Inhaltszusammenfassung zur Seite Nr. 1
UNVENTED (VENT-FREE) Gas
MiNi CoMa p CT FiREpla CE
oWNER’s opERa TioN aND iNsT alla TioN MaNU al
Shown with Optional
Cabinet Mantel/Hearth
Base Accessory
MaNUal MoDEls CGMFN aND CGMFp
REMoTE-REaDy MoDEls VGMRN aND VGMRp
WARNING: If the information in this manual is not fol-
lowed exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
— Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any other
applianc
Inhaltszusammenfassung zur Seite Nr. 2
TaBlE oF CoNTENTs Safety Information ............................................... Inspecting Burners............................................. 4 Local Codes......................................................... 4 Cleaning and Maintenance ................................ 4 Unpacking............................................................ 4 Troubleshooting ................................................. 5 Product Identification ........................................... 5 S
Inhaltszusammenfassung zur Seite Nr. 3
saFET y iNFoRMa TioN Fireplace front and screen be- Continued come very hot when running heater. Keep children and adults DANGER: Carbon monoxide away from hot surfaces to avoid poisoning may lead to death! burns or clothing ignition. Fire- Carbon Monoxide Poisoning: Early signs of carbon place will remain hot for a time monoxide poisoning resemble the flu, with head- after shutdown. Allow surfaces aches, dizziness or nausea. If you have these signs, to cool before touching. the firepla
Inhaltszusammenfassung zur Seite Nr. 4
19. To prevent performance problems, do not use saFETy iNFoRMa TioN propane/LP fuel tank of less than 100 lbs. Continued capacity. 6. Do not add extra logs or ornaments such as 20. Provide adequate clearances around air pine cones, vermiculite or rock wool. Using openings. these added items can cause sooting. Do not add lava rock around base. Rock and debris l oCal CoDEs could fall into the control area of fireplace. Install and use fireplace with care. Follow all local 7. This fireplace
Inhaltszusammenfassung zur Seite Nr. 5
ELECTRONIC IGNITOR pR oDUCT (Remote-Ready Models Only) iDENTiFiCa TioN This heater has an electronic ignitor to light heater fuel supply. opTioN al REMo TE CoNTRol aCCEssoRiEs Brick (For Remote-Ready Models Only) Liners There are four optional remote controls that can be purchased separately for Remote-Ready Models only: Screen • wall switch • hand-held ON/OFF remote Log • wall thermostat • hand-held thermostat remote See Accessories, page 34. Control assEMByl Knob Piezo Ignitor WARNI
Inhaltszusammenfassung zur Seite Nr. 6
assEMByl aiR FoR CoMBUsTioN Continued aND VENTila TioN 5. Place hood under top edge of firebox opening. WARNING: This fireplace shall Use 3 screws from hardware kit to mount screen to firebox (see Figure 3). not be installed in a confined space or unusually tight construc- tion unless provisions are provid- ed for adequate combustion and Shoulder ventilation air. Read the following Screw instructions to insure proper fresh air for this and other fuel-burning appliances in your home. T
Inhaltszusammenfassung zur Seite Nr. 7
DETERMINING FRESH-AIR FLOW aiR FoR CoMBUsTioN FOR FIREPLACE LOCATION aND VENTila TioN Continued Determining if You Have a Confined or Unconfined Space Unusually tight construction is defined as Use this work sheet to determine if you have a construction where: confined or unconfined space. a. walls and ceilings exposed to the out- Space: Includes the room in which you will install side atmosphere have a continuous fireplace plus any adjoining rooms with doorless pas- water vapor retarder
Inhaltszusammenfassung zur Seite Nr. 8
aiR FoR CoMBUsTioN aND VENTila TioN 12" Continued Ventilation Grills The space in the example is a confined space because Into Adjoining Room, Ventilation Option 2 the actual Btu/Hr used is more than the maximum Grills Or into Remove Btu/Hr the space can support. You must provide ad- Adjoining Door into Room, Adjoining Option 1 Room, ditional fresh air. Your options are as follows: Option 3 A. Rework worksheet, adding the space of an adjoin- ing room. If the extra space provides an uncon
Inhaltszusammenfassung zur Seite Nr. 9
IMPORTANT: Vent-free fireplaces add moisture iNsTalla TioN to the air. Although this is beneficial, installing fire- NOTICE: This heater is intended place in rooms without enough ventilation air may cause mildew to form from too much moisture. See for use as supplemental heat. Air for Combustion and Ventilation, page 6. Use this heater along with your Note: Your fireplace is designed to be used in zero primary heating system. Do not clearance installations. Wall or framing material inst
Inhaltszusammenfassung zur Seite Nr. 10
Minimum Clearances For Side Combustible iNsTalla TioN Material, Side Wall and Ceiling Continued A. Clearances from the side of the fireplace FIREPLACE CLEARANCES cabinet to any combustible material and wall should follow diagram in Figure 6. WARNING: Maintain the Example: The face of a mantel, bookshelf, minimum clearances shown etc. is made of combustible material and 1 protrudes 3 / " from the wall. This combus- in Figure 6. If you can, provide 2 tible material must be 4" from the side
Inhaltszusammenfassung zur Seite Nr. 11
