Inhaltszusammenfassung zur Seite Nr. 1
REFRIGERATOR USER INSTRUCTIONS
THANK YOU for purchasing this high-quality product. If you should experience a problem not covered in TROUBLESHOOTING,
please visit our website at www.jennair.com for additional information. If you still need assistance, call us at 1-800-536-6247. In
Canada, visit our website at www.jennair.ca or call us at 1-800-807-6777.
You will need your model and serial number, located on the inside wall of the refrigerator compartment.
Table of Contents / Índice / Ta
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electric shock, or injury when using your refrigerator, follow these basic precautions: ■ Plug into a grounded 3 prong outlet. ■ Use nonflammable cleaner. ■ Do not remove ground prong. ■ Keep flammable materials and vapors, such as gasoline, away from refrigerator. ■ Do not use an adapter. ■ Use two or more people to move and install refrigerator. ■ Do not use an extension cord. ■ Disconnect power before installing ice maker (
Inhaltszusammenfassung zur Seite Nr. 3
Location Requirements Electrical Requirements WARNING WARNING Explosion Hazard Electrical Shock Hazard Keep flammable materials and vapors, such as Plug into a grounded 3 prong outlet. gasoline, away from refrigerator. Do not remove ground prong. Failure to do so can result in death, explosion, or fire. Do not use an adapter. Do not use an extension cord. To ensure proper ventilation for your refrigerator, allow for 1/2" (1.25 cm) of space on each side and at the top. Allow for 1" Failure to f
Inhaltszusammenfassung zur Seite Nr. 4
6. Fasten the shutoff valve to the cold water pipe with the pipe Water Pressure clamp. Be sure the outlet end is solidly in the ¹⁄₄" drilled hole in the water pipe and that the washer is under the pipe clamp. Tighten the packing nut. Tighten the pipe clamp screws slowly A cold water supply with water pressure of between 35 and and evenly so the washer makes a watertight seal. Do not 120 psi (241 and 827 kPa) is required to operate the water overtighten. dispenser and ice maker. If you ha
Inhaltszusammenfassung zur Seite Nr. 5
4. Slide the compression nut over the sleeve and screw into the water valve inlet port. Refrigerator Door(s) and Drawer TOOLS NEEDED: ⁵⁄₁₆", ³⁄₈", ¹⁄₄" hex head socket wrench, a #2 Phillips screwdriver, and a flat-blade screwdriver. A IMPORTANT: ■ Your refrigerator may have a standard reversible refrigerator door (Style 1) with either a freezer door or freezer drawer, or B French doors (Style 2). Follow the instructions specific to the C door style of your model. ■ All graphics reference
Inhaltszusammenfassung zur Seite Nr. 6
Freezer drawer models Reverse Door - Standard Door (optional) 1. Unplug refrigerator or disconnect power. 2. Keep the refrigerator door closed until you are ready to lift it IMPORTANT: If you want to reverse your door so it opens from free from the cabinet. the opposite side, follow these steps. If you are not reversing the NOTE: Provide additional support for the door while the door, see “Replace Door(s) and Hinges.” hinges are being moved. Do not depend on the door gasket magnets to hol
Inhaltszusammenfassung zur Seite Nr. 7
Freezer door models Plastic Handles 1. Replace the parts for the bottom hinge as shown. Tighten ■ To remove the handle, grasp the handle firmly, slide the handle screws. Replace the freezer door. to the left and pull the handle straight out from the drawer. See Plastic Handle graphic 2. NOTE: Provide additional support for the door while the hinges are being moved. Do not depend on the door gasket ■ To replace the handle, position the handle so that the large magnets to hold the door in pla
Inhaltszusammenfassung zur Seite Nr. 8
Style 1–Standard Door Door Swing Reversal (optional) Door Removal & Replacement 2 2 Front Mount Side Mount Top Hinge A A C 1-2 A 1st B 3rd B C A. Cabinet Hinge Hole Plugs A. Top Hinge Cover 1-1 B. ⁵⁄₁₆" Hex-Head Hinge Screws C. Top Hinge 2nd A 4th Center Hinge A. ⁵⁄₁₆" Hex-Head Hinge Screws D B A A. Trim Screw B B. Handle Screws C C. Top Trim D. Bottom Trim 6 A. Hinge Pin Cover 3 A B. Center Hinge C. Hinge Screws A. Door Hinge Hole Plug Bottom Hinge Door Handle Seal Screw Front View Side Vie
Inhaltszusammenfassung zur Seite Nr. 9
Style 2–French Doors WARNING Electrical Shock Hazard Disconnect power before removing doors. Failure to do so can result in death or electrical shock. Door Removal & Replacement Top Hinges A B 1 Plastic Handle C 1 D Metal Handle A. Hinge Cover Screw B. Top Hinge Cover 5 C. /16" Hex Head Hinge Screws D. Top Hinge Bottom Hinges A A B C A. Hinge Pin Cover B. Bottom Hinge C. Hinge Screws A. ³⁄₃₂" or ¹⁄₈" Setscrew Wiring Plug 2 2 Metal Handle Plastic Handle A A. ³⁄₃₂" or ¹⁄₈" Setscrew Drawer Front Re
Inhaltszusammenfassung zur Seite Nr. 10
Adjust the Door Depending on your model, your refrigerator may have two front adjustable rollers (Styles 1 and 2), or a leveling screw (Style 3), Style 2–Freezer Drawer Models located at the base of the refrigerator. If your refrigerator seems unsteady or you want the door to close more easily, follow the 1. Remove the base grille. Grasp the grille firmly and pull it instructions for your model. toward you. Style1–Freezer Door Models 1. Remove the base grille. Grasp the grille firmly and p
