICATED AMPLIFIERS OR SELF-AMPLIFIED SPEAKERS CONFIGURATION 9: 3-ZONE - ONE-WAY PAGING - LOW-POWER SYSTEM - DEDICATED AMPLIFIERS OR SELF-AMPLIFIED SPEAKERS Low-Power System is a switch-selectable feature that allows the system designer to use dedicated amplifiers or self-amplified speakers on the zone outputs.The PCMZPM module that is to be used as a low-power module will switch only low-level signals to the zone outputs f
Inhaltszusammenfassung zur Seite Nr. 20
SETUP FOR CONFIGURATION 9: 3-ZONE - ONE-WAY PAGING - LOW-POWER SYSTEM - DEDICATED AMPLIFIERS OR SELF-AMPLIFIED SPEAKERS CONFIGURATION 9: 3-ZONE - ONE-WAY PAGING - LOW-POWER SYSTEM - DEDICATED AMPLIFIERS OR SELF-AMPLIFIED SPEAKERS Low-Power System is a switch-selectable feature that allows the system designer to use dedicated amplifiers or self-amplified speakers on the zone outputs.The PCMZPM module that is to be used as a low-power module will switch only low-level signals to the zone outputs f
