Manual de instrucciones de Edelbrock Honda TRX300EX

Resumen del contenido incluido en la página 1

INSTRUCTION SUPPLEMENT
Figure 1.
1993-LATER HONDA

TRX300EX


Twist Throttle
Removing Stock Carb and Cables


1. Remove stock thumb throttle
1. Remove seat/fender assembly and fuel
housing from handle bar end.
tank.


2. Install cables into supplied twist
2. Remove throttle cables paying close
throttle housing by clamping the end
attention to routing.
with the plastic elbows into throttle

housing.
3. Remove thumb throttle housing if you are

installing a twist thrott

Resumen del contenido incluido en la página 2

1. Using an 11mm or 7/16” wrench, remove hex plug from carburetor cap. Do not Replacement Cables: Thumb-#3013 discard, as it may be reinstalled after Twist- #9337 all adjustments are made. 2. Install supplied metering adjustment tool into cap. Do not over-tighten as damage may occur!!! 3. Install supplied fuel line onto carburetor fuel inlet and secure with supplied clamp. 4. Install carb into manifold and align as close to vertical as possible and tighten manifold clamp.