Manual de instrucciones de Havis-Shields Slide-Out Trunk Tray 2006-2008 Chevrolet Impala C-3311-2

Resumen del contenido incluido en la página 1

INSTALL INSTRUCTIONS C-3311-2 & C-3311-18-2
SLIDE-OUT TRUNK TRAY
2006-2008 CHEVROLET IMPALA

TOOLS REQUIRED:
7/16” wrench Standard socket set
Powered drill w/ 3/16” drill bit Screwdriver set
Ratcheting wrench

HARDWARE:
QTY DESCRIPTION PART #
12 ¼-20 x ¾” Hex head bolts GSM33001
16 ¼” Flat washers GSM31005
12 ¼-20 Serrated nuts GSM30023
4 8-32 x 3/8” Machine Screws GSM33540
4 8-32 Keps Nuts GSM30027
4 ¼” x ¾” Hex head lag bolts (only on C-3311-18-2) GSM33060-1
2 Front Mounting

Resumen del contenido incluido en la página 2

C-3311-18-2 HALF SIZE SLIDE TRAY Mounting Plate P.S Front Mounting Bracket Front Mounting Legs ¼” x 1” Lag bolts D.S. Rear Mounting Brackets 8-32 Screws and hex nuts P.S. Rear Mounting Bracket P.S. Rear Mounting ¼” x 1” Lag bolts Adapter Bracket C-3311-2 FULL SIZE SLIDE TRAY Mounting Plate Front Mounting Mounting Plate Legs Cradle Bracket D.S. Rear Mounting Brackets 8-32 Screws and hex nuts P.S. Rear Mounting Bracket - 2 -

Resumen del contenido incluido en la página 3

1. Attach forward mounting legs to the slide out tray. • Attach forward mounting legs with provided 8-32 screws and hex nuts to slide track. • The front legs will be square to the slide tray. • On the front passenger side of the half tray, passenger side front mounting brackets (CM001394) will attach to the front mounting legs. 2. Attach rear-mounting brackets to the slide out tray. • Loosely attached the rear mounting brackets to the “Cradle Bracket” using ¼” x ¾” hex head bolts, was

Resumen del contenido incluido en la página 4

• Tighten all loose hardware. • Be sure tray slides smoothly and locks in the closed position. If the tray does not slide smooth then most likely the tray is not square or level. #8 screws & hex nuts ¼” bolts, washers, & nuts Photo #3 - 4 - C-3311-2^3311-18-2_INST_9-07