Inhaltszusammenfassung zur Seite Nr. 12
A Quick Look At The Remote Control REPEAT 1/ALL—pressto repeat a track or CDs. CD-R — press to select the RECORD/PLAYBACK tray. REPEAT A-B — press to repeat a designated section. CD-R Operation buttons DIGITAL REC LEVEL Numeric Buttons — Use –/+ — press to adjust these buttons to select track the recording level. numbers. RECORD — press to — hold down to @I enter record pause search for a part of a track. mode. TIME — press to change the time display. g — press to start playback, recordi
Inhaltszusammenfassung zur Seite Nr. 13
If you do not plan to use the remote Installing Batteries control for a month or more, remove the batteries. Using the Remote For the best results, point the remote control toward REMOTE SENSOR on the front of Your CD recorder's remote control requires the CD recorder. two AA batteries (not supplied) for power. We recommend alkaline batteries, available at your local RadioShack store, for the best performance and longest life. Cautions: Always use fresh batteries of the required siz
Inhaltszusammenfassung zur Seite Nr. 14
A Quick Look At The Display Pause Type of Disc in Input REPEAT Peak Indicator RECORD/PLAYBACK Selection A-TRACK Indicator Level Tray Playback (Auto Track) Meter Indicator SHUFFLE SYNC Indicator Recording Indicator Program Indicator Record INTRO Indicator CHECK Indicator Time Display (Min. and Track Number of Time Display (Min. and Track Number of Sec.) of PLAYBACK Tray PLAYBACK Tray Sec.) of RECORD/PLAYBACK RECORD/PLAYBACK Tray Tray Message Display A Quick Look at the CD Recorder’s Contro
Inhaltszusammenfassung zur Seite Nr. 15
AUTO/MANUAL — press (button on the left INPUT SELECTOR — press to select the of the CD recorder) to select the track source you want to record from. number increment level, or to select the 1 synchronized recording starting level. PHONES — insert your /4-inch headphones plug into the PHONES jack on the front of — (for PLAYBACK and RECORD/ the CD recorder. BC PLAYBACK trays) — press to skip tracks. Hold down to search for a part of a track. Note: To further reduce the headphone volume level,
Inhaltszusammenfassung zur Seite Nr. 16
Operation CD-R, NO TOC —aCD-Rwhich Playing CDs has yet to be finalized. You can use the RECORD/PLAYBACK tray CD-RW, NO TOC — a CD-RW to play back CD, CD-R, and CD-RW discs. which has yet to be finalized. You can use the PLAYBACK tray to play back CD and finalized CD-R/CD-RW discs. CD-RW — a finalized CD-RW. You cannot play CD-R/CD-RW discs that BLANK — No disc or unreadable disc. haven’t been finalized on the PLAYBACK tray. 5. Press for the PLAYBACK tray or ² /ENTER for the RECORD/ ² 1.
Inhaltszusammenfassung zur Seite Nr. 17
During program playback, press Notes: B once to return to the beginning of the If you press the numeric button in the current track. To return to the beginning pause mode, the CD recorder enters of the previous track in the program, pause mode at the beginning of the press twice. To playback the next B selected track. track in the program, press . You C cannot use the numeric buttons on the Direct playback is not possible during remote control. shuffle playback and program playback.
Inhaltszusammenfassung zur Seite Nr. 18
When you set discs in both the PLAYBACK current track finishes. In the stop mode, tray and the RECORD/PLAYBACK tray, the press SHUFFLE then . g CD recorder repeats all the tracks of each disc alternately for five cycles and then If you press during shuffle play, the CD J stops. recorder randomly selects the next track. If you press , the CD recorder plays the F current track from the beginning. Repeating a Designated Section (A-B Repeat) To cancel shuffle play at any time, press SHUFFLE
Inhaltszusammenfassung zur Seite Nr. 19
5. When you finish the selection of track Programming a Sequence numbers, press . The track number D of Tracks programmed toST: 01 appears. You can program up to 32 selections from 2 6. Press to play the sequence. After the g discs to play in any order you choose. CD recorder plays all programmed tracks, it stops and ST: 01 appears. Note: Shuffle playback does not work The CD recorder keeps the sequence in during program playback. memory even after programmed playback has finished or st
Inhaltszusammenfassung zur Seite Nr. 20
Adding to the Programmed Before Recording Sequence Before you start recording, make sure that You can add tracks at the end of a you understand the following points: programmed sequence, up to a maximum of 32 tracks. The CD recorder requires Digital Audio CD-R or CD-RW media for recording. 1. Press PROGRAM in the stop mode. Computer CD-R or CD-RW discs do not work with this CD recorder. 2. Enter the desired track number, then Once you have recorded on a CD-R press PROGRAM. The CD rec
Inhaltszusammenfassung zur Seite Nr. 1
Dual-Tray CD Player/Recorder
Thank you for purchasing the RCA Dual- This CD player is made and tested to meet
Tray CD Player/Recorder. Your CD exacting safety standards. It meets FCC
recorder is easy to operate and provides requirements and complies with safety
many options for its use as listed below. performance standards of the U.S.
