Inhaltszusammenfassung zur Seite Nr. 1
GAPAB
PERFECT AIR AIR PURIFIER FOR FAN COILS
SIZES 1620, 2020 AND 2420
Installation Instructions
NOTE: Read the entire instruction manual before starting the
install.
TABLE OF CONTENTS
PAGE
INTRODUCTION ................................... 1
HOW IT WORKS ................................... 1
SAFETY CONSIDERATIONS ......................... 1
APPLICATION CONSIDERATIONS .................... 2
INSTALLATION .................................... 3
START--UP AND OPERATION ........................ 6
MAINT
Inhaltszusammenfassung zur Seite Nr. 2
Transitions ! CAUTION If the return air duct or fan coil openings do not fit the Perfect Air Air Purifier cabinet openings, gradual transitions are recommended to reduce air turbulence and maximize efficiency. No more than 20 PERSONAL INJURY HAZARD degrees (about 4 in. per running ft.) of expansion should be used Failure to follow this caution may result in personal injury. on each side of the transition fitting. Ozone in concentrations above 0.05 PPM may be hazardous Turning Vanes to health. If
Inhaltszusammenfassung zur Seite Nr. 3
c. The location of the Perfect Air Air Purifier should be readily INSTALLATION accessible. Enough room should be provided for periodic re- Step 1 — Check Perfect Air Air Purifier Components placement of the air purifier cartridges. Step 3 — Mount Cabinet ! CAUTION a. Turn off power to the heating and cooling system. b. Remove the existing fan coil filter and discard. Excessive sys- PERSONAL INJURY HAZARD tem static pressure may result if the Perfect Air Air Purifier is Failure to follow this cau
Inhaltszusammenfassung zur Seite Nr. 4
c. Connect the power cord and the flow sensor cord to the power supply connector and the flow sensor connector (see Fig. 7 and Fig. 8). A06392 A06414 Fig. 6 -- Use of Return Duct Adapters Fig. 7 -- Flow Sensor Cable Installed ! WARNING ELECTRIC SHOCK AND UNIT DAMAGE HAZARD Failure to follow this warning could result in personal injury or death. Only a trained, experienced service person should install the Perfect Air Air Purifier. A thorough check of the unit installation should be completed bef
Inhaltszusammenfassung zur Seite Nr. 5
NOTICE ! WARNING ELECTRICAL SHOCK HAZARD AIR FLOW SENSOR CABLE OR AIR FLOW SENSOR BYPASS PLUG MUST BE CONNECTED TO THE Failure to follow this warning could result in personal POWER SUPPLY IN ORDER TO ACTIVATE THE AIR injury or death. PURIFIER Before installing or servicing system, always turn off main power to system. There may be more than 1 disconnect switch. ! CAUTION EQUIPMENT DAMAGE HAZARD Failure to follow this caution may result in equipment damage or improper operation. This unit cannot
Inhaltszusammenfassung zur Seite Nr. 6
Purifier cartridge. This maintenance reminder can be based on START--UP AND OPERATION either the TrueSenset dirty filter algorithm or time. The in- Checking Air Purifier Operation staller should use their discretion to select the most appropriate option based on the initial system static pressure. ! WARNING Maximizing Performance ELECTRICAL SHOCK AND HIGH VOLTAGE a. Maximum air purification performance is obtained when the HAZARD furnace blower is set for continuous operation on the thermo- stat
Inhaltszusammenfassung zur Seite Nr. 7
Step 5 — Slide out the enhancement module assembly and safety Step 7 — Gently stroke the ionization pins on the top plane of screen. each bar with enough brush depth to hit front and back tips of the points in the ionization array. Use a gentle back and forth brushing motion to clean any small accumulations from the tips of the ! CAUTION points. If desired, use vacuum cleaner with brush attachment to gently vacuum the frame and components of enhancement module. PERSONAL INJURY HAZARD Step 8 — Re
Inhaltszusammenfassung zur Seite Nr. 8
NOTE: A magnet in the door (see Fig. 8) is used to activate a TROUBLESHOOTING safety switch in the power supply when the door is installed. The power supply will not energize the air purifier unless the safety ! CAUTION switch is activated. Step 2 — Check that the Perfect Air Air Purifier power switch is in SAFETY HAZARD the on (closed) position. Failure to follow this caution may result in personal injury or Step 3 — Confirm that the fan coil blower is operating. equipment damage. Step 4 — Conf
Inhaltszusammenfassung zur Seite Nr. 9
SPECIFICATIONS AND DIMENSIONS Table 1 – Specifications and Dimensions SPECIFICATIONS GAPABXBB1620 GAPABXBB2020 GAPABXBB2420 Color Taupe Metallic Taupe Metallic Taupe Metallic CabinetMaterial 20 Ga. Powder Coated Steel 20 Ga. Powder Coated Steel 20 Ga. Powder Coated Steel Electrical 208/230v/60Hz 208/230v/60Hz 208/230v/60Hz Maximum Airflow (CFM) 1350 1800 2000 Efficiency EquivalenttoMERV15 EquivalenttoMERV15 EquivalenttoMERV15 ReplacementCartridge GAPCCCAR1620 GAPCCCAR2020 GAPCCCAR2420 InitialPre
Inhaltszusammenfassung zur Seite Nr. 10
10 GAPAB
Inhaltszusammenfassung zur Seite Nr. 11
Limited Warranty for Air Purifier FOR WARRANTY SERVICE OR REPAIR: Contact the installer. You may find the installer’s name on the equipment or in your Owner’s Packet. For help, contact: CAC / BDP, Consumer Relations, P.O. Box 4808, Syracuse, New York 13221, Phone 1-800-227-7437 PRODUCT REGISTRATION: You can register your product online at www.cac-bdp.com. Model No. ____________________________________________ Unit Serial No. ________________________________________ Da
Inhaltszusammenfassung zur Seite Nr. 12
WARRANTY CONDITIONS: 1. To obtain the longer warranty periods as shown in the table under original owner, for the original purchaser, the product must be properly registered at www.cac-bdp.com within ninety (90) days of original installation. In jurisdictions where warranty terms conditioned on registration are prohibited by law, registration is not required and the longer warranty period shown will be apply. 2. Where a product is installed in a newly constructed home, the date of in