iNsTalla TioN WARNING: Do not allow any Continued combustible or noncombustible Actual Framing materials to overlap the firebox 3 1 Height 3 /4" /4" front facing. 3 1 Front Width 19 /4" 1 / " Depth 8 /8" 8 /8" WARNING: Do not allow Bottom 0" 0" noncombustible materials to 1. Frame in rough opening. Use dimensions shown cover any necessary openings in Figure 7 for the rough opening. If installing in a corner, use dimensions shown in Figure 8 for like louvered slots. 1 the roug
Inhaltszusammenfassung zur Seite Nr. 12
Pipe and Gas Electrical iNsTalla TioN Hearth Shutoff Valve Outlet Continued Base Mantel Shelf 9" Note: 3" All vertical measurements 1" are from top of 3/4" fireplace opening to Figure 10 - Placing Hearth Base Against Wall bottom of mantel shelf. All measurements are in inches. Cabinet Mantel Side of Firebox Figure 9 - Minimum Mantel Clearances Hearth for Built-In Installation Base OPTIONAL MANTEL INSTALLATION Refer to instructions provided with the mantel for assembly. Refer to
Inhaltszusammenfassung zur Seite Nr. 13
External Regulator iNsTalla TioN Propane/LP Continued Supply Tank CONNECTING TO GAS SUPPLY WARNING: This appliance re- quires a 45° male flare fitting 5/8"- 18 UNF (Unified National Fine Thread) inlet connection and the flexible gas line provided. WARNING: A qualified ser- Vent Pointing Down vice person must connect fire- Figure 13 - External Regulator With Vent place to gas supply. Follow all Pointing Down local codes. CAUTION: Use only new, black iron or steel pipe. Inter- WARNING: Ne
Inhaltszusammenfassung zur Seite Nr. 14
1. Route flexible gas line, included, from fire- iNsTalla TioN place control to equipment shutoff valve Continued through side or rear access holes in outer We recommend that you install a sediment trap in casing (see Figure 1, page 5). supply line as shown in Figure 14. Locate sediment 2. Apply pipe joint sealant lightly to male threads trap where it is within reach for cleaning. Install of gas connector attached to flexible gas line/ in piping system between fuel supply and heater. equi
Inhaltszusammenfassung zur Seite Nr. 15
Test Pressures Equal To or Less Than iNsTalla TioN 1/2 PSIG (3.5 kPa) Continued 1. Close equipment shutoff valve (see Figure 16). CHECKING GAS CONNECTIONS 2. Pressurize supply piping system by either opening propane/LP supply tank valve for WARNING: Test all gas piping propane/LP gas or opening main gas valve and connections, internal and located on or near gas meter for natural gas or using compressed air. external to unit, for leaks after 3. Check all joints from gas meter to equipmen
Inhaltszusammenfassung zur Seite Nr. 16
Receiver iNsTalla TioN Continued PRESSURE TESTING FIREPLACE GAS CONNECTIONS 1. Open equipment shutoff valve (see Figure 16, page 15). 9-Volt Terminal 2. Open main gas valve located on or near gas Battery Wires meter for natural gas or open propane/LP supply tank valve. Battery Clip 3. Make sure control knob of fireplace is in the Figure 20 - Attaching Battery to Receiver OFF position. 4. Check all joints from equipment shutoff valve Red Wire to TH to gas regulator (Manual-Controlled Mod
Inhaltszusammenfassung zur Seite Nr. 17
9. Move the temperature adjustment back and forth iNsTalla TioN to insure the bimetal is free from restrictions. Continued 10. Replace the cover onto the base. (Upon in- OPTIONAL WALL MOUNTED stallation, the thermostat must be allowed to THERMOSTAT - GWMT1 stabilize at room temperature for a minimum (Remote-Ready Models Only) of 30 minutes for proper operation). 11. Set switch on fireplace to Auto position. WARNING: Read and fol- 12. Set the temperature adjustment to the desired low insta
Inhaltszusammenfassung zur Seite Nr. 18
Shoulder Screw iNsTalla TioN Continued Log OPTIONAL WALL SWITCH - GWMS2 (Remote-Ready Models Only) WARNING: Read and fol- low installation instructions. Installation should be done by a qualified installer familiar with low-voltage wiring procedures. Screen WARNING: Do not connect this switch to any electrical Figure 26 - Installing Log and Screen source! Electrical shock and/or fire hazard will occur. oER p a TiNG FiREpla CE MaNUal-CoNTR ollED 1. Connect one terminal of 25 ft. wire to
Inhaltszusammenfassung zur Seite Nr. 19
Note: If pilot does not stay lit, refer to opERa TiNG FiREpla CE Troubleshooting, page 31. Also, contact a Continued qualified service person or gas supplier for D. Do not use this appliance if any part has repairs. Until repairs are made, light pilot been under water. Immediately call a with match. To light pilot with match, see qualified service technician to inspect the Manual Lighting Procedure on page 20. appliance and to replace any part of the 7. Keep control knob pressed in for
Inhaltszusammenfassung zur Seite Nr. 20
C. Use only your hand to push in or turn the opERa TiNG FiREpla CE gas control knob. Never use tools. If the Continued knob will not push in or turn by hand, don’t TO TURN OFF GAS try to repair it, call a qualified service tech- TO APPLIANCE nician or gas supplier. Force or attempted repair may result in a fire or explosion. Shutting Off Fireplace D. Do not use this appliance if any part has Turn control knob clockwise to the OFF been under water. Immediately call a position. qualified
