Manual de instrucciones de Directed Electronics HT80ic

Resumen del contenido incluido en la página 1

HT60ic
HT80ic
owner's manual
analog and digital systems

Resumen del contenido incluido en la página 2

table of contents introduction 1 cautions 1 about this manual 1 features 1 installation precautions and tips 2 general mounting suggestions 2 prewiring 3 preparing the wall or ceiling cutout 3 installation preparation 3 final installation 4 custom painting 4 operation 4 specifications 5 warranty information 6 introduction Thank you for purchasing an a/d/s/ in-ceiling speaker system. Please read the following instructions carefully. Following these instructions will ensure that your system will

Resumen del contenido incluido en la página 3

installation precautions and tips Please read these instructions completely for the best enjoyment of your Custom Series speakers.  When you cut into the ceiling to install the speaker, do not cut through the facing or insulation that may be above the ceiling. This facing is a moisture barrier. Use duct tape or wide vinyl tape to seal any cuts.  Keep debris and loose material away from the installation location. Do not allow debris to get in the openings of the woofer basket. Debris and loos

Resumen del contenido incluido en la página 4

prewiring  Check local building and electrical codes for compliance of the speaker wire.  Use stranded wire of at least 16 gauge; for runs over 100 feet, it is preferable to use 14 gauge wire.  Use only insulated staples or nylon tie straps to secure wiring within the wall to avoid shorts.  Do not stretch the wire as it is being routed. This could create future (and costly) problems.  Leave about 2-3 feet of free wire at both ends. Cutting excess wire is better than splicing.  Always "h

Resumen del contenido incluido en la página 5

final installation The speaker is held in place with four mounting clamps that are part of the assembly. When shipped from the factory the clamps are pivoted so they will fit into the mounting hole. When the mounting hole clamp screws are turned, the clamps pivot outward and are then drawn downward until they press against the back of the mounting surface. Insert the speaker/mounting bezel assembly into the mounting hole. Hold the speaker in place in the mounting hole and evenly tighten the four

Resumen del contenido incluido en la página 6

specifications HT60ic HT80ic frequency response (Hz) 65-20 kHz 58-20 kHz impedance 4 ohm 4 ohm sensitivity 1W/1M (dB) 88 dB 88 dB max bezel diameter 9-1/4" (23.5 cm) 10-7/8" (27.6 cm) mounting hole 7-11/16" (19.5 cm) 9-7/16" (24.0 cm) rear clearance 3-1/2" (8.9 cm) 4-1/8" (10.5 cm) recommended power 20-80 watts 20-80 watts woofer 6-1/2" (16.5 cm) 8" (20.3 cm) tweeter 1" (25 mm) dome 1" (25 mm) dome (Specifications subject to change without notice) 5

Resumen del contenido incluido en la página 7

warranty information LIMITED TWO YEAR CONSUMER WARRANTY Directed Electronics, Inc. promises to the original purchaser, to replace this product should it prove to be defective in workmanship or material under normal use, for a period of two years from the date of purchase from the dealer as indicated by the date code marking of the product PROVIDED the product was installed by an authorized Directed dealer. During this two-year period, there will be no charge for this replacement PROVIDED the uni

Resumen del contenido incluido en la página 8

a Directed Electronics, Inc. All rights reserved G39630/35 8-03