Manual de instrucciones de American Standard M968628 REV.1.3

Resumen del contenido incluido en la página 1

Installation
Instructions
STUDIO
T590.50X
PRESSURE BALANCING
BATH AND SHOWER
TRIM KITS
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
Certified to comply with ANSI A112.18.1
M968628 REV.1.3
Recommended Tools
Phillips Screwdriver
Adjustable Wrench
Channel Locks
Plumbers' Putty or Caulking
Teflon Tape
Flat Blade Screwdriver
ROUGHING-IN DIMENSI

Resumen del contenido incluido en la página 2

INSTALL VALVE TRIM 1 PLSTER Figure 1. Remove plaster guard from valve. Push CAP (1) GUARD 1 over VALVE CARTRIDGE (2) until seated against stop. Figure 2. Make sure O-RING (8) is secure within ESCUTCHEON HOLDER (3). Push ESCUTCHEON HOLDER (3) onto CAP (1) and attach with LONG SCREWS (4). Mount ESCUTCHEON SUPPORT (5) to ESCUTCHEON 2 HOLDER (3) with 4 SHORT SCREWS (6). Figure 1. Figure 3. Install ESCUTCHEON (7) onto CAP (1) and push flush against finished wall. Escutcheon (7) will snap fit onto ESCUTC

Resumen del contenido incluido en la página 3

0 1 ADJUST HOT LIMIT STOP 3 HOT LIMIT SAFETY STOP ADJUSTMENT By restricting handle rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY STOP reduces risk of accidental scalding. To set the maximum hot water temperature of your faucets, all you need to do is adjust the setting on the HOT LIMIT SAFETY STOP. Use a flat blade screwdriver or your fingers to pull up and rotate red HOT LIMIT SAFETY STOP (1). Follow Step "A" or "B" to adju