Manual de instrucciones de Network Technologies SE-DVI-2

Resumen del contenido incluido en la página 1

NETWORK 1275 Danner Dr Tel:330-562-7070
R
TECHNOLOGIES Aurora, OH 44202 Fax:330-562-1999
INCORPORATED www.networktechinc.com
NTI
®
VIDMUX Series
SE-DVI-2
2 Port DVI Video Switch
Installation and Operation Manual
MAN068 Rev Date 5/24/2006

Resumen del contenido incluido en la página 2

TRADEMARK VIDMUX is a registered trademark of Network Technologies Inc in the U.S. and other countries. COPYRIGHT Copyright © 2006 by Network Technologies Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written consent of Network Technologies Inc, 1275 Danner Drive, Aurora, Ohio 44202. CHANGES The material in this g

Resumen del contenido incluido en la página 3

TABLE OF CONTENTS Introduction......................................................................................................................................................................1 Materials..........................................................................................................................................................................1 Features And Functions ..................................................................................................

Resumen del contenido incluido en la página 4

NTI VIDMUX Series 2-Port DVI Video Switch INTRODUCTION The VIDMUX Series SE-DVI-2 (VIDMUX) is a 2-port DVI video switch that enables two video sources such as a PC or HDTV tuner to share one DVI monitor using DVI-I or DVI-D single-link connectors. The DVI interface technology implements digital signal transmission over the cable to eliminate noise and reduce undesired distortion. See our catalog, visit our website at http://www.networktechinc.com, or contact an NTI sales representative at 800

Resumen del contenido incluido en la página 5

NTI VIDMUX Series 2-Port DVI Video Switch INSTALLATION The VIDMUX is a Plug-and-Play device with no special configuration settings and easy installation steps: 1. Before connecting the VIDMUX to the video sources, make sure the video sources and the monitor are turned OFF. WARNING! Damage may occur to the CPU if power is not disconnected before connecting or disconnecting ! cables. 2. Connect the monitor to the DVI female port labeled “MONITOR” on

Resumen del contenido incluido en la página 6

NTI VIDMUX Series 2-Port DVI Video Switch 4. Plug the 5VDC AC adapter into the power jack on the rear panel. Rear View of SE-DVI-2 Monitor Video 2 Video 1 R NETWORK 5VDC TECHNOLOGIES NTI INCORPORATED 1275 Danner Dr Tel:330-562-7070 Aurora, OH 44202 Tel:800-742-8324 www.networktechinc.com 5 VDC Barrel AC ADAPTER Power Connector 5VDC @ 2.0A OUTPUT (Outside (Inside barrel) barrel) 2.1 mm x 5.5 mm Female 5. Power up the VIDMUX first. 6. Power up the monitor. 7. Power up one or both of the video

Resumen del contenido incluido en la página 7

NTI VIDMUX Series 2-Port DVI Video Switch TROUBLESHOOTING If the VIDMUX is not working properly, please look for a solution in the list below: PROBLEM: No video at all SOLUTION: Check cable connections on each video source, monitor and the VIDMUX. After reconnecting, if a CPU is the video source, the CPU may need to be re-booted in order to sense the monitor connection. PROBLEM: No video on one port SOLUTION: Check cable connections on that port. Power cycle the corresponding video source whil