Inhaltszusammenfassung zur Seite Nr. 1
fr eez er
INSTRUCTION BOOKLET
EUU 1172 / EUU 6174
UK
2222 740-55
Inhaltszusammenfassung zur Seite Nr. 2
CONTENTS Instructions for the User Instructions for the Installer Technical Specifications 13 Important Safety Instructions 3 Installation 13 Operation 5 Positioning 13 Before use 5 Freezer controls 5 Electrical Connection 14 Starting your appliance 5 Temperature control 5 Building-in Instructions 15 Warning light (red) 5 Grid preparation 15 Temperature acoustic alarm 5 Door reversal 15 Freezing fresh food 5 Building the appliance in under a worktop 16 Frozen food storage 6 Fitting the plinth 20
Inhaltszusammenfassung zur Seite Nr. 3
IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation General Safety ¥ Check the appliance for transport damage. Under ¥ This appliance contains hydrocarbons in its no circumstance should a damaged appliance be cooling uni
Inhaltszusammenfassung zur Seite Nr. 4
Servicing ¥ This product should be serviced by an authorised engineer and only genuine spare parts should be used. ¥ Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Service Force Centre. At the end of the Appliance Life ¥ When disposing of your appliance use an autho- rised disposal site. ¥ Remove the plug and ensure that any locks or catches are removed, to pre
Inhaltszusammenfassung zur Seite Nr. 5
OPERATION Before use Remove all securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0.5 litre of water). Do not use soap or deter- gent as the smell may linger. Dry thoroughly. Freezer controls ` ´ ˆ ˜ ¯ ˘ Symbol for audible alarm (temperature warning - Warning light (red) ˆ only for EUU1172) Pilot light (green) ˜ Push button for fast-freezing ` Push button ON/OFF ¯ Fast-freezing indicator light (yellow) ´ Thermostat control knob ˘ Starting your ap
Inhaltszusammenfassung zur Seite Nr. 6
To remove the drawers, proceed as follows: pull the food, the yellow light illuminates. This time can be ´ drawer out until it comes to a stop, then tilt it upwards shortened, depending on the quantity of food to be (see figure). frozen. After the time has elapsed place the food to be frozen in the two top compartments of the freezer as this is the coldest part; if freezing only a small amount of food, always use the top compartment. Once the food is completely frozen (which could take up to 24
Inhaltszusammenfassung zur Seite Nr. 7
HEALTH AND SAFETY GUIDELINES Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever. The following tips should help you to ensure that the food in your home is in as perfect condition as possible. ¥ Keep the freezer door closed as much as possible. ¥ The size of each pack should be small enough to ensure that it
Inhaltszusammenfassung zur Seite Nr. 8
DEFROSTING The freezer compartment will become progressively Important covered with frost. This should be removed with the In the event of a power failure causing t h e special plastic scraper provided, whenever the thick- temperature within your freezer to rise, do ness of the frost exceeds 1/4". not re-freeze the food without checking its condition. The following guidelines should During this operation it is not necessary to switch off assist you: the power supply or to remove the foodstuffs.
Inhaltszusammenfassung zur Seite Nr. 9
MAINTENANCE AND CLEANING Warning Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. Important This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by autho- rised technicians. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0.5 litre of water). Rinse and dry thoroughly. NEVER USE DETERGENTS, ABRASIVE POW- DERS, HIGHLY PERF
Inhaltszusammenfassung zur Seite Nr. 10
SOMETHING NOT WORKING? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to the appliance - Check there is power at the socket. - Check there is not a power cut by checking the house- hold lights. - Check the fuse has not blown. The temperature in the free
Inhaltszusammenfassung zur Seite Nr. 11
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if When you contact the Service Force Centre you will you wish to purchase spare parts, please contact your need to give the following details: local Service Force Centre by telephoning:- 1. Your name, address and post code 2. Your telephone number 08705 929929 3. Clear and concise details of the fault Your telephone call will be automatically routed to the 4. The model and serial number of the appliance Service Force C
Inhaltszusammenfassung zur Seite Nr. 12
GUARANTEE CONDITIONS Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: • The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. • The appliance has
Inhaltszusammenfassung zur Seite Nr. 13
TECHNICAL SPECIFICATIONS DIMENSIONS Height 81,5 cm Width 59,6 cm Depth 54 cm POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 90 W AVERAGE DAILY UNITS ELECTRICITY(*) 0,78 kWh GROSS CAPACITY 108 l NET CAPACITY 100 l STAR RATING (*)This figure is based on standard test results in accordance with European Standard EN153. Actual con- sumption will depend on how the appliance is used and where it is located. INSTALLATION Positioning This appliance should only be installed at
Inhaltszusammenfassung zur Seite Nr. 14
ELECTRICAL CONNECTION If you fit your own plug, the colours of the wires in the WARNING mains lead of your appliance, may not correspond THIS APPLIANCE MUST BE EARTHED. with the markings identifying the terminals in your The manufacturer declines any liability plug, proceed as follows: should this safety measure not be Connect the Green and the Yellow (earth) wire to the observed. terminal in the plug which is marked with the letter If the plug that is fitted to your appliance is not suitable «E
Inhaltszusammenfassung zur Seite Nr. 15
BUILDING-IN INSTRUCTIONS Before carrying out any work, remove the plug from the power socket. Grid preparation Left door opening: A Remove the left side (A) of the grid cutting it from the rear (see figure). B Right door opening: Remove the right side (B) of the grid cutting it from the rear (see figure). DO002/2 To position the grid on the appliance proceed as fol- lows: a Apply the grid to the base of the appliance by pushing on to the clasps (a) until they click. a DO001 Door reversal To reve
Inhaltszusammenfassung zur Seite Nr. 16
600 550 min. Attention After completion of the door reversing opera- 10 tion, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to 13 the cabinet. In that case, wait for the natural fit- ting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting. 9 12 11 3 Building the appliance in under a worktop 1. The dimensions of the recessed installation area mu
Inhaltszusammenfassung zur Seite Nr. 17
596 3. Two cabinet securing brackets are supplied with the installation pack. They need to be assembled onto the cabinet prior to cabinet being pushed into the Kitchen aperture. - To fit these brackets remove the two screws at the top left and right hand front corners of the cabinet. - Position the two brackets as shown in the figure and replace the two securing screws. Left hand Right hand bracket bracket 1/a 4. Push the appliance into place. The plug socket necessary for connection of the appl
Inhaltszusammenfassung zur Seite Nr. 18
10 7. Screw appliance into place and retain the cabinet with screws through the securing brackets into the worktop or adjacent woodwork as necessary. 5 8. To mount the furniture door proceed as shown in the figures: 2 1 a C 4 3 b 6 ab C clic C clic c 7 8 18
Inhaltszusammenfassung zur Seite Nr. 19
10 UPPER PART OF KITCHEN FURNITURE PANEL 1 a LOWER PART OF KITCHEN FURNITURE PANEL 2 275 275 b 9/a 9 1 2 45 ° = 3 = 11 10 12 19 max 100 = =
Inhaltszusammenfassung zur Seite Nr. 20
25 - 80 9. Refit the covering strip. A 13 Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. ¥ For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. ¥ For plinth heights greater than a=100 mm, b=150 mm, a cut should be made in the plinth, 580 m
