Manual de instrucciones de Furuno Lh3000

Resumen del contenido incluido en la página 1

1. INSTALLATION
Wiring
The illustration below shows how to connect the power supply. Other equipment are
connected similarly.
(1) Unfasten screws.
J1
J2
J3
(4) Set terminal;
Jeweler’s
tighten screws.
screwdriver
(2) Pull out terminal.
- + - + - +
AFT FWD 13.6V
(3) Insert wire into terminal,
and tighten screw at top
of terminal.
- +
Note: Connect power cables
TERMINAL ARRANGEMENT
to the battery correctly.
J1
- + - + - +
AFT

Resumen del contenido incluido en la página 2

1. INSTALLATION Power connection 77 3 The LH-3000 is intended for Sheath Armor use with a 13.6 VDC power Drain wire fabrication supply. Connect the power L* Armor * Length long enough to reach ground terminal. cable (local supply) to the 15 5 Sheath terminals labeled “13.6V”. Use cable type DPYC-1.5 or φ = 11.7 mm Conductor 2 Cut the sheath. S = 1.5 mm equivalent. Fabricate the φ = 1.56 mm Solder drain wire DPYC-1.5 Sectional view cable as shown below. For 15 10 longer runs the wire s

Resumen del contenido incluido en la página 3