Resumen del contenido incluido en la página 1
INTEGRATED STEREO AMPLIFIER
PMA-2000IVR
OPERATING INSTRUCTIONS
B
VOLUME
MUTE/STANDBY
INPUT SELECTOR
TAPE-2/MD TAPE-1/CD-R PHONO CD TUNER DVD/AUX-1 AUX-2/P. DIRECT
POWER
¢ ON/STANDBY £ OFF SOURCE DIRECT
¢ ON
£ OFF
REMOTE SENSOR
REC OUT SELECTOR
BASS TREBLE BALANCE AMP
CD
PHONO TUNER POWER MUTING
PHONES
TAPE-1 2 1 AUX-1 9
COPY AUX-2
8
TRACK FUNCTION VOLUME
LEFT RIGHT
3 2 1
PAUSE STOP PLAY
CD
B
REMOTE CONTROL UNIT
RC-858
“SERIAL NO.
PLEASE RECORD UNIT SERIAL NUM
Resumen del contenido incluido en la página 2
2 SAFETY PRECAUTIONS CAUTION CAUTION TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF RISK OF ELECTRIC SHOCK PLUG TO WIDE SLOT, FULLY INSERT. DO NOT OPEN ATTENTION CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTERODUIRE LA USER-SERVICEABLE PARTS INSIDE. REFER LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE SERVICING TO QUALIFIED SERVICE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’ AU PERSONNEL. FOND. The lightning flash with arro
Resumen del contenido incluido en la página 3
SAFETY INSTRUCTIONS 1. Read Instructions – All the safety and operating instructions 13. Power-Cord Protection – Power-supply cords should be routed should be read before the product is operated. so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to 2. Retain Instructions – The safety and operating instructions cords at plugs, convenience receptacles, and the point where should be retained for future reference. they exit from
Resumen del contenido incluido en la página 4
NOTE: PRECAUTIONS FOR INSTALLATION 1. Always keep the POWER switch on the main unit turned on. For heat dispersal, leave at least 10 cm of space between the top, 2. Turn the power on and off from the remote control unit. back and sides of this unit and the wall or other components. 3. Unplug the power cord when you do not plan to use the unit for a long period of time. 10cm or more ✽ CAUTION: If only the MUTE/STANDBY LED is lit red, this means that the ✽ power is turned off from the remote contr
Resumen del contenido incluido en la página 5
• TUNER: Power switch (POWER) q Used to recording from the tuner. When the power switch is turned ON (¢), the • AUX-1: MUTE/STANDBY LED !1 lights. Used to recording component that connected to the When the power switch is turned ON, power is supplied to DVD/ AUX-1 terminals. the unit. It takes a few seconds after the power is turned on for the unit to warm up. This is due to the built-in • AUX-2: muting circuit that eliminates noise during the on/off Used to recording component that connected t
Resumen del contenido incluido en la página 6
Rear Panel @1 @0 !9 !2 !3 !4 !5 !6 !7 !8 Inputs terminals (INPUTS) Pre out terminals (PRE OUT) !2 !6 These are input terminals for CD players, turntables, Use these when adding a power amplifier, a subwoofer AM/FM tuners, tape decks or other playback components. with built-in power amplifier, etc. Connect these PRE OUT terminals to the input terminals on NOTE: the additional power amplifier, subwoofer, etc. The PHONO input terminals are equipped with a NOTE: short pin-plug. Remove this plug to c
Resumen del contenido incluido en la página 7
Ground terminal (SIGNAL GND) @0 Connect the turntable’s ground wire here. NOTE: This terminal is used to reduce noise when a turntable, etc., is connected. It does not provide grounding. Cartridge selection switch (CARTRIDGE) @1 This switch is set according to the type of player cartridge to be used. Set this switch to MM (£) or MC (¢) according to the type of cartridge used on your turntable. 2 CONNECTIONS Connecting the speakers CAUTION • Speaker impedance Protective Circuit • When using speak
Resumen del contenido incluido en la página 8
Cautions on Connections • Do not plug in the power cord until all connections are • Note that placing the pin plug cords next to power supply completed. cords or near power transformers may result in humming or • Be sure to connect the left and right channels properly. other noise. • Insert the plugs securely. Incomplete connections can • The PHONO input jacks have an extremely high sensitivity, result in noise. so avoid turning up the volume when no pin plug cords are • Use the SWITCHED AC OUT
Resumen del contenido incluido en la página 9
3 OPERATION (Refer to page 4 and 6) PREPARATION RECORDING WITH TAPE DECK 1. CHECKING CONNECTIONS 1. Set the REC OUT SELECTOR switch i to the program • Make sure that all the connections are proper by referring to source you wish to record. the rear panel. 2. Play back the program source. • Check the polarity (positive and negative) of connections, 3. Start recording with the component connected to “TAPE- and the directivity of stereo separation (right cord to right 1/CD-R” or “TAPE-2/MD”. channe
Resumen del contenido incluido en la página 10
4 REMOTE CONTROL OPERATION The accessory Remote Control Unit is used to control the amplifier from a convenient distance. (1) Inserting the Dry Cell Batteries Notes on Battery Usage 1. Remove the battery cover on the Remote Control Unit. • RC-858 uses the size R03 (AAA) dry cell batteries. • The batteries will need to be replaced approximately once a year. This will depend upon how often the Remote Control Unit is used. • If, in less than a year from the time new batteries were inserted, the Rem
Resumen del contenido incluido en la página 11
Remote Control Unit RC-858 supplied with the PMA-2000IVR Pre-main Amplifier Block Use these to control the PMA-2000IVR. MUTING : AMP When pressed, the main unit’s power POWER MUTING LED flashes and the speaker output is turned off. When pressed again, the 9 mute mode is canceled and the power LED stops flashing (remaining lit). 8 POWER : TRACK FUNCTION VOLUME • When the main unit’s power switch is set to the ON/STANDBY position (¢), press 3 2 1 CD player Block this to turn the PMA-2000IVR’s pow
Resumen del contenido incluido en la página 12
5 TROUBLESHOOTING Check the following before assuming there is a problem with the set. 1. Are all connections proper ? 2. Is the set being operated as described in the operating instructions ? 3. Are the speakers and input components being operated properly ? If the set does not seem to be operating properly, check the points listed below. If these points do not apply, the set may be damaged. Turn off the power immediately and contact your store of purchase. Symptom Cause Measures Page MUTE/STAN
Resumen del contenido incluido en la página 13
6 SPECIFICATIONS • POWER AMPLIFIER SECTION • OVERALL CHARACTERISTICS Rated Output Power: SN Ratio (IHF A Network): PHONO Both channel driven (input terminals short- (8 Ω /ohms Load) 80 W + 80 W circuited) MM: 89 dB 20 Hz to 20 kHz, T.H.D. 0.07 % (at 5 mV input) (4 Ω /ohms Load) 160 W + 160 W (input terminals short- DIN, 1 kHz, T.H.D. 0.7 % circuited) MC:74 dB Total Harmonic Distortion: 0.01 % (at 0.5 mV input) (–3 dB at rated output, 8 Ω /ohms) (1 kHz) SOURCE-DIRECT: ON CD, TUNER, Input Sensitiv
Resumen del contenido incluido en la página 14
MEMO 14
Resumen del contenido incluido en la página 15
MEMO 15
Resumen del contenido incluido en la página 16
16-11, YUSHIMA 3-CHOME, BUNKYOU-KU, TOKYO 113-0034, JAPAN Telephone: (03) 3837-5321 Printed in Japan 511 3917 001
