Manual de instrucciones de Lightolier Lytecaster 1001F Series

Resumen del contenido incluido en la página 1

READ AND UNDERSTAND THESE INSTRUCTIONS
INSTRUCTION SHEET NO.

BEFORE INSTALLING LUMINAIRE.

This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
IS:1101F
installation. To prevent electric shock, turn off electricity at main power supply before proceeding.

Retain these instructions for maintenance reference.
D1007

Resumen del contenido incluido en la página 2

INSTRUCTION SHEET NO. INSTALLATION PROCEDURE FOR: Lytecaster® 1101F, 1001F and 2001F Series Frame-In Kits IS:1101F (Continued) D1007 Page 2 of 3 INSTALLATION INSTRUCTIONS FOR WOOD FRAME CEILING APPLICATIONS 1 PREPARATION: Remove Wing Nuts on T-Bar Clips and remove clips from Luminaire Frame. Loosen Wing Nuts on Frame Clamps enough to allow free movement of Mounting Bars (Figure A). NOTE: The Mounting Bars may be readily adjusted to fit openings between 13” (330mm) minimu

Resumen del contenido incluido en la página 3

INSTRUCTION SHEET NO. INSTALLATION PROCEDURE FOR: Lytecaster® 1101F, 1001F and 2001F Series Frame-In Kits IS:1101F (Continued) D1007 Page 3 of 3 INSTALLATION INSTRUCTIONS FOR STEEL CONSTRUCTION APPLICATIONS 1 PREPARATION: Remove Wing Nuts on T-Bar Clips and reverse clips to inside of Luminaire Frame. Loosen Wing Nuts on Frame Clamps enough to allow free movement of Mounting Bars. Using standard ½” EMT tubing, cut pieces to required length such that it spans across Hat Chann