Inhaltszusammenfassung zur Seite Nr. 1
Notice
The information in this guide is subject to change without notice.
COMPAQ COMPUTER CORPORATION SHALL NOT BE LIABLE
FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS
CONTAINED HEREIN; NOR FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES RESULTING FROM THE
FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL.
This guide contains information protected by copyright. No part of this
guide may be photocopied or reproduced in any form without prior
written consent from Compaq Computer Corporation.
© 1997 Compaq
Inhaltszusammenfassung zur Seite Nr. 2
book 1 ENGLISH The Compaq V55 Color Monitor is a microprocessor-based, Introduction intelligent scanning monitor that automatically locks in on the most common display modes. This monitor operates most efficiently when used with a Compaq compatible graphics controller. The monitor features include the following: Product Features ■ 15-inch CRT with a 13.7-inch (34.7 cm) diagonal viewable image size ■ Easy-to-access front panel controls ■ Universal Serial Bus (USB) pass-through connectors for u
Inhaltszusammenfassung zur Seite Nr. 3
■ Plug and play capability if supported by your system ■ Tilt control (image rotation) functionality ■ Automatically scans all horizontal frequencies from 30 to 60 kHz and vertical frequencies from 47.5 to 125 Hz ■ Supports VGA, Super VGA, and 1024 × 768 resolutions ■ Energy Saver feature, when activated, results in a power savings of greater than 90 percent ■ Macintosh-compatible timing with optional connector ■ Compliant with the following regulated specifications: ❏ Swedish MPR II 1990 ❏ EPA
Inhaltszusammenfassung zur Seite Nr. 4
■ You can purchase backup diskettes from your Compaq authorized reseller, dealer or service provider. If you choose to purchase the Support Software CD, you have two options: ■ You can purchase a single CD-ROM that gives you one- time access to the latest support software (North America only, Compaq part number 272505-001). ■ You can purchase a yearly subscription that delivers up to 12 monthly CD-ROMs (Compaq part number 183426-xxx). The annual subscription ensures your continuous access to the
Inhaltszusammenfassung zur Seite Nr. 5
To set up the monitor, ensure that the power is turned off to the Setting Up the monitor, computer system, and other attached devices, then Monitor follow these steps: 1. Place the monitor in a convenient, well-ventilated location near your computer. 2. Connect the monitor signal cable 1 to the 15-pin connector on the rear panel of the computer and tighten the screws. Be sure the signal cable aligns with the 15-pin connector. Do not ✎ force the cable onto the connector or you may damage the si
Inhaltszusammenfassung zur Seite Nr. 6
USB Connectors The base of the monitor has two Universal Serial Bus (USB) connectors. Use connector to connect the USB signal cable ❶ to the computer. Use connector to connect USB compatible ❷ plug and play devices such as a keyboard, mouse, or joystick if supported by your computer. This feature provides USB pass- through and does not support USB host requirements. CAUTION: This USB connector is not designed for use with high speed USB devices such as a video camera, scanner, etc. Compaq re
Inhaltszusammenfassung zur Seite Nr. 7
Operating the Monitor Front Panel Controls No./Icon Control Function Horizontal Position Moves screen left or right. 1 Vertical Position Moves screen up or down. 2 Horizontal Size Adjusts the horizontal screen width. 3 Vertical Size Adjusts the vertical screen height. 4 Minus Controls degree of adjustment to functions. 5 Plus Controls degree of adjustment to functions. 6 Pincushion Straightens vertical lines if the picture has 7 pincushion or barrel distortion. Trapezoid Corrects trapezoid dist
Inhaltszusammenfassung zur Seite Nr. 8
Front Panel Controls Continued No./Icon Control Function Contrast Adjusts screen contrast. : Power LED 1. Green indicates monitor is turned on. ; 2. Amber indicates energy saver levels. < Power switch Turns the monitor on and off. Setting Contrast and Brightness controls to their maximum ✎ settings may cause the screen to appear out of focus. To correct this appearance, decrease the Brightness setting. To adjust screen controls, complete the following procedures: 1. Press the desired control f
Inhaltszusammenfassung zur Seite Nr. 9
Dual Function Controls Some controls have dual functions and, when pressed in pairs, will adjust alternate screen functions. The following table identifies which controls to press together to adjust a particular function. Dual Function Controls Icon Control Function Parallelogram Corrects a display that is leaning left or right. + V-linearity Corrects a compressed display look at the top + or bottom of the screen. Pinbalance Adjusts sides of the display when they are + bowed toward left or right
Inhaltszusammenfassung zur Seite Nr. 10
