Inhaltszusammenfassung zur Seite Nr. 1
DlGlTA L 900MHZ
2 LINE CORDLESS PHONE
MODEL VT2900
WEiI
VTECH COMMUNICATIONS LTD.
Distributed in the USA. by VTECH Communications, 8770 SW Nimbus Avenue /
Beaverton, Oregon, 97008
Distributed in Canada by VTECH Electronics Canada Ltd., Suite 200 - 7671 Alderbridge
Way Richmond, B.C. V6X 1Z9.
Copyright 1996 for VTECH COMMUNICATIONS LTD.
ISSUE 0
VTECH COMMUNICATIONS LTD.
Inhaltszusammenfassung zur Seite Nr. 2
INTRODUCTION ................................... 1 Disconnecting ..................................... 17 .................... ........... Parts Check List .. 2 OFF Mode (STANDBY) ...................... 17 REPLACING THE BATTERIES ........... 3 Volume Controls .................................. 17 . Charging the handset batteries ........... 3 Using the Speakerphone .................... 18 Replacing The Handset Batteries ......... 4 To Put A Call On Hold ........................ 18 IMPORT
Inhaltszusammenfassung zur Seite Nr. 3
- - Congratulations! You have purchased alert you when you are "Out of Range" This manual is designed to make you VOLUME n CONTROL KEYS one of the most sophisticated cordless even when you're not using the phone! familiar with the VT2900. We strongly telephones on the market! The VT2900 FLEXIBLE In this way you will not miss an recommend you read the manual ANTENNA has been designed to offer a new incoming call just because you were before using your phone. standard in cordless t
Inhaltszusammenfassung zur Seite Nr. 4
Charging the handset batteries reaches the minimum level needed to CAUTION: operate, the CHARGE indicator will Replacing The Handset Batteries To Reduce the Risk of Fire or Injury to The handset of your VT2900 cordless illuminate steadily and the battery will Persons, Read and Follow the continue to charge up to its full Follow the steps below: telephone is powered by rechargeable Instructions batteries. They charge automatically potential. It is recommended that the 1. Remove the battery
Inhaltszusammenfassung zur Seite Nr. 5
When using your telephone equipment, 7. This product should be operated 12.Unplug this product from the wall 13.Avoid using a telephone (other basic safety precautions should always only from the type of power source outlet and refer servicing to qualified than a cordless type) during an service personnel under the be followed to reduce the risk of fire, indicated on the marking label. If electrical storm. There may be a electric shock and injury to persons, you are not sure of the type of f
Inhaltszusammenfassung zur Seite Nr. 6
If you have two telephone numbers Setting Up Your VT2900 Modular Jack Test If you don't hear any dial tone on 1. Choose an area near an electrical installed on two separate jacks, a jack, there may be a problem outlet and a telephone wall jack. (type RJ-11) both jacks must be Perform this test if you aren't sure with the jack or the wiring in your within reach of your phone. You will whether you have two-line jacks or home. (see page 30, 'IN CASE OF 2. Connect your telephone Line need to u
Inhaltszusammenfassung zur Seite Nr. 7
WALL INSTALLATION USING You cannot select TONE for one line CAUTION: MOUNTING SCREWS PROVIDED and PULSE for the other. Both will be 1. Never install telephone wiring Tools You Will Need: A hammer, a either TONE or PULSE. during a lightning storm. nail, a pencil or ballpoint pen, a Phillips head (+) screwdriver, and the Wall CHARGE THE HANDSET BAlTERY 2. Never install telephone jacks in wet Mounting Template included in the PACK BEFORE USE. locations unless the jack is back of thi
Inhaltszusammenfassung zur Seite Nr. 8
4. Position the wall mount adapter Line 2 Indicator INTERCOM Indicator ,- Memory Mode Indicator Name Dialing Indicator Line 1 lndicator7 on the base. 7 I /-- Line up the tabs on the wall mount Low Battery 7 \ \ 7 Earpiece Volume adapter with the holes on the Indicator Level Indicator bottom of the base (Figure 1). Snap the wall mount adapter firmly in place. 5. Mount the base on the wall. 1 I Position the base so the mounting PROGRAM lndicator studs will fit into the holes on th
Inhaltszusammenfassung zur Seite Nr. 9
\. 2 LINE MHz CORDLESS PHONE bmzl MEMORY I FLEXIBLE ANTENNA DIALING CARD w LCD SCREEN SPEAKER GRILL / -- LINE KEYS ANTENNA OFF KEY OFF KEY LINE KEYS DIGIT KEYS ZERO VOLUME >f: , TEMPORARY TONE UPIDOWN KEYS PROGRAM AND MEMORY KEY CONFERENCE CLEAR KEY KEY INTERCOM & CHANNEL INTERCOM KEY CHANGE KEY MUTE KEY CONFERENCE AND BACKSPACE KEY HOLD KEY REDIAL KEY POWER INDICATOR HOLD KEY CHARGE INDICATOR \ \ CHARGE CONTACTS MAlN FEATURES ON HANDSET MAlN FEATURES ON
Inhaltszusammenfassung zur Seite Nr. 10
The MUTE indicator will light and Here's a brief guide to the features NAME DIALING: CHANGING CHANNELS the speakerphone microphone will and functions of your VT2900cordless Press a LlNE key. Press the CHANIINTCM key to telephone: be cut off. Press MEM. Make sure NAME is change the channel. The display Press MUTE again to return to displayed on the LCD. If not, press will briefly show the new channel normal speakerphone operation. SET-UP MEM again. number. Connect telephone line cord(s
Inhaltszusammenfassung zur Seite Nr. 11