Inhaltszusammenfassung zur Seite Nr. 11
■ To lower, turn the leveling screw counterclockwise. ■ If the temperature is too warm or too cold in the refrigerator or freezer, first check the air vents to be sure they are not blocked before adjusting the controls. Electronic and Dial Controls For your convenience, the temperature controls are preset at the factory. When you first install your refrigerator, make sure the controls are still set to the recommended setting as shown. Style 1 Recommended Setting “4” A A. Leveling screw 3. O
Inhaltszusammenfassung zur Seite Nr. 12
Digital Controls For your convenience, your temperature controls are preset at the Speed Ice Feature factory. When you first install your refrigerator, make sure the The Speed Ice feature assists with temporary periods of heavy ice controls are still set to the recommended set points as shown. use by increasing ice production. Recommended Settings ■ Press the SPEED ICE feature touch pad to set the freezer to the lowest temperature setting. Press the SPEED ICE feature touch pad again to ret
Inhaltszusammenfassung zur Seite Nr. 13
Door Alarm The Door Alarm feature sounds a chime every few seconds when Crisper Humidity Control the refrigerator door has been left open for 5 continuous minutes. You can control the amount of humidity in the moisture-sealed The chime will sound until the door is closed or Door Alarm is crisper. Depending on your model, adjust the control to any turned off. setting between FRUIT and VEGETABLES or LOW and HIGH. ■ Press the DOOR ALARM touch pad to turn this feature on or FRUIT / LOW (open)
Inhaltszusammenfassung zur Seite Nr. 14
NOTE: After 5 minutes of continuous dispensing, the 3. Turn the filter clockwise until it stops. Snap the filter cover dispenser will stop dispensing water to avoid flooding. To closed. continue dispensing, press the dispenser button again. NOTE: The dispenser feature may be used without a water filter installed. Your water will not be filtered. If this option is chosen, ■ Allow 24 hours for the refrigerator to cool down and chill replace the filter with the blue bypass cap. water. Dispens
Inhaltszusammenfassung zur Seite Nr. 15
Changing the Light Bulb NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to replace the bulb with an appliance bulb of the same size, shape, and wattage (no greater than 40 watts). 1. Unplug the refrigerator or disconnect power. 2. Remove the light shield (on some models). Freezer drawer models 3. Replace the burned-out bulb(s) with an appliance bulb(s) no ■ Top of the refrigerator compartment - Slide the light shield greater than 40 watts. toward the back of the compartm
Inhaltszusammenfassung zur Seite Nr. 16
The refrigerator seems noisy There is interior moisture buildup Refrigerator noise has been reduced over the years. Due to this NOTE: Some moisture buildup is normal. reduction, you may hear intermittent noises from your new ■ Humid room? Contributes to moisture buildup. refrigerator that you did not notice from your old model. Below are ■ Door(s) opened often or left open? Allows humid air to enter listed some normal sounds with explanations. refrigerator. Minimize door openings and keep doo
Inhaltszusammenfassung zur Seite Nr. 17
■ Odor transfer from food? Use airtight, moisture proof packaging to store food. WATER FILTER ■ Are there minerals (such as sulfur) in the water? A water filter may need to be installed to remove the minerals. CERTIFICATIONS ■ Water filter installed on the refrigerator? Gray or dark discoloration in ice indicates that the water filtration system needs additional flushing. Flush the water system before using a new water filter. Replace water filter when indicated. See “Water Filtration S
Inhaltszusammenfassung zur Seite Nr. 18
PRODUCT DATA SHEETS Interior Water Filtration System Model UKF8001AXX-750 Capacity 750 Gallons (2839 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Atrazine, Benzene, p-Dichlorobenzene, Carbofuran, Toxaphene, Cysts, Turbidity, Asbestos, Tetrachloroethylene and Lindane. This system has been tested according to NSF/ANSI S
Inhaltszusammenfassung zur Seite Nr. 19
Interior Water Filtration System Model UKF8001AXX-200 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Atrazine, Benzene, p-Dichlorobenzene, Carbofuran, Toxaphene, Cysts, Turbidity, Asbestos, O-Dichlorobenzene, Ethylbenzene, Chlorobenzene, Endrin, Tetrachloroethylene and Lindane. This system has
Inhaltszusammenfassung zur Seite Nr. 20
® JENN-AIR REFRIGERATOR WARRANTY LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Jenn-Air brand of Whirlpool Corporation or Whirlpool Canada LP (hereafter “Jenn-Air”) will pay for factory specified parts and repair labor to correct defects in materials or workmanship that existed when this major appliance was purchased. Service must be provided by a Jenn-Air desig
