Inhaltszusammenfassung zur Seite Nr. 18
Operations in the Picture-in-picture mode Selecting the input signals to be displayed 1. Press the ACTIVE SELECT button to make the desired To move the position of the sub screen, press the cursor picture active. or button. 2. Press the PC/RGB, VIDEO1, 2 or DVD/HD1, 2, 3, 4 button to change the selection of the input signal. button PC/RGB VIDEO1 A PC/RGB VIDEO1 A The INPUT/EXIT button on the monitor can also be used B B to change the selection. button Top Left Top Right Zooming in on a
Inhaltszusammenfassung zur Seite Nr. 19
OSM (On Screen Menu) Controls Menu Operations Information The following describes how to use the menus and the Advanced menu mode selected items. When “ADVANCED OSM” is set to “ON” in the 1. Press the MENU/ENTER button on the remote control to FUNCTION menu, full menu items will be shown. display the MAIN MENU. PICTURE MAIN MENU PICTURE MEMORY : OFF CONTRAST : 52 PICTURE SET UP BRIGHTNESS : 32 SHARPNESS : 16 AUDIO FUNCTION COLOR : 32 TINT R G : 32 IMAGE ADJ. SIGNAL INFO. NR : OFF COLOR TEM
Inhaltszusammenfassung zur Seite Nr. 20
Menu Tree : Shaded areas indicate the default value. ←→: Press the or button to adjust. : Menu items in a ruled box are available when the ADVANCED OSM is set to ON. Main menu Sub menu Sub menu 2 Sub menu 3 Sub menu 4 RESET REFERENCE PICTURE PICTURE MEMORY OFF/MEMORY1-6 YES 23 CONTRAST ←→ 0←52→72 YES 23 BRIGHTNESS ←→ 0←32→64 YES 23 SHARPNESS ←→ 0←16→32 YES 23 COLOR ←→ 0←32→64 YES 23 TINT R←→G 0←32→64 YES 23 NR OFF/NR-1/NR-2/NR-3 YES 23 COLOR TEMP. LOW/MIDDLE LOW/MIDDLE/
Inhaltszusammenfassung zur Seite Nr. 1
Model PD5001 User Guide
Plasma Monitor
Page 1 06.9.7, 4:41 PM
Inhaltszusammenfassung zur Seite Nr. 2
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. (Additional Safety Information) 2. Keep these instructions. 15. This product may contain lead or mercury. Disposal of 3. Heed all warnings. these materials may be regulated due to environmental 4. Follow all instructions. considerations. 5. Do not use this apparatus near water. For disposal or recycling information, please contact your 6. Clean only with a dry cloth. local authorities or the Electronic Indu
Inhaltszusammenfassung zur Seite Nr. 3
PRÉCAUTIONS IMPORTANTES DE SÉCURITÉ A lire avant de faire fonctionner l’appareil 1. Lire ces instructions. (Informations de Sécurité Supplémentaires) 2. Garder ces instructions. 15. Ce produit peut contenir un plomb ou du mercure. La 3. Respecter tous les avertissements. mise à rebut de ces matières pourrait être réglementée 4. Suivre toutes les instructions. pour des raisons de protection de l’environnement. Pour 5. Ne pas utiliser cet appareil près de l’eau. s’informer sur la mise à rebut ou l
Inhaltszusammenfassung zur Seite Nr. 4
Important Information To avoid damage and prolong operating life: Precautions 1. Use only with 100 V to 240 V 50 Hz/60 Hz AC power supply. Continued Please read this manual carefully before using your plasma monitor and operation at line voltages greater than 100 V to 240 V AC will shorten keep the manual handy for future reference. the life of the unit, and might even cause a fire hazard. 2. Handle the unit carefully when installing it and do not drop. CAUTION 3. Set the unit away from h
Inhaltszusammenfassung zur Seite Nr. 5
Recommandations importantes Pour éviter tout dommage et assurer une utilisation durable: Précaution 1. Utiliser seulement une alimentation en courant de 100 V à 240 V 50 Hz/60 Hz. Veuillez lire avec attention ce manuel avant d’utiliser le moniteur à plasma Toute utilisation prolongée avec un courant supérieur à 100 V à 240 V risque et le conserver accessible pour s’y référer ultérieurement. de diminuer la durée de vie de l’appareil et même de provoquer un incendie. 2. Manipuler l’appareil avec p
Inhaltszusammenfassung zur Seite Nr. 6
Important Information Warning Caution Not for use in a computer room as defined in the This model is for use with the following optional Standard for the Protection of Electronic Computer/ accessories. Use with other optional accessories is Data Processing Equipment ANSI/NFPA 75. capable of resulting in instability causing possible injury. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Manufacturer’s name: D&M Holdings Inc. Part 15 o
Inhaltszusammenfassung zur Seite Nr. 7
Recommandations importantes Avertissement Attention Ne pas utiliser dans une salle d’ordinateurs telle que Ce modèle peut être utilisé avec les accessoires définie dans la Norme pour la protection des ordinateurs optionnels suivants. L’utilisation de ce modèle avec électroniques/appareils de traitement des données d’autres accessoires optionnels peut entraîner une ANSI/NFPA75. instabilité qui peut causer des blessures. Nom du fabricant : D&M Holdings Inc. Cet appareil a été testé est trouvé conf
Inhaltszusammenfassung zur Seite Nr. 8
