Manual de instrucciones de Sanyo TRC-6030

Resumen del contenido incluido en la página 1

INSTRUCTION
TRC-6030
MANUAL
i.,
MEMO.SCRIBER
TranscribinqSystem
)
,
t'\-
B
*"
HELP.LINE
the tolFfree number below il you have product.
any diffaculties operating this
-
1-800-421-5013 (weekdays pacific
8:00 AM 5:00 PM,
time)
1 AD6P1 P01 65-E lssue Number
, 1
-1

Resumen del contenido incluido en la página 2

MEMO-SCRIBER SANYO CONTROLS WARRANW LIMITED MODELTRC-6030 11. (VOLUME) 1. Eject lever (EJECT) Volume control OBLIGATIONS Service Center picked up lrom an Authorized Sanyo be delivered to and the product must In order to obtain warranty servtce, 2. Cassette 12.Search button and indicator compartment lid of Authorized Sanyo The iames and addresses "therwise in this warranty. untess spJciii""iiiy st;teq at the user,s expense, listed (SEARCH) at any of the addresses 3. Tape sFc's w;rrant

Resumen del contenido incluido en la página 3

Loading a microcassette 1. Pull the EJECT lever to Foot control open the cassette compartment lid. (BACK) 2. Load microcassette with 20. Back switch a the full reel to the right. 3. Close lid pressing Play (PLAY) the by it. 21. switch NOTES: - Be sure to close the lid after loading a micro- cassette. The unit does not operate unless the lid is closed. - Do not atempt to operate the EJECT lever while the unit is operating. When unloading press @o a microcassette, first the STOP but- pullth

Resumen del contenido incluido en la página 4

I lndex search (button DOWN). 1. Press the SEARCH button TRANSCRIPTION the unit. 2. Press the REW or FFWD button on when the tape reaches the The tape stops briefly and a beep tone sounds you index mark have recorded. - press BACK switch. When using the foot control, the NOTE: TRC-6300 Memo-scriber. The index marks are made on the SANYO Erasing you microcassette' is completed, can erase the After transcription press REW button While holding down the ERASE button, the 1. light. The ERA

Resumen del contenido incluido en la página 5

MAINTENANCE Cleaning the cabinet Use a clean soft cloth moistened with plain lukewarm water and wrung dry. Never use benzol, benzene or other strong chemical cleaners since these could damage the finish of your unit. lt is important that no liquid reaches the inside of the unit. Cleaning the head For continued high performance, periodically clean the head, pinch roller and capstan whdnever an accumulation of dust and red-brown oxide particles is noticed. To do this, pull the EJECT leve