Resumen del contenido incluido en la página 1
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS INTRODUCTION...........................................................................................................................2 IMPORTANT SAFETY INSTRUCTIONS......................................................................................3 FCC INFORMATION.....................................................................................................................5 PREPARATION FOR USE ..........................................................................
Resumen del contenido incluido en la página 3
INTRODUCTION Thank-you for choosing SANYO. This digital music system comes with dual docks for playing and charging iPhone/iPod, an AM/FM stereo digital tuner with 40 presets, dual alarm clock function with wake to iPhone/iPod/radio/buzzer, jumbo backlit LCD display with six level dimmer control, two 2.5” speaker drivers, rear passive subwoofer, 10W system power and a full function remote control. 2
Resumen del contenido incluido en la página 4
IMPORTANT SAFETY INSTRUCTIONS 1.) Read these instructions. Keep these instructions. Follow all instructions. Heed all warnings. 2.) Install this unit in accordance with the manufacturer’s instructions. 3.) Only use attachments / accessories specified by the manufacturer. 4.) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the unit. When a cart is used, use caution when moving the cart/unit combination to avoid injury from tip-over. 5.) Use
Resumen del contenido incluido en la página 5
IMPORTANT SAFETY INSTRUCTIONS 21.) Do not destruct the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 22.) Protect the power cord from being walked on or pinched particularly at pl
Resumen del contenido incluido en la página 6
FCC INFORMATION NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no g
Resumen del contenido incluido en la página 7
PREPARATION FOR USE Unpacking And Set Up ® • Remove the main unit, the AC adaptor, the 6 iPod adaptors, the lithium battery(CR2032) and the external AM Loop Antenna from the carton, and remove all packing material from the main unit. We recommend that you save the carton and packing material in the event that the unit ever needs to be returned for service. • Remove any descriptive labels or stickers from the top or front panels of the unit but do not remove any labels or stickers from the
Resumen del contenido incluido en la página 8
BATTERY BACK-UP SYSTEM This system includes a battery back-up circuit that will maintain the time and alarm settings, and the preset tuner memories, in the event of a temporary power interruption. The battery back-up system requires one 3-Volt lithium button cell (Type CR2032 or equivalent). If the back-up battery is not installed, or the battery is exhausted, and the AC power supply is interrupted, the time, alarm, and preset memory stations will be lost. It will be necessary to reset the
Resumen del contenido incluido en la página 9
BATTERY BACK-UP SYSTEM Battery Precautions Follow these precautions when using a battery in this device. 1. Warning -Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 2. Use only the size and type of battery specified. 3. Be sure to follow the correct polarity when installing the battery as indicated in the Battery Compartment. A reversed battery may cause damage to the device. 4. If the device is not to be used for a long per
Resumen del contenido incluido en la página 10
LOCATION OF CONTROLS & INDICATORS 1 2 3 4 16 21 5 6 7 8 9 10 11 12 13 14 15 22 17 18 19 20 1 . iPod Indicator 13. PLAY/PAUSE / Control 2 . Universal Dock for iPod 14. TUNE/SKIP / Control 3 . Universal Dock for iPod/iPhone 15. iPod SELECT Button 4 . iPod/iPhone Indicator 16. Remote Sensor 5 . STAN
Resumen del contenido incluido en la página 11
LOCATION OF CONTROLS & INDICATORS LCD DISPLAY Wake To Indicator; iPod,Radio,Buzzer. AUX/Radio Frequency/ Volume Level/ Alarm 1 / 2 Left iPod Indicator EQ/ DBBS Indicator ‘On’ Indicators FM/AM Indicator Right iPod Indicator Daylight Savings Time STEREO Indicator SLEEP, SNOOZE TIME AM / PM Indicator Indicator Low Battery Indicator Time/Alarm Display 10
Resumen del contenido incluido en la página 12
