Manual de instrucciones de Pelco C283M-C

Resumen del contenido incluido en la página 1

C283M-C (4/07)
LWM41
®
Legacy Wall Mount
IMPORTANT SAFETY INSTRUCTIONS
1. Installation and servicing should only be done by qualified service personnel and conform to all local codes.
2. Installation shall be done in accordance with all local and national electrical and mechanical codes utilizing only approved materials.
3. Use only installation methods and materials capable of supporting four times the maximum specified load.
4. Use stainless steel hardware to fasten the mount to outdoor surfac

Resumen del contenido incluido en la página 2

OPTIONAL RECEIVER MODELS ® LRD41A11-1 Fixed speed, Coaxitron compatible only; 120 VAC input voltage; 120 VAC pan/tilt voltage LRD41A11-2 Fixed speed, Coaxitron compatible only; 24 VAC input voltage; 24 VAC pan/tilt voltage LRD41A11-3 Fixed speed, Coaxitron compatible only; 230 VAC input voltage; 120 VAC pan/tilt voltage LRD41C21-1 Fixed speed, Coaxitron/RS-422 compatible with 64 presets; 120 VAC input voltage; 120 VAC pan/tilt voltage LRD41C21-2 Fixed speed, Coaxitron/RS-422 compatible with 64 p

Resumen del contenido incluido en la página 3

To install any Legacy Series pan/tilt with the LWM41 mount: 1. Route the pan/tilt pigtail wire connector through the hole of the mount. 2. Place the pan/tilt on the mount, without the enclosure being attached to the pan/tilt. Be sure the factory-installed gasket is on the bottom of the pan/ tilt spindle for protection (refer to Figure 1). 3. Secure the pan/tilt to the mount using three 1/4-20 x 5/8-inch cap screws supplied with the mount (refer to Figure 1). Be sure to apply some form of ® thr

Resumen del contenido incluido en la página 4

PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or If a warranty repair is required, the Dealer must contact Pelco at (800)289-9100 or workmanship for a period of one year after the date of shipment. (559)292-1981 to obtain a Repair Authorization number (RA), and provide the following information: Exceptions to this warranty are as noted below: 1. Model and serial number • Five years on FR/FT/FS Series fi