Inhaltszusammenfassung zur Seite Nr. 1
ZANUSSI
User
Manual
Washing
Machine
ZWG1100M
ZWG1120M
ZWG1140M
Inhaltszusammenfassung zur Seite Nr. 2
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _2 _ _ _ _ _ Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ 13 _ _ _ _ _ Product description _ _ _ _ _ _ _ _ _ _ _ _ 4 _ _ _ _ _ What to do if ... _ _ _ _ _ _ _ _ _ _ _ _ _ _ 15 _ _ _ _ Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ 17 _ _ _ _ _ Control Panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 _ _ _ _ Washing programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7-8 Installation
Inhaltszusammenfassung zur Seite Nr. 3
ZANUSSI • All packing and transit bolts must be removed If volatile cleaning fluids are used, care should be taken to ensure that the fluid is removed from the before use. Serious damage can occur to the product and to property if this is not adhered to. garment before placing in the machine. See relevant section in the user manual. • Never pull the power supply cable to remove the • After having installed the appliance, check that it is plug from the socket; always take hold of the plug not sta
Inhaltszusammenfassung zur Seite Nr. 4
Product description The detergent The control panel compartment Quick Guide 1. Install the washing machine 2. Load the laundry 3. measure out the detergent Door handle Basket 4. Close the machine door 5. Put down (hang up) the drain pipe 6. Turn on the water tap 7. Plug the power supply 8. Select the desired programme 9. Press the [start/pause] key Service panel Filter door «MAX» Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used duri
Inhaltszusammenfassung zur Seite Nr. 5
ZANUSSI Control panel 1 1 2 3 4 9 8 7 6 5 1 6 Display DELAY START button 2 7 OPTIONS button SPIN button 3 8 Programme selector dial TEMPERATURE button 4 9 START/PAUSE button SOIL LEVEL button 5 ADDITIONAL CHILD LOCK button Display START/PAUSE button • The corresponding lights (pre wash, washing, • «Start/Pause» button, has the start and pause rinse, spin) will flash when the washing proceeds function. When this button is pressed continuously, to each step during the washing process. this machine
Inhaltszusammenfassung zur Seite Nr. 6
Additional child lock. • There is an additional, selectable child safety feature. To select it, press button 5 for three seconds. The Child Lock button also locks the Start/Pause button. An English text and the image of the head of a child appear in the display when the lock is activated. You can now also press the Pause button without anything happening. There will just be an error beep. When the programme has finished, the door can be opened, but to select the next wash you need to press the C
Inhaltszusammenfassung zur Seite Nr. 7
Hygene ZANUSSI Washing Programmes for ZWG1100M-ZWG1120M 7 Fabric Detergent box Maximum Clothes to be Maximum spin speed The maximum washing Default temperature Extra Rinse Pre-Wash RPM capacity (kilogram) operation time washed (suggestion) (Centigrade) Pre-wash Main wash Cycle I II Softener Cottons Optional Optional Ordinary clothes 95 1000 1200 6 1:23 Quick Optional Non-optional Quick Lightly Soiled 40 1000 1200 3 0:23 X Comparatively thick Optional Optional Cottons 95 1000 1200 6 2:47 clothes
Inhaltszusammenfassung zur Seite Nr. 8
Hygene Washing Programmes for ZWG1140M 8 Fabric Detergent box Maximum Clothes to be Maximum spin speed The maximum washing Default temperature Extra Rinse Pre-Wash RPM capacity (kilogram) operation time washed (suggestion) (Centigrade) Pre-wash Main wash Cycle I II Softener Cottons Optional Optional Ordinary clothes 95 1400 6 1:24 Quick Optional Non-optional Quick Lightly Soiled 40 1400 3 0:24 X Comparatively thick Optional Optional Cottons 95 1400 6 3:05 clothes Optional Non-optional Wool Woole
Inhaltszusammenfassung zur Seite Nr. 9
ZANUSSI Helpful hints and tips Sorting out the laundry Ink: depending on the type of ink, moisten the fabric Follow the wash code symbols on each garment label first with acetone*, then with acetic acid; treat any and the manufacturer’s washing instructions. Sort the residual marks on white fabrics with bleach and then laundry as follows: whites, coloureds, synthetics, rinse thoroughly. delicates, woollens. Tar stains: first treat with stain remover, methylated Before loading the laundry spirits
Inhaltszusammenfassung zur Seite Nr. 10
Degrees of water hardness Water hardness is classified in so-called «degrees» of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your local authority. If the water hardness degree is medium or high we suggest you use a water softener, following the manufactures instructions. When the degree of hardness is soft, re-adjust the quantity of the detergent. First Use • Ensure that the electrical and water connections • Run a c
Inhaltszusammenfassung zur Seite Nr. 11
