Manual de instrucciones de Kathrein BAS 60

Resumen del contenido incluido en la página 1

Conversion set for flat antenna BAS 60 / BAS 61
- Modification instructions -
The conversion set for BAS 60/BAS 61 enables you to convert your mobile flat
Important notice!
antenna to a stationary antenna. The use determination (purpose) of your
antenna will also change. After the rnodification has been effected, the antennas
are identical with the flat antennas BAS 62 or BAS 63. These are flat antennas for
stationary use. The instructions for the „Conversion set“ are complemented by the
12-page

Resumen del contenido incluido en la página 2

Conversion Milled screws LNB-cover 1. Unscrewing the cable from the LNB The LNB of the flat antenna BAS 61 has two outputs. The LNB of the flat antenna BAS 60 has only one Antenna cable antenna output. • Loosen the two milled screws of the LNB cover. Remove the cover and place it within reach. • Unscrew the cable from the LNB and pull it out of the cable support on the LNB. Flat antenna • Then screw the LNB cover again to the flat antenna. This will protect the LNB during the transport of the

Resumen del contenido incluido en la página 3

4. Driving without the mounted flat antenna lf you wish to drive with your vehicle without the flat Mobile antenna support antenna mounted, but the jointed mast still installed, you should protect the antenna as shown in opposite Joint illustration. • Care for adequate insulation or sealing of the Cable binder antenna plug. Protect the plug from moisture. Cable plug • Bend the antenna cable to the form of a loop and introduce the end of the cable into the joint of the mast until the plug has