REMOTE CONTROL 1 Remote Control Transmitter 1 . 2 . STANDBY/ON Button 3 . MUTE Button 2 4 . VOLUME Button 5 . FM ST/MO Button 3 16 4 6 . DBBS Button 5 7 . SLEEP Button 17 6 8 . TIME SET / MEMORY Button 18 7 9 . PRESET / MENU - Button 8 19 PRESET / MENU 10. MENU Button 9 20 11. TUNE / SKIP Button 10 21 12. ENTER Button 11 12 13. iPod SELECT Button 13 22 14. PLAY/PAUSE / Button 14 15. SNOOZE / DIMMER Button 15 16. VOLUME Button 17. EQ Button DMP-692 18. ALM 2 Button 19. ALM 1
Resumen del contenido incluido en la página 13
OPERATING INSTRUCTIONS • Make sure that you have fully extended the FM antenna wire. • Be sure to connect the external AM Loop Antenna to the AM Antenna Jack on the back panel if you are planning to listen to AM radio stations (refer to page 17 for connection information) . • Make sure you have removed the mylar insulation tab from the remote control. • Make sure that the system is connected to an AC outlet that is always “live”. • Do not connect the system to an AC
Resumen del contenido incluido en la página 14
SETTING & BASIC OPERATION Sensor-Touch Control Information All of the controls on the top panel of the main unit, with the exception of the STANDBY/ON control and the iPod SELECT control, are special ‘Sensor-Touch’ controls. There are no buttons to ‘push’. When you softly touch one of these ‘buttons’, it will flash 3 times to confirm it understood the command, and then the system will react accordingly. Daylight Saving / Standard Time Selection Note: This adjustment can only be made when the
Resumen del contenido incluido en la página 15
SETTING & BASIC OPERATION Setting The Clock When the system is connected to the 120V 60Hz AC Outlet for the first time, “AM 12:00” will flash on the display. Important: Do not press the STANDBY/ON button to turn the system ‘On’. The clock can only be set when the system is in the Standby Mode. 1.) Touch and hold the TIME SET control on the top panel, or depress and hold the TIME SET button on the remote control until only the “Hour” digits are flashing. 2.) Touch the TUNE/SKI
Resumen del contenido incluido en la página 16
SETTING & BASIC OPERATION Volume Controls To increase or decrease the system volume, press the VOLUME or button on the remote control or VOLUME + or - on the top panel. The Volume Level Indicator will appear on the display when you change the volume level. The level indicator ranges from “00” (Minimum) to “30” (Maximum). If the volume level less than VOL 24, the system remembers the volume level when the power is switched ‘off’ and automatically returns to the same level when the power
Resumen del contenido incluido en la página 17
RADIO OPERATION 1.) Press the STANDBY/ON button on the top panel or on the remote control to turn the system ‘On’. The initial default ® Mode for this system is the iPod function. The “iPod ” indicator will flash above the time display. 2.) Touch the MODE button on the top panel or press the MODE button on the remote control until a FM or AM frequency appears above the time display. 3.) Tune to the desired station as follows: Automatic Tuning Press and hold the / buttons on the r
Resumen del contenido incluido en la página 18
RADIO OPERATION Hits For Better Reception FM: The FM lead wire antenna on the back panel should be extended to its full length. You may also have to vary the direction of this antenna until you find the position that provides the best reception. FM ANT AM: Insert the small black plug at the end of the AM Loop antenna wire into the AM ANT jack on the back panel as shown in the illustration. FM ANT AM ANT AM ANT To connect the AM loop antenna 17
Resumen del contenido incluido en la página 19
PRESETTING STATIONS IN THE TUNER MEMORY Up to 40 stations (20 AM / 20 FM) can be stored in the tuner memory for easy recall at any time. Use either the Automatic or Manual tuning methods described on page 16 to tune to the first station to be stored in memory. (Example “FM 103.5 MHz”) 1.) When the desired station frequency appears in the display, press and release the TIME SET / MEMORY button on the remote control or touch TIME SET / MEMORY on the top panel. The P – 01(Preset Memor
Resumen del contenido incluido en la página 20
PRESETTING STATIONS IN THE TUNER MEMORY Recalling Preset Stations Simply press the PRESET / MENU + or - buttons on the remote control or touch the PRESET / ALM1 - or PRESET / ALM2 + control on the top panel to scroll forward or backward through the preset station memories. Changing Preset Stations Tune to the new station you want to memorize, press the TIME SET / MEMORY button on the remote control or touch the TIME SET / MEMORY control on the top panel, then press the PRESET / MENU + or -