Contents Checking the signal being transmitted to PC/RGB terminal ... 27 IMPORTANT SAFETY INSTRUCTIONS ..................... 1 Setting high definition images to the suitable screen size ... 27 PRÉCAUTIONS IMPORTANTES DE SÉCURITÉ ........... 2 Setting a computer image to the correct RGB select screen ... 27 Important Information...................................... 3 Setting the black level for HDMI signal .......................... 28 Recommandations importantes ......................... 4 Sett
Inhaltszusammenfassung zur Seite Nr. 9
Installation You can attach your optional mounts or stand to the plasma monitor in one of the following two ways: * While it is upright. (See Drawing A) * As it is laid down with the screen face down (See Drawing B). Lay the protective sheet, which was wrapped around the monitor when it was packaged, beneath the screen surface so as not to scratch the screen face. * Do not touch or hold the screen face when carrying the unit. • This device cannot be installed on its own. Be sure to use a stand o
Inhaltszusammenfassung zur Seite Nr. 10
2.Align the batteries according to the and Cable Management indication inside the case. Using the cable clampers and beads bands provided with the plasma display; Bundle the signal and audio cables at the back of the unit to connect to the display. 3.Replace the cover. PD5001 Back of the unit mounting holes Operating Range * Use the remote control within a distance of about 7 m/ 23 ft. from the front of the monitor’s remote control sensor and at horizontal and vertical angles of up to approxi
Inhaltszusammenfassung zur Seite Nr. 11
Part Names and Function Front View MENU VOLUME INPUT /EXIT ON/STANDBY MENU VOLUME INPUT/EXIT ON/STANDBY 7 6 5 4 1 3 2 q Power t and Turns the monitor’s power on and off. Enlarges or reduces the image. Functions as the CURSOR ( / ) buttons in the On-Screen Menu w Remote sensor window (OSM) mode. Receives the signals from the remote control. y VOLUME and e ON/STANDBY indicator Adjusts the volume. Functions as the CURSOR (/ When the power is on ............................. Lights gre
Inhaltszusammenfassung zur Seite Nr. 12
Rear View/ Terminal Board PD5001 L VIDEO AUDIO1 DVD/HD1 AUDIO2 DVD/HD2 PC/RGB AUDIO 3 DVD/HD3 DVD/HD4 EXTERNAL CONTROL REMOTE L/R Y Cb/Pb Cr/Pr L/R Y Cb/Pb Cr/Pr L/R IN OUT BA D VIDEO AUDIO1 DVD/HD1 AUDIO2 DVD/HD2 PC/RGB AUDIO 3 DVD/HD3 DVD/HD4 EXTERNAL CONTROL REMOTE 1 R R R HDMI HDMI 2 Y Cb/Pb Cr/Pr Y Cb/Pb Cr/Pr IN OUT L (MONO) L ( ) ( ) MONO L MONO CE F G H I JK A AC IN I EXTERNAL CONTROL (D-Sub) Connect the included power cord here. This terminal is used when operating and controlling the m
Inhaltszusammenfassung zur Seite Nr. 13
i MUTE Remote Control Mutes the audio. o VOLUME (+ /–) Adjusts the audio volume. !0 ZOOM (+ /–) Enlarges or reduces the image. !1 SINGLE Cancels the split screen mode. !2 SIDE BY SIDE Press this button to show a couple of pictures in the side-by-side mode. !3 PICTURE IN PICTURE Press this button to show a couple of pictures in the picture-in-picture mode. !4 ACTIVE SELECT Press this button to make the desired picture activate during split screen mode. When the PICTURE FREEZE function is operatin
Inhaltszusammenfassung zur Seite Nr. 14
Basic Operations POWER OFF TIMER To turn the unit ON and OFF: To set the off timer: The off timer can be set to turn the power off after 30, 60, 1. Plug the power cord into an active AC power outlet. 90 or 120 minutes. 2. Press the Power button (on the unit). 1. Press the OFF TIMER button to start the timer at 30 The monitor’s ON/STANDBY indicator turns red and the minutes. standby mode is set. 2. Press the OFF TIMER button to the desired time. 3. Press the POWER ON button (on the remote control
Inhaltszusammenfassung zur Seite Nr. 15
WIDE Operations The picture is expanded in the horizontal and vertical Wide Screen Operation (manual) direction, maintaining the original proportions. With this function, you can select one of seven screen sizes. * Use this for theater size (wide) movies, etc. When viewing videos or digital video discs 2.35:1 size screen 1. Press the WIDE button on the remote control. 2. Within 3 seconds ... Press the WIDE button again. The screen size switches as follows: → NORMAL → ANAMORPHIC → STADIUM → ZOO
Inhaltszusammenfassung zur Seite Nr. 16
Wide Screen Operation with Information Computer Signals Supported resolution Switch to the wide screen mode to expand the 4 : 3 image See page 39, 42 and 45 for details on the display output to fill the entire screen. of the various VESA signal standards supported by the 1.Press the WIDE button on the remote control. monitor. When 852 (848) dot 480 line wide VGA* 2.Within 3 seconds ... signals with a vertical frequency of 60 Hz and Press the WIDE button again. horizontal frequency of 31.7
Inhaltszusammenfassung zur Seite Nr. 17
SPLIT SCREEN Operations Operations in the Side-by-side mode Showing a couple of pictures on the screen at the same time To change the picture size, press the cursor or button. * There may be some RGB-input signals that may not be displayed as not all signals are supported. button button VIDEO1 PC/RGB VIDEO1 PC/RGB VIDEO1 PC/RGB 1. Press the button to select a screen mode from among single A AB B B A mode, side-by-side, and picture-in-picture. button button Side-by-Side2-R Side-b
