Bedienungsanleitung Cisco Systems OL-12603-01

Inhaltszusammenfassung zur Seite Nr. 1

CHAPTER9
APC Power Strips
This chapter contains the following sections:
• Setting the APC System BIOS, page 9-1
 Entering the APC Configuration into VFrame GUI, page 9-2
Setting the APC System BIOS
If you are using an APC power strip for power control of the physical servers, use the recommended
system BIOS setting for the physical server. Failure to change this setting appropriately can cause the
server not to boot in some cases.
To set the APC system BIOS, follow these steps:
Step 1 Enter

Inhaltszusammenfassung zur Seite Nr. 2

Chapter 9 APC Power Strips Entering the APC Configuration into VFrame GUI Figure 9-1 APC BIOS Setup Utility Entering the APC Configuration into VFrame GUI Once you have set up APC power for any node, discover the server in VFrame and enter the APC information. This allows the VFrame Director to power on/off the physical server. The addition of physical servers and entry of the power control information is described in the Cisco VFrame InfiniBand Director User Guide. Creating the Ini

Inhaltszusammenfassung zur Seite Nr. 3

Chapter 9 APC Power Strips Entering the APC Configuration into VFrame GUI Step 4 Follow the on-screen prompts to create the initial manager account. After you create the initial manager account, the setup account is deleted and you are logged out of the server. You can then log in using the new manager account, from which you can create other user accounts. Cisco VFrame Third Party Integration Guide OL-12603-01 9-3

Inhaltszusammenfassung zur Seite Nr. 4

Chapter 9 APC Power Strips Entering the APC Configuration into VFrame GUI Cisco VFrame Third Party Integration Guide 9-4 OL-12603-01