Manual de instrucciones de Edelbrock Yamaha YZ/WR400

Resumen del contenido incluido en la página 1

7. Install pull cable (see Figure 1) end into
INSTRUCTION SUPPLEMENT FOR
the 8:00 position of the cable wheel
1998-LATER YAMAHA
and the return cable into the 11:00
YZ/WR400/426/450F
position. Secure cables into cable

bracket by replacing end piece and
Removing stock carburetor and cables
phillips screw. See figure 2.



Figure 1.
1. Remove seat and gas tank. Make
sure fuel petcock is in “off”
position.
2. Remove throttle cables paying
close attention to routing, as the
ne

Resumen del contenido incluido en la página 2

17. Once pump is primed, get motor to TDC Figure 4. and kick through without opening throttle. If Motor will not fire with a few kicks, open idle cable ½ turn and repeat starting process. NOTE: If flooding occurs, slowly open throttle to wide open and hold. With throttle still open, hold decompression lever and kick motor through 5-10 times. Release throttle and decompression lever and proceed with normal starting procedure. SPECIAL NOTE: Because the Edelbrock is less