Manual de instrucciones de Pioneer XM Digital Satellite Data & Audio Receiver GEX-P10XMT

Resumen del contenido incluido en la página 1

Connecting the Units
Note:
• This unit is for vehicles with a 12-volt battery and
• When replacing the fuse, be sure to only use a fuse
negative grounding. Before installing it in a recre-
of the rating prescribed on the fuse holder.
ational vehicle, truck, or bus, check the battery
• To prevent incorrect connection, the input side of
voltage.
the IP-BUS connector is colored blue, and the out-
• To avoid shorts in the electrical system, be sure to
put side is colored black. Connect the connector

Resumen del contenido incluido en la página 2

Connecting the Units Connecting the power cord and antenna Connecting the system (2) When connecting this product to the unit, support the data communication functions (e.g. AVIC-D1, AVIC-N2, AVIC-N1) by both an IP-BUS and XM DATA cable, connect each Antenna Unit This product equipment as below. Antenna Input Navigation system (sold separately) (e.g. AVIC-D1, AVIC-N2, AVIC-N1) Display unit Note: Violet When combining this product with AVIC-N1 (sold separately), be sure to updated with the latest

Resumen del contenido incluido en la página 3

Installation A Title (English) Note: Installing the Unit • Before making a final installation of the unit, tem- • Install the antenna on as flat a place as possible. porarily connect the wiring to confirm that the con- • Do not paint the antenna, as this may affect its per- nections are correct and the system works proper- formance. Mounting with Brackets ly. • Do not place items such as magnetic cards close to • Use only the parts included with the unit to ensure the antenna because it has a p

Resumen del contenido incluido en la página 4

Installation Route the antenna cable Installing the Antenna Unit When routing the lead inside the trunk Installation using the magnet of antenna Waterproof pad Make sure the waterproof pad 6in. (15.5 cm) contacts the top of the rubber packing. clamper Clamps Use clamps to secure the lead where necessary inside Make a U-shaped loop in the the vehicle. lead outside the rubber 6in. (15.5 cm) packing to prevent rainwater from flowing along the lead into the interior of the vehicle. Rubber packing Wh