Inhaltszusammenfassung zur Seite Nr. 4
I(ENMORE ELITE®LIMITED WARRANTY Disclaimer of implied warranties; limitation of remedies When installed, operated and maintained according to all instructions supplied with the product, if any non-consumable Customer's sole and exclusive remedy under this limited part of this appliance other than the sealed refrigerant system warranty shall be product repair as provided herein. Implied fails due to a defect in material and workmanship within one warranties, including warranties of merchantabilit
Inhaltszusammenfassung zur Seite Nr. 5
REFRIGERATORSAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING." These words mean: You can be killed or seriously injured if you don't immediately
Inhaltszusammenfassung zur Seite Nr. 6
INSTALLATION INSTRUCTIONS Excessive Weight Hazard Use two or more people to move and install refrigerator. Failure to do so can result in back or other injury. Explosion Hazard Keep flammable materials and vapors, such as Remove the Packaging gasoline, away from refrigerator. Remove tape and glue residue from surfaces before turning Failure to do so can result in death, explosion, or fire. on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with
Inhaltszusammenfassung zur Seite Nr. 7
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. TOOLS NEEDED: • Flat-blade screwdriver • 1/4" Nut driver • 7/16" and 1/2" Open-end or two • 1/4" Drill bit adjustable wrenches • Cordless drill Electrical Shock Hazard NOTE: Your refrigerator dealer has a kit available with a 1/4" Plug into a grounded 3 prong outlet. (6.35 ram) saddle-type shutoff valve, a union, and copper Do not remove ground prong. tubing. Be
Inhaltszusammenfassung zur Seite Nr. 8
Gather the required tools and parts and read all instructions before starting installation. Save these instructions for future reference. NOTE: Before moving your product into your home, measure the doorway of your home to see whether you need to remove the refrigerator and freezer doors. If door removal is necessary, see the instructions below. IMPORTANT: Before you begin, turn the refrigerator control OFF. Unplug refrigerator or disconnect power. TOOLS NEEDED: Phillips screwdriver, 3/16" hex k
Inhaltszusammenfassung zur Seite Nr. 9
Remove the Doors Excessive Weight Hazard Use two or more people to lift the freezer door. Failure to do so can result in back or other injury. 8o Lift freezer door straight up off bottom hinge. See Graphic 5° The water tubing and wiring remain attached to Electrical Shock Hazard the freezer door and pull through the bottom left hinge. Disconnect power before removing doors. NOTE: This may require two people - one to lift the door and another to feed the water tubing and wiring through the Failur
Inhaltszusammenfassung zur Seite Nr. 10
7. Align and replace the top right hinge as shown. See Graphic 6. Tighten screws. 8. Replace the ice storage bin and any adjustable door or Excessive Weight Hazard utility bins. Use two or more people to lift the freezer door. 9. Plug refrigerator into a grounded 3 prong outlet. Failure to do so can result in back or other injury. Leveling and Door Closing Your refrigerator has two adjustable front feet -- one on the 2. Before replacing the freezer door on the bottom left hinge, right and one on
Inhaltszusammenfassung zur Seite Nr. 11
IMPORTANT: When the screws feel tight, tighten them an _md e ss_s
Inhaltszusammenfassung zur Seite Nr. 12
NOTE: To allow sufficient water flow to the refrigerator, a NOTE: To avoid rattling, be sure the copper tubing does not minimum 1/2" size copper household supply line is touch the cabinet's side wall or other parts inside the recommended. cabinet. A B C D A B A. Line to refrigerator C. Ferrule (purchased) B. Nut {purchased) D. Supplied line from refrigerator C 4° Install the water supply tube clamp around the water supply D line to reduce strain on the coupling. 5. Turn shutoff valve ON. A. Bulb
Inhaltszusammenfassung zur Seite Nr. 13
Style 3 sta Cea ' Fow F 1. Unplug refrigerator or disconnect power. 2. Remove and discard the black nylon plug from the gray (on so_>e n,¢odes} water tube on the rear of the refrigerator. On some models, your refrigerator's accessory packet includes 3. If the gray water tube supplied with the refrigerator is not an air filter, which must be installed prior to use. On some long enough, a 1/4" x 1/4" (6.35 mm x 6.35 mm) coupling is models the air filter is already installed at the factory. needed
Inhaltszusammenfassung zur Seite Nr. 14
NOTE: The indicator will not easily slide into the notches if Remove the Produce Preserver pouches from their the rear bubble has not been popped. packaging. 4. Close the air filter door, and check that the indicator is visible through the rectangular hole in the door. Replacing the Air Filter The disposable air filter should be replaced every 6 months, 0 spe
Inhaltszusammenfassung zur Seite Nr. 15
Rattling noises may come from the flow of refrigerant, the water line, or items stored on top of the refrigerator. Please read before using the water system. Water dripping on the defrost heater during a defrost cycle may cause a sizzling sound. Immediately after installation, follow the steps below to make sure that the water system is properly cleaned. As each cycle ends, you may hear a gurgling sound due to the refrigerant flowing in your refrigerator. 1. Open the freezer door and turn off th
Inhaltszusammenfassung zur Seite Nr. 16
Dual evaporation results in higher humidity, which helps keep Adjusting the Controls foods in the refrigerator from spoiling as quickly and improves food quality and freshness in the freezer due to decreased For your convenience, your refrigerator and freezer controls are freezer burn. In addition, the dual evaporation system helps preset at the factory. When you first install your refrigerator, keep food smells in the refrigerator from transferring to ice in make sure that the controls are stil
Inhaltszusammenfassung zur Seite Nr. 17
NOTE: To exit without saving changes, press WATER/ICE at NOTE: If increased ice production is desired at all times, any time while in adjust mode, or allow about 60 seconds of change the freezer set point to a lower setting. Setting the inactivity and adjust mode will turn off automatically. freezer to a colder temperature may make some foods, such as ice cream, harder. When adjusting temperature set points, use the following chart Door Ajar Alarm as a guide. The Door Ajar Alarm feature sounds a
Inhaltszusammenfassung zur Seite Nr. 18
Dispensing Options The Water Dispenser IMPORTANT: Your dispenser can dispense water and ice in two ways. • The DISPENSE WATER button, located below the dispenser • Dispense at least 1 qt (1 L) of water every week to maintain a control panel's display screen, dispenses only water. fresh supply. • The dispenser pad is the pad located along the rear wall of • If the flow of water from the dispenser decreases, it could be the dispenser cavity. When pressed, it dispenses either water caused by low wa
Inhaltszusammenfassung zur Seite Nr. 19
6. To stop dispensing before the selected volume has been dispensed, remove the glass from the dispenser pad OR press either the DISPENSE WATER button or the LIGHT button a second time. NOTE: If you stop dispensing before the desired volume has been dispensed, the digital display will continue to show how much water remains to be dispensed. The display will turn off after 1 minute of inactivity. The Ice Dispenser Ice dispenses from the ice maker storage bin in the freezer when the dispenser pad
Inhaltszusammenfassung zur Seite Nr. 20
3, Remove the glass to stop dispensing. NOTE: If water flow to your water dispenser or ice maker decreases noticeably, change the filter sooner. The filter NOTE: Ice may continue to dispense for several seconds should be replaced at least every 6 months, depending on after removing the glass from the pad. The dispenser may your water quality and usage. continue to make noise for a few seconds after dispensing. After changing the water filter, reset the status light. Press the SETTINGS button, th
