Bedienungsanleitung Casio 2861

Inhaltszusammenfassung zur Seite Nr. 1

|
l
|
l
|
l
|
|
l






|
l
|
|
l
|
l
MO0312-EA
Operation Guide 2858 2859 2860 2861
Getting Acquainted
Congratulations upon your selection of this CASIO watch. To get the most out of your
About This Manual
purchase, be sure to carefully read this manual and keep it on hand for later reference
• The operational procedures for Modules 2858, 2859, 2860, and 2861 are identical.
when necessary.
All of the illustrations in this manual show Module 2858/2859.
• Button operations are indicated using the

Inhaltszusammenfassung zur Seite Nr. 2

Operation Guide 2858 2859 2860 2861 • Signal reception is normally better at night than during the day. Signal Receive Troubleshooting • Time calibration signal reception takes from two to five minutes, but in some cases it Check the following points whenever you experience problems with calibration signal can take as long as 12 minutes. Take care that you do not perform any button reception. operations or move the watch during this time. Problem Probable Cause What you should do Cannot perform

Inhaltszusammenfassung zur Seite Nr. 3

l l l l
l l l Operation Guide 2858 2859 2860 2861 To delete all Time Recorder times To measure times with the stopwatch 1. Enter the Time Recorder Mode. 2. Hold down A for about two seconds to delete all Time Recorder times. Elapsed Time • The recorded date and recorded time are replaced by dashes (x) when there are no Time Recorder times currently in memory. D ➤D ➤D ➤D ➤B Start Stop Re-start Stop Clear Alarms Split Time The Alarm Mode gives you a choice of four one-time D ➤B ➤B ➤D ➤B Alarm nu

Inhaltszusammenfassung zur Seite Nr. 4

Operation Guide 2858 2859 2860 2861 Important! Daylight Saving Time (DST) • Storing the watch for long periods in an area where there is no light or wearing it in Daylight Saving Time (summer time) advances the time setting by one hour from such a way that it is blocked from exposure to light can cause rechargeable battery Standard Time. Remember that not all countries or even local areas use Daylight power to run down. Be sure that the watch is normally exposed to bright light Saving Time. when

Inhaltszusammenfassung zur Seite Nr. 5

| | | | | | | | | |


| | | | | | | | | Operation Guide 2858 2859 2860 2861 Recovery Times Module 2859 and 2861 The table below shows the amount exposure that is required to take the battery from In this case: The watch does this: one level to the next. The first signal auto search operation 1. Checks the Rugby signal first. Exposure Level Approximate Exposure Time after factory default settings are in effect, 2. If the Rugby signal cannot be received, (Brightness) or after the city code ha

Inhaltszusammenfassung zur Seite Nr. 6

Operation Guide 2858 2859 2860 2861 Backlight Precautions • The electro-luminescent panel that provides illumination loses power after very long use. • The illumination provided by the backlight may be hard to see when viewed under direct sunlight. • The watch may emit an audible sound whenever the display is illuminated. This is due to vibration of the EL panel used for illumination, and does not indicate malfunction. • The backlight automatically turns off whenever an alarm sounds. • Frequent