The volume controls for the handset Making Calls Disconnecting To end a call, either place the handset are located on the side of the unit. You can make calls directly from the handset whether you are at the base back in the base, or press OFF on the Press the A (up) or V (down) keys to increase or decrease the or away from it. You cannot make handset. volume. Holding either key down will calls on the speakerphone in the base continuously change the volume but you can answer calls from
Inhaltszusammenfassung zur Seite Nr. 12
If a call is on HOLD using the VT2900 Using Both Lines At Once NOTE: If you want to switch to another Likewise, if you are using the and you pick up another phone on the If your using your handset to carry on line without disconnecting your current speakerphone, someone at the same line, the VT2900 will take itself a conversation on one line, it is call, you can also simply press the handset can join the conversation by off HOLD and turn OFF. Therefore, possible to use the other line to ot
Inhaltszusammenfassung zur Seite Nr. 13
Conferencing To join a three-way conference already 2. Press CONF to continue your conference call. This feature allows you to link both CONFERENCE CALLING in progress, press LlNE 1 or LlNE 2 FROM THE HANDSET lines together to hold a three-way on the base if the conference is at the MAKE OR RECEIVE CALL handset. If the conference is at the Temporary Tone conversation between you and the ON LlNE 1 OR LlNE 2 PRESS HOLD TO PLACE base, press LlNE 1 or LlNE 2 at the If you have a rotary (dia
Inhaltszusammenfassung zur Seite Nr. 14
Advanced Dialing Programming The Ringer Turning Off The Ringer Changing Channels The handset ringer is capable of four There are two different ways to dial In the unlikely event you notice To turn off the ringer for a particular out a number: different types of ringer tones for each interference when using your handset, line do the following: 1 Press the LlNE key and wait for a press the INTCMICHAN key to switch line. The following sections detail how Press and hold PROG until the dial
Inhaltszusammenfassung zur Seite Nr. 15
The VT2900 is capable of two modes Press MEM to store and exit. A of memory dialing. You can dial out Happy tone will be generated if by pressing the memory location (e.g. programming was successful. 15) or by entering the person's name Otherwise, the unit will generate a (e.g. "BOB). We suggest that numbers sad tone and display: Enter the memory location (00..19) be stored with the person's name to you wish to store the number in. As which the number belongs. soon as the second me
Inhaltszusammenfassung zur Seite Nr. 16
If you get Error displayed during Deleting Stored Numbers TAKING CARE OF YOUR Electrical storms / programming when you are entering TELEPHONE Electrical storms can sometimes cause To delete a stored number from I the name, you may have entered too Your VT2900 cordless telephone power surges harmful to electronic memory do the following: contains sophisticated electronic parts Press MEM. Check to make sure equipment. 1 few or too many letters. Enter only six L so it must be treated wit
Inhaltszusammenfassung zur Seite Nr. 17
For out-of-range in standby mode, the NOISE OR INTERFERENCE If you have difficulty operating your YOU GET NOISE, STATIC, OR A Your VT2900 cordless telephone has handset will beep at 15 second WEAK SIGNAL EVEN WHEN phone, the suggestions below should intervals. To disable the warning auto-channel scan circuitry which will solve the problem. If you still have YOU'RE NEAR THE BASE UNIT. detect excess noise and change the tones, simply press and hold a number Place the handset in the base dif
Inhaltszusammenfassung zur Seite Nr. 18
IF THE HANDSET APPEARS TO VTECH Communications warrants, WHEN USING THE SPEAKER- MISS DIGITS IMMEDIATELY to the original purchaser only, the PHONE, YOUR CALLER'S VOICE FOLLOWING PRESSING THE LINE GETS CUT OFF AND IS HARD TO material and workmanship of this KEY product for ONE YEAR from the date HEAR. Press the LINE key again and then Your VOLUME CONTROL may be of purchase. VTECH will repair or wait 2 seconds before dialing. replace, at our option, this product turned down. If you're i
Inhaltszusammenfassung zur Seite Nr. 19
This equipment complies with Parts 15 The equipment has been tested and FCC Part 68 This equipment may not be used on and 68 of the Federal Communications found to comply with part 15 of the The FCC requires that you connect coin service provided by the phone Commission (FCC) rules for the United FCC rules. These limits are designed your cordless telephone to the company or Party Lines. States. It also complies with to provide reasonable protection nationwide telephone network through re
Inhaltszusammenfassung zur Seite Nr. 20
SIZE Before installing this equipment, users FREQUENCY CONTROL Caution: User should not attempt to I should ensure that it is permissible to Crystal Controlled Dual PLL Handset: 20.2cm x 6.2cm x 4.5cm make such connections them-selves, i ( L x W x T ) maximum be connected to the facilities of the Synthesizer I but should contact the appropriate ( anntenna excluded ) electric inspection authority, or 1 local telecommunications company. The equipment must also be installed TRANSMIT FR