Department of Health and Human Services.
Warnings:
Features
This CD player employs a laser light
Dual Tray — lets you record from CD to
beam. Only a quali
Inhaltszusammenfassung zur Seite Nr. 2
Note, however, that in the United States, it is recorder, and safety is a major factor in its not a violation of U.S. copyright laws for a design. However, safety is also your consumer to use an audio recording device responsibility. to duplicate musical recordings for noncommercial (personal) use. This section lists important information that will help you properly use and enjoy your CD recorder and accessories. Read all the included safety and operating instructions The FCC Wants You To
Inhaltszusammenfassung zur Seite Nr. 3
Cart — Use only with the cords at plugs, convenience receptacles, and cart, stand, tripod, bracket, or the point where they exit from the product. table specified by the manufacturer, or sold with Non use Periods — Unplug the CD the apparatus. When a cart is recorder's power cord when you will not use used, use caution when moving the cart/ it for extended periods. apparatus combination to avoid injury from tip-over. Lightning — For added protection for this product during a lightning stor
Inhaltszusammenfassung zur Seite Nr. 4
If liquid has been spilled or objects have fallen into the product. If the product has been exposed to rain or water. If the product does not operate normally by following the operating instructions, adjust only those controls that are covered by the operating instructions, as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation. If the product has been dropped or
Inhaltszusammenfassung zur Seite Nr. 5
Contents Before Use ..................................................................................................................... 7 Compact Discs ....................................................................................................... 7 About CD-R and CD-RW Discs .............................................................................. 7 Finalizing ............................................................................................................... 7 Recorda
Inhaltszusammenfassung zur Seite Nr. 6
Setting the Recording Level ................................................................................. 24 Finalizing ............................................................................................................ 24 Erasing or Unfinalizing a CD-RW ........................................................................ 24 Advanced Recording ................................................................................................... 25 Assigning Track Numbers to Recordi
Inhaltszusammenfassung zur Seite Nr. 7
material. The packaging of CD-R discs Before Use includes this logo below. The nominal temperature should be between 41°F and 95°F (5°C and 35°C). The CD-RW recorder is more sensitive to extremes of temperature than ordinary CD players. By contrast, you can use a CD-RW disc in much the same way as a CD-R disc, but you Relative humidity should be 30 to 90% can erase the last track or all the tracks, and non-condensing. you can use the space on the disc for other recordings. The pack
Inhaltszusammenfassung zur Seite Nr. 8
The process of writing this table of contents Never touch the recording (non-label) is known as “finalizing.” Once this has been side of a disc on which you will be done, no further data can be written to the recording. Recording on a disc requires CD-R disc. a cleaner surface than playing back, and fingerprints, dust, grease, and so on, A CD-RW disc that has been finalized can be can cause errors in the recording “unfinalized.” This allows further tracks to process. be recorded to the d
Inhaltszusammenfassung zur Seite Nr. 9
Do not stick papers or protective sheets Condensation on the discs and do not use any protective coating spray. When the CD recorder (or a disc) is moved from a cold to a warm place, or used after a Use a soft oil-based felt-tipped pen to sudden temperature change, there is a write the information on the label side. danger of condensation; vapor in the air Never use a ball-point or hard-tipped could condense on the internal mechanism, pen, as this may cause damage to the making co
Inhaltszusammenfassung zur Seite Nr. 10
Connections and Setup Note: Turn off the power of all the equipment before making connections and read the instructions of each component you intend to use with the CD recorder. LINE IN/OUT Jacks Connect the LINE IN/OUT jacks to your analog source (receiver) using the supplied RCA stereo patch cable. An additional patch cable is available at your local RadioShack store or at RadioShack.com. Insert LINE IN to your receiver’s line out jack (REC). Connect the LINE OUT jack to your receiver’s l
Inhaltszusammenfassung zur Seite Nr. 11
DIGITAL IN/OUT Terminals Connect the component which has a digital input or output terminal using a digital coaxial cable or an optical cable (neither supplied and available at your local RadioShack store). Insert DIGITAL IN to your component’s output jack (DIGITAL OUT). Connect DIGITAL OUT to your component’s input jack (DIGITAL IN). Notes: When using DIGITAL OPTICAL IN/ OUT terminals, remove the caps from the terminals. When you do not use them, leave the caps in place. Connect eithe
