Bedienungsanleitung Aiwa CT-X421

Inhaltszusammenfassung zur Seite Nr. 1

OPERATING INSTRUCTIONS
MANUAL DE INSTRUCCIONES
CT-X421 YU
MODE D’EMPLOI
STEREO CAR CASSETTE RECEIVER
RADIO-CASSETTE ESTEREOFONICO PARA AUTOMOVIL
ENGLISH
ESPAÑOL
FRANÇAIS
OWNER’S RECORD
For your convenience, record the model number and
serial number (you will find them on the bottom side of
your set) in the space provided below. Please refer to
them when you contact your AIWA dealer in case of
difficulty.
Model No. CT-X421
Serial No.
8B-KTG-901-11
010105BTM-OX

Inhaltszusammenfassung zur Seite Nr. 2

PRECAUTIONS TABLE OF CONTENTS • Use only in a 12-volt DC negative-ground electrical THEFT PROTECTION .............................................. 2 system. BASIC OPERATION, AUDIO AND CLOCK •Disconnect the vehicle’s negative battery terminal ADJUSTMENT ..................................................... 2 while mounting and connecting the unit. RADIO OPERATION ................................................ 3 • When replacing the fuse, be sure to use one with an TAPE PLAYBACK ...............

Inhaltszusammenfassung zur Seite Nr. 3

ENGLISH THEFT PROTECTION BASIC OPERATION, Take the front panel with you when leaving the car, and AUDIO AND CLOCK keep it in the supplied carrying case. ADJUSTMENT Detaching the front panel Before detaching the front panel, remove the cassette to prevent possible damage to the unit. 1 Press z to remove the cassette. 2 Press and hold PWR/MUTE until the unit turns off. 3 Press %. (Hold the panel with one hand to prevent accidentally dropping it.) 4 Remove the panel. Smart Jog Turning the unit on/o

Inhaltszusammenfassung zur Seite Nr. 4

Adjusting sound Setting the clock You can select the following modes for adjusting sound 1 Press DISP to have the clock displayed. depending on the music you listen to: BASS (low If the clock indication is already displayed, skip this frequencies), TRE (high frequencies), BAL (left/right), step. FAD (front/rear) and H-BASS (high bass) 2 Press and hold DISP until the clock indication flashes in the display. 1 Press SEL repeatedly to select the mode to be 3 Press TUNEi (to set hour) or TUNEk (to s

Inhaltszusammenfassung zur Seite Nr. 5

Monaural mode Presetting stations manually When FM signals become weak, or FM reception (Manual Memory) becomes poor, the unit automatically switches to 1 Press FNC repeatedly to select the desired band Monaural mode to reduce noise. (FM1, FM2, FM3, AM1 or AM2). Local mode 2 Press TUNEi or TUNEk to tune in to a desired Local mode allows you to tune in only to strong stations station (see “Tuning in to a station,” page 3). during Seek Tuning. 3 Press and hold the desired preset station button unt

Inhaltszusammenfassung zur Seite Nr. 6

1 Turn off the unit. TAPE PLAYBACK 2 Press and hold INFO until “PO” flashes in the display. 3 Press SEL. 4 Set the time you wish the unit to turn on. • Press TUNEi and turn the Smart Jog to set the hour. • Press TUNEk and turn the Smart Jog to set the minute. 5 Press SEL. 6 Press FNC to select the band. Playing a tape 7 Press TUNEi, TUNEk or the desired preset station button to select the station. 1 Insert a cassette to start playback. 8 Press SEL. 9 Set the time you wish the unit to turn off f