Resumen del contenido incluido en la página 1
MICRO COMPONENT SYSTEM
UX-P55—Consists of CA-UXP55 and SP-UXP55
COMPACT
DIGITAL AUDIO
CD-R/R W PLA YBACK
STANDBY/ON
MICRO COMPONENT SYSTEM UX·P55
CLOCK
STANDBY / ON
AHB PRO
CD TAPE FM/AM MD/AUX
STANDBY/ON
/
DIMMER DISPLAY SLEEP
DIRECT OPERATING
FUNCTION VOLUME
SOUND TIMER
MD/AUX
PROG RANDOM REPEAT
SOUND AUTO FM/AM
MODE PRESET FM MODE
TAPE
CD
CD
REV .MODE
CANCEL MULTI KEY SET
DISPLAY PTY
MODE /EON
REC REC
REC
PHONES AUTO REVERSE
AHB
PRO VOLUME
RM-SUXP5R REMOTE CONTROL
SP-UXP55 CA-UXP55 SP-UXP55
I
Resumen del contenido incluido en la página 2
Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS IMPORTANT for the U.K. DO NOT cut off the mains plug from this equipment. If the plug REPRODUCTION OF LABELS fitted is not suitable for the power points in your home or the cable 1 CLASSIFICATION LABEL ON EXTERIOR SURFACE is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonethele
Resumen del contenido incluido en la página 3
SAFETY INSTRUCTIONS “SOME DOS AND DON’TS ON THE SAFE USE OF EQUIPMENT” This equipment has been designed and manufactured to meet international safety standards, but like any electrical equipment, care must be taken if you are to obtain the best results and safety is to be assured. ✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮✮ Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and inter
Resumen del contenido incluido en la página 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the buttons on the remote control. DO NOT handle
Resumen del contenido incluido en la página 5
Contents Location of the Buttons and Controls ....................... 3 Playing Back CDs (CD/CD-R/CD-RW) .................. 14 Front Panel ................................................................. 3 Playing Back the Entire CD—Normal Play ............. 14 Remote Control .......................................................... 5 Basic CD Operations ................................................ 14 Programming the Playing Order of the Tracks Getting Started..............................
Resumen del contenido incluido en la página 6
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Front Panel 1 q COMPACT w DIGITAL AUDIO CD-R/R W PLA YBACK e r STANDBY/ON 2 MICRO COMPONENT SYSTEM UX-P55 CLOCK 3 t STANDBY/ON 4 5 AHB PRO y CD TAPE FM/AM MD/AUX 6 / DIRECT OPERATING VOLUME FUNCTION TIMER SOUND 7 u i o 8 ; REV.MODE a s REC REC d AUTO REVERSE PHONES 9 f p – 3 – EN01-13_UX-P55[B]f.pm6 3 03.1.23, 7:55 PM
Resumen del contenido incluido en la página 7
Continued Display Window 2 1 3 4 [ ] DAILY REC SLEEP REC RDSEON TA NEWS INFO CLOCK PRGM RANDOM ALL BASS SOUND MONOST 5 6 7 8 9p See pages in the parentheses for details. Front Panel Display Window 1 Remote sensor 1 Tape operation indicators 2 STANDBY/ON lamp (9) •2 3 (tape direction) and (reverse mode) 3 (STANDBY/ON) button (9, 16, 21) indicators 4 TAPE 2 3 button (9, 17, 18) 2 Timer indicators Pressing this button also turns on the unit. • (timer), DAILY, REC and SLEEP indicators 5 CD 3/8 (pla
Resumen del contenido incluido en la página 8
Remote Control 1 REPEAT button (16) 2 DIMMER button (10) 3 DISPLAY button (9) 4 PROG (program) button (15) 5 RANDOM button (16) 6 SOUND MODE button (10) STANDBY/ON 7 AUTO PRESET button (11) 8 CD 0 (disc tray open/close) button (14) 1 t Pressing this button also turns on the unit. DIMMER DISPLAY SLEEP 2 9 CD 3/8 button (9, 14, 15) y 3 Pressing this button also turns on the unit. MD/AUX PROG RANDOM REPEAT 4 p4 (reverse search) button (11 – 14, 17) u SOUND AUTO 5 q7 (stop) button (14 – 19) FM/AM FM
Resumen del contenido incluido en la página 9
Continued Getting Started Supplied Accessories Connecting Antennas Make sure that you have all the following items. FM antenna The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) • FM antenna (1) • Remote control (1) FM antenna (supplied) • Batteries (2) If anything is missing, consult your dealer immediately. Putting the Batteries into the Remote Control Insert the batteries—R6(SUM-3)/AA(15F)—into the remote control, by matching the polarity (+ and
Resumen del contenido incluido en la página 10
AM (MW/LW) antenna Connecting Speakers ] ] 2 1 3 ANTENNA Vinyl-covered wire (not supplied) Red 1 AM EXT AM LOOP RIGHT LEFT MAIN SPEAKERS Speaker Speaker cord cord FM 75 SPEAKER COAXIAL IMPEDANCE MIN 6 Black Right Left 2 speaker speaker AM loop antenna (supplied) 1 Press and hold the clamp of the speaker terminal on the rear of the unit. 1 Connect the AM loop antenna to the AM LOOP terminals as illustrated. 2 Insert the end of the speaker cord into the terminal. 2 Turn the AM loop antenna until y
Resumen del contenido incluido en la página 11
To remove the speaker grilles To connect audio equipment with an optical digital The speaker grilles are removed as the illustrations below. input terminal You can record CD sound onto the connected digital Holes Projections equipment. Protective plug OPTICAL DIGITAL OUT Speaker grille Before connecting the other equipment, remove the protective plug from the terminal. Audio equipment with To remove the speaker grille, inserting your fingers at the an optical digital input top of the speaker gri
