Manual de instrucciones de Knoll MX1255

Resumen del contenido incluido en la página 1

Warranty
Knoll Systems warrants MX1255 amplifiers sold in the USA and Canada by
MX1255 Amplifier
authorized Knoll dealers to be free of defects in materials and manufacturing.
12 Channel Amplifier
This warranty extends for three full years from the date of purchase by the
original consumer. Any products returned to Knoll Systems and found to be
Installation Instructions v7.3
defective by Knoll Systems within the warranty period will be repaired or

replaced at Knoll Systems decision,

Resumen del contenido incluido en la página 2

Important Safety Instructions: Hum and noise In most cases, one of the following suggestions should help you 1) Read these instructions. solve a hum noise in your system. Please try these steps in the 2) Keep these instructions. order shown; proceeding from one step to the next if the prior 3) Read all warnings. suggestion does not eliminate the problem. 4) Follow all instructions. 5) Do not use this apparatus near water. 6) Clean only with dry cloth. Suggestion #1 7) Do not blo

Resumen del contenido incluido en la página 3

Knoll Systems service information The MX1255 amplifier does not contain any user serviceable parts Installation inside. If you suspect a problem that may require servicing, contact us Installing the MX1255 should be relatively easy. With a bit of at www.knollsystems.com/contact.html, or by phone at 800 566-5579. planning, it will give trouble free service for years. Troubleshooting 1. The most important consideration when installing the If a problem is encountered with the MX1255,

Resumen del contenido incluido en la página 4

Caution: Never listen to sound that is distorted. If distorted sound is heard, turn the volume down immediately or speaker and/or amplifier damage could occur that is not covered by the The trigger is 12 VDC (35mA per MX1255) via 3.5mm warranty. If this problem persists, contact your dealer. mono jack. 5 VDC trigger outputs will not work. To connect the trigger to a receiver use a 12 VDC power User adjustments and service: There are no user supply (we suggest Knoll PS1202 power sup