Allow the monitor to warm up for 30 minutes before Adjusting the performing the following procedures. The screen image Monitor Screen stabilizes after a warm-up period. Optimizing Contrast For best results, set your screen to a dark background (such as the DOS prompt) before adjusting the following settings: 1. Set the brightness and contrast controls to their lowest settings. 2. Increase brightness until the background portions of the screen are visible, then slowly reduce brightness until the
Inhaltszusammenfassung zur Seite Nr. 11
The resolution settings listed below are the most commonly Display Resolutions used modes and are set as factory defaults. The monitor Default Settings automatically recognizes these preset modes as they are requested by a software program. Display Resolutions Preset Modes Resolutions 1. VESA 1024 × 768 at 60.0 kHz/75 Hz 2. VESA 1024 × 768 at 48.4 kHz/60 Hz 3. VESA 800 × 600 at 53.7 kHz/85 Hz 4. VESA 800 × 600 at 46.9 kHz/75 Hz 5. VESA 800 × 600 at 37.8 kHz/60 Hz 6. VGA 720 ×
Inhaltszusammenfassung zur Seite Nr. 12
The energy saver feature has three different modes of Energy Saver operation: Feature ■ Full power mode ■ Suspend mode ■ Sleep mode By selecting settings in the computer's Energy Saver utility, you determine the length of inactivity before the monitor goes into suspend or sleep mode. The following table describes the monitor energy saver levels available during the different modes of operation. Energy Saver Levels Mode Power Usage Description Full Power Less than ON = Normal operation
Inhaltszusammenfassung zur Seite Nr. 13
This section explains how to care for and maintain your Care and Compaq monitor during normal everyday use. Maintenance Protecting the Monitor To protect your monitor from overheating and other types of damage, follow these suggestions: ■ Use only a power source and connection appropriate for this monitor, as indicated on the marking label/back plate. ■ If an extension cord or power strip is used, make sure that the cord or strip is rated for the product and that the total ampere ratings of all
Inhaltszusammenfassung zur Seite Nr. 14
■ Keep the monitor in a well-ventilated area, away from excessive light, heat, and moisture. Keep the monitor away from high capacity transformers, electric motors, and other strong magnetic fields. ■ Do not open the monitor cabinet or attempt to service this product yourself. Adjust only those controls that are covered by the operating instructions. If the monitor is not operating properly or has been dropped or damaged, contact your Compaq authorized dealer, reseller, or service provider. Clea
Inhaltszusammenfassung zur Seite Nr. 15
appendix AGENCY REGULATORY NOTICES This equipment has been tested and found to comply with the Federal limits for a Class B digital device, pursuant to Part 15 of the Communications FCC Rules. These limits are designed to provide reasonable Commission Notice protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
Inhaltszusammenfassung zur Seite Nr. 16
Declaration of Conformity for Products Marked with FCC Logo, United States Only This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. For questions regarding this declaration, contact: Compaq Computer Corporation P.O. Box 692000, Mail Stop 510101 Houston, Texas 77269-2000 Or c
Inhaltszusammenfassung zur Seite Nr. 17
European Notice Products with the CE Marking comply with both the EMC Directive (89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European norms: ■ EN55022 (CISPR 22) - Radio Frequency Interference ■ EN50082-1 (IEC801-2, IEC801-3, IEC801-4) - Electromagnetic Immunity ■ EN60950 (IEC950) - Product Safety Japanese Notice Specifications 1-17 Writer: M. Silvetti Saved b
Inhaltszusammenfassung zur Seite Nr. 18
SPECIFICATIONS Compaq V55 Color Monitor Display 15-in FS CRT 38.1 cm Viewable Image Size (diagonal) 13.7-in 34.7 cm Screen Treatment Silica antiglare/antistatic coating Approximate Weight (Unpacked) 27.9 lb 12.7 kg Maximum Dimensions Width 14.6-in 36.9 cm Depth 15.6-in 39.3 cm Height 17.1-in 43.3 cm Maximum Graphics Resolution 1024 × 768 at 75 Hz Refresh Rate Text Mode VGA or higher Phosphor/Dot Pitch P22, 0.28 mm Horizontal Frequency 30 to 60 kHz Vertical Frequency 47.5 to 125 Hz Envir
Inhaltszusammenfassung zur Seite Nr. 19
Connector Pin Assignments Signal Cable Connector Pin Signal 1 Red Video 2 Green Video/Sync on Green 5 4 3 2 1 10 KEY 8 7 6 15 14 13 12 11 3 Blue Video 4 Ground 5 Return 6 Red Gnd 7 Green Gnd 8 Blue Gnd 9 Reserved (No Pin) 10 Sync Gnd 11 Ground 12* Bidirectional Data (SDA) 13 H-Sync 14 V-Sync24 15* Data Clock (SCL) * DDC Signals Color Display Values CIE* Chromaticity Coordinates XY 0.620 0.350 Red 0.305 0.600 Green 0.155 0.065 Blue 0.281 (+/- .015) 0.311 (+/- .015) White Point
Inhaltszusammenfassung zur Seite Nr. 20
The monitor power supply is provided with Automatic Line Power Cord Set Switching (ALS). This feature allows the monitor to operate on Requirements input voltages between 100-240 VAC. The power cord set (flexible cord or wall plug) received with the monitor meets the requirements for use in the country where you purchased the equipment. Power cord sets must meet the requirements of the country where you use the monitor. For more information on power cord set requirements, contact your Compaq aut