Resumen del contenido incluido en la página 12
Common Operations Turning On the Power 2 Press ¢ or 4 to adjust the hour, then press CLOCK. When you press the play button—CD 3/8, TAPE 2 3, or The minute digits start flashing on the the source selecting button—FM/AM and MD/AUX, the unit display. automatically turns on and starts playback if the source is ready. CLOCK CLOCK To turn on the unit, press (STANDBY/ON). The STANDBY/ON lamp on the unit lights green. STANDBY/ON STANDBY/ON 3 Press ¢ or 4 to adjust the minute, then press STANDBY/ON CLOC
Resumen del contenido incluido en la página 13
Adjusting the Volume Reinforcing the Bass Sound You can adjust the volume level only while the unit is turned You can reinforce the bass sound to maintain rich (“AHB 1” on. The volume level can be adjusted between “VOLUME 0” and “AHB 2”), full bass at low volume. This function only and “VOLUME 40.” affects the playback sound, but does not affect your recording. – VOLUME + When using the remote control, press AHB VOLUME + to increase the volume or press To get the effect, press AHB (Active Hyper
Resumen del contenido incluido en la página 14
Listening to FM and AM (MW/LW) Broadcasts Tuning in a Station 3 Repeat steps 1 and 2 to store stations for the other band. FM/AM 1 Press FM/AM. The unit automatically turns on and tunes in the previously tuned station (either FM or When you cannot automatically store stations you want AM—MW/LW). Stations with weak signals cannot be detected with this automatic • Each time you press the button, the band alternates presetting. To store such a station, use the manual presetting. between FM and AM (
Resumen del contenido incluido en la página 15
Continued Receiving FM Stations with RDS RDS (Radio Data System) allows FM stations to send an Searching for Programs by PTY Codes additional signal along with their regular program signals. (PTY Search) For example, the stations send their station names, as well as information about what type of program they broadcast, such One of the advantages of RDS is that you can locate a as sports or music, etc. particular kind of program by specifying the PTY codes. When tuned to an FM station which prov
Resumen del contenido incluido en la página 16
Switching Temporarily to a Program Type of How the Enhanced Other Networks function actually Your Choice works: The Enhanced Other Networks function allows the unit to CASE 1 switch temporarily to a broadcast program of your choice If there is no station broadcasting the program you (TA, NEWS, and INFO) from a different station. have selected • The function only works when you are listening to a preset The unit continues tuning in the current station. FM RDS stations providing the data. « To act
Resumen del contenido incluido en la página 17
Continued Playing Back CDs (CD/CD-R/CD-RW) This unit has been designed to playback the following CDs: CD 3 Press CD 3/8. •CD The disc tray automatically closes and the first • CD-R track of the CD starts playing. • CD-RW Continued use of irregular shape CDs (heart-shape, octagonal, etc.) can damage the Track number Elapsed playing time unit. • The CD automatically stops when the last track of the CD has finished playing. General Notes In general, you will have the best performance by keeping To
Resumen del contenido incluido en la página 18
To check the program contents Programming the Playing Order of the Tracks PROG You can check the program contents by —Program Play pressing PROG on the remote control. The programed tracks are shown in the You can arrange the order in which tracks play before you programed order. start playing. You can program up to 20 tracks. To modify the program On the remote control ONLY: CANCEL Before or after playing, you can erase the last 1 Load a CD. programed track by pressing CANCEL on the • If the cu
Resumen del contenido incluido en la página 19
Playing at Random—Random Play Prohibiting Disc Ejection—Tray Lock The tracks will play in no particular order when you use this You can lock the disc tray and prohibit to eject the CD. mode. • This is possible only while the unit is turned on. On the remote control ONLY: On the unit ONLY: RANDOM To use Random play mode, press RANDOM To prohibit disc ejection, press before or during playing. (STANDBY/ON) while holding 7. (If the The RANDOM indicator lights up on the display. disc tray is opened,
Resumen del contenido incluido en la página 20
Playing Back Tapes You can play back type I, type II, and type IV tapes without To stop playing, press 7. changing any settings. To fast-wind to the left or to the right, press ¢ or 4 while the tape is not running. The tape direction indicator (2 or 3) starts flashing quickly Playing Back a Tape on the display. To remove the cassette, press 0 for cassette deck. 1 Press 0 for cassette deck. To play both sides—Reverse Mode You can set the deck to play just one side of a tape, both sides once, or b
