Resumen del contenido incluido en la página 1
RS
If you have any questions contact
the SAS Technical Support Department at:
Phone - (225) 272 7135 • Fax - (225) 272-9844
Email - tech@bazooka.com • Website - www.bazooka.com
In Canada: (604) 988 2966
15049 Florida Blvd., Baton Rouge, LA. 70819
, SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc.
PAT. NO. 4,567,959 • PAT NO. 5,097,513
1003129704A
amplified installation manual
Resumen del contenido incluido en la página 2
C O N S U M 1 E 9 R ' S E L N E O C I CONGRATULATIONS ADJUSTING THE CROSSOVER Dear Friend, The built-in crossover on the Amplified Bazooka is a 18 dB per octave electronic low pass filter, it has a 60 Hz to 250 Hz variable crossover point. Select the ® Thank you for selecting Bazooka subwoofer speaker systems for your car stereo crossover point that you feel best fits your system design. Set the potentiometer labeled XOVER to the point you selected, 60 Hz being all the way to the left (coun- sy
Resumen del contenido incluido en la página 3
CONTENTS Phase Alert When one of the Amplified Bazooka's High-level Input channels is out of phase elec- trically with the other High-level Input channel your Bazooka will sound as if it has lit- System Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 3 tle or no output, and any output that is produced may sound distorted. If you suspect Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 3 that your Bazooka is out of phase, use the
Resumen del contenido incluido en la página 4
SYSTEM FEATURES " ", 8 • 6 1/2 ", or 10 SUBWOOFER • BASS-REFLEX ENCLOSURE * • HIGH EFFICIENCY OUTPUT OPTIMIZED FOR SPACE EFFICIENCY • DESIGNED FOR CORNER LOADING • MOISTURE RESISTANT ENCLOSURE • CONTINUOUSLY VARIABLE 18dB ELECTRONIC CROSSOVER • NOISE REJECTING BALANCED HIGH LEVEL INPUT • INPUTS ARE SUMMED MONO INTERNALLY • 150 WATTS MONO INTO 2 OHMS • SELECTABLE AUTOMATIC TURN ON FEATURE • 2 YEAR WARRANTY • LARGE MAGNET FOR INCREASED POWER HANDLING ® *BAZOOKA subwoofer speaker systems exclusiv
Resumen del contenido incluido en la página 5
GROUND WIRE CONT. INSTALLATION The ground point in the car should be a piece of chassis metal that is part of or TRUCK INSTALLATION welded to the main body of the vehicle. Painted surfaces should be scraped or sanded clean to expose the bare metal before the ground lug is bolted down. (Cover the bare metal area with paint or grease after you finish mounting the ground wire to prevent rust.) Figure 1 REMOTE TURN ON OPTIONS The ORANGE wire on the Amplified Bazookas' 14-pin Molex Mini-fit Jr. conne
Resumen del contenido incluido en la página 6
INSTALLATION POWER WIRE The 12 gauge red wire on the 2-pin power plug is the 12 Volt positive power wire. Please take time to read through this manual and plan out your installation It must be fused and connected directly to the positive terminal of the battery to pro- before you begin! vide a power source with a low voltage drop and low noise. Do not make the power connection at the fuse block or any point other than the battery. Improper Locate an area in the rear of the vehicle where you wou
Resumen del contenido incluido en la página 7
WIRING DIAGRAM MOUNTING THE BAZOOKA When using high level inputs, take the time after you make all wiring connections to run through the AM I IN PHASE? procedure of this manual to confirm that your inputs are in correct electrical phase and the proper 1. With the top side bass response is being produced. of the buckle facing up (see figure 4), lace Figure 4 the strap through the mounting base as illustrated in figure 5. Top Bottom Figure 5 2. After the strap is com- pletely laced through the mou
Resumen del contenido incluido en la página 8
MOUNTING THE BAZOOKA MOUNTING THE BAZOOKA 7. Adjust buckle end of 3. Place each mount- strap so that it extends ing base under the See Model Size out of the mounting Bazooka so that the For Length base (see figure 9) the apex at the bottom of proper length for the the tube sits inside model size of Bazooka the mounting base as you are installing in figure 7. Figure 9 (Refer to the chart for proper length) 8. Remove any slack in the strap by feeding it 4. Move the bases so Model Length out of th