ZANUSSI Daily Use Load the laundry With this button you can select an additional Prewash Open the door by or an additional Rinse or both. carefully pulling the door When this button is pressed, the corresponding pilot handle outwards. Place light illuminates. When it is pressed again, the pilot the laundry in the drum, light goes out. one item at a time, Start the programme by pressing button 4 shaking them out as much To start the selected programme, press this button. as possible. Close the Th
Inhaltszusammenfassung zur Seite Nr. 12
Cancelling the Delay Start after having started the 3. Reduce the spin speed if needed, by pressing the programme: relevant button. 4. Press button 4. 1. Set the washing machine to PAUSE by pressing At the end of the programme, the door is released, button 4. 2. Press button 6repeatedly until the display shows 0'. after few minutes, and can be opened. Turn the 3. Press button 4 again to start the programme. programme selector dial toO to switch the machine Important! off. • The door will be lock
Inhaltszusammenfassung zur Seite Nr. 13
ZANUSSI Care and cleaning Warning! You must DISCONNECT the appliance Cleaning the pump from the electricity supply, before you can carry Important! out any cleaning or maintenance work. According to the soil level within the cycles and the Descaling frequency of the cycles, you have to inspect and The water we use normally contains lime. It is a good clean the filter regularly. idea to periodically use a water softening powder in The pump should be inspected if: the machine. • the machine does n
Inhaltszusammenfassung zur Seite Nr. 14
If you wash rugs, it is compulsory to inspect and Frost precaution or emergency emptied out clean the filter. If the machine is exposed to temperatures below 0°C or if the water is not discharged, proceed as follows. Cleaning the water inlet filters 1 Pull out the plug from the power socket. Important! 2 Turn off the water tap. If the appliance doesn't fill, takes long to fill with water, 3 Unscrew the inlet hose. the starting button blinks yellow or the display (if 4 Place a bowl on the floor a
Inhaltszusammenfassung zur Seite Nr. 15
ZANUSSI What to do if..... Certain problems are due to lack of simple Before contacting your local Service Centre, please maintenance or oversights, which can be solved carry out the checks listed below. easily without calling out an engineer. Malfunction Possible Cause / Solution Close the washing machine's door. The washing machine does not work Press the▽Start/Pause▼key. Water leakage Correctly connect the inlet water pipe. The spin of the clothes is abnormal Reload and distribute the la
Inhaltszusammenfassung zur Seite Nr. 16
Malfunction Possible Cause / Solution Check if the amount of detergent is excessive, if it is the specialized detergent for the drum Foam spills from the detergent washing machine. drawer Dip one scoop of the softener mixed with 1/2 liter of water to the detergent box II. Reduce the amount of detergent used next time. The machine stops when the proce- Power failure or water cut. dure has not been finished The water inside the inner barrel has been drained The drainage pump is noisy during bu
Inhaltszusammenfassung zur Seite Nr. 17
ZANUSSI If you are unable to identify or solve the problem, contact our service centre. Before telephoning, make a note of the model, serial number and purchase date of your machine. The Service Centre will require this information. Technical data Rated Mains 2 0-240 V 2 / 50Hz Wash power 150W Spin power 360W 495mm 948mm Heat power 2000W Max. Power 2150W Water pressure 0.02MPa~1MPa Net weight 65Kg 855mm Drain method Upper drain Spin method Centrifugal Washing capacity 6Kg Maxinum spin speed rpm
Inhaltszusammenfassung zur Seite Nr. 18
Installation Unpacking Accurate levelling prevents vibration, noise and displacement of the machine during operation. Never All transit bolts and packing must be removed before place cardboard, wood or similar materials under the using the appliance. machine to compensate for any unevenness in the You are advised to keep all transit devices so that floor. they can be refitted if the machine ever has to be transported again. Unscrew the four bolts using a spanner. Slide out the relevant plastic s
Inhaltszusammenfassung zur Seite Nr. 19
ZANUSSI Caution! The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. Water drainage The end of the drain hose can be positioned in three ways: In a sink drain pipe branch. Hooked over the edge This branch must be above the trap so that the bend of a sink using the is at least 60 cm above the ground. plastic hose guide supplied with the Directly into a drain pipe at a h
Inhaltszusammenfassung zur Seite Nr. 20
ZANUSSI www.electrolux.com www.zanussi.be Subject to change without notice
