Bedienungsanleitung Aube Technologies TH131-15S

Inhaltszusammenfassung zur Seite Nr. 1

TH131-15S & TH133-15S
User Guide
Electronic Thermostat
2.
WARNING
Installation

This thermostat provides fast-cycling control and MUST therefore
be used ONLY with solid-state relays. The use of electromechani-
Control Module
cal relays will result in reduced life expectancy and possibility of
overheating of these devices.
TH131-15S
Pilot wire indicator
Heating indicator
(Europe only)
On/Off switch
Power Base
Temperature
selection dial NOTE: Keep the thermostat's air vents clean and free from o

Inhaltszusammenfassung zur Seite Nr. 2

4. 6. Operation Warranty AUBE TECHNOLOGIES INC. THREE (3) YEAR LIMITED WARRANTY 4.1 Temperature Adjustment Aube warrants this product, excluding battery, to be free from defects TH131-15S in the workmanship or materials, under normal use and service, for a Use the dial on the front of the thermostat to set the desired tempera- period of three (3) years from the date of purchase by the consumer. ture. If at any time during the warranty period the product is determined to be defective or malfunc

Inhaltszusammenfassung zur Seite Nr. 3

PB130-024T Installation Instructions 24-V Low-Voltage Power Base 1. 4.1 Single SSR with Built-in Transformer Applications This document describes the connections when the PB130-024T power base is used on any TH13x-15S series thermostat. When used on a TH13x-15S thermostat, this low-voltage power base must be connected to the line-voltage load using a solid-state relay (SSR). Electrical The PB130-024T is compatible with most solid-state relays; however, Panel Blue Red the following Aube relays a