Resumen del contenido incluido en la página 9
MOUNTING THE BAZOOKA MOUNTING THE BAZOOKA 7. Adjust buckle end of 3. Place each mount- strap so that it extends ing base under the See Model Size out of the mounting Bazooka so that the For Length base (see figure 9) the apex at the bottom of proper length for the the tube sits inside model size of Bazooka the mounting base as you are installing in figure 7. Figure 9 (Refer to the chart for proper length) 8. Remove any slack in the strap by feeding it 4. Move the bases so Model Length out of th
Resumen del contenido incluido en la página 10
WIRING DIAGRAM MOUNTING THE BAZOOKA When using high level inputs, take the time after you make all wiring connections to run through the AM I IN PHASE? procedure of this manual to confirm that your inputs are in correct electrical phase and the proper 1. With the top side bass response is being produced. of the buckle facing up (see figure 4), lace Figure 4 the strap through the mounting base as illustrated in figure 5. Top Bottom Figure 5 2. After the strap is com- pletely laced through the mou
Resumen del contenido incluido en la página 11
INSTALLATION POWER WIRE The 12 gauge red wire on the 2-pin power plug is the 12 Volt positive power wire. Please take time to read through this manual and plan out your installation It must be fused and connected directly to the positive terminal of the battery to pro- before you begin! vide a power source with a low voltage drop and low noise. Do not make the power connection at the fuse block or any point other than the battery. Improper Locate an area in the rear of the vehicle where you wou
Resumen del contenido incluido en la página 12
GROUND WIRE CONT. INSTALLATION The ground point in the car should be a piece of chassis metal that is part of or TRUCK INSTALLATION welded to the main body of the vehicle. Painted surfaces should be scraped or sanded clean to expose the bare metal before the ground lug is bolted down. (Cover the bare metal area with paint or grease after you finish mounting the ground wire to prevent rust.) Figure 1 REMOTE TURN ON OPTIONS The ORANGE wire on the Amplified Bazookas' 14-pin Molex Mini-fit Jr. conne
Resumen del contenido incluido en la página 13
TURN ON OPTIONS CONT. and middle pins to enable the Auto Turn-On feature. This can be done easily with a pair of needle nose pliers. With the jumper in the Auto position, the Amplified Bazooka will turn on automatically when it senses any music. The ORANGE wire should not be connected to anything if this feature is being used. Be sure to insulate the end of the ORANGE wire so that it will not short to ground, as this may damage the Amplified Bazooka. Amplifier Status LED The white color LED on t
Resumen del contenido incluido en la página 14
CONTENTS Phase Alert When one of the Amplified Bazooka's High-level Input channels is out of phase elec- trically with the other High-level Input channel your Bazooka will sound as if it has lit- System Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 3 tle or no output, and any output that is produced may sound distorted. If you suspect Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .pg 3 that your Bazooka is out of phase, use the
Resumen del contenido incluido en la página 15
C O N S U M 1 E 9 R ' S E L N E O C I CONGRATULATIONS ADJUSTING THE CROSSOVER Dear Friend, The built-in crossover on the Amplified Bazooka is a 18 dB per octave electronic low pass filter, it has a 60 Hz to 250 Hz variable crossover point. Select the ® Thank you for selecting Bazooka subwoofer speaker systems for your car stereo crossover point that you feel best fits your system design. Set the potentiometer labeled XOVER to the point you selected, 60 Hz being all the way to the left (coun- sy
Resumen del contenido incluido en la página 16
RS If you have any questions contact the SAS Technical Support Department at: Phone - (225) 272 7135 • Fax - (225) 272-9844 Email - tech@bazooka.com • Website - www.bazooka.com In Canada: (604) 988 2966 15049 Florida Blvd., Baton Rouge, LA. 70819 , SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc. PAT. NO. 4,567,959 • PAT NO. 5,097,513 1003129704A amplified installation manual
