Resumen del contenido incluido en la página 1
MP1311
Owner's Manual
AM/FM/CD/MP3/WMA Receiver
MP1311 MP3/WMA RECEIVER
MONO
TUNE
EQ
/
AUX IN
SCAN
MENU (0)
(7)
Resumen del contenido incluido en la página 2
MP1311 PREPARATION Getting Started need a kit but cannot locate one, call our Disconnect Battery customer support line at 1-800-323-4815. Congratulations on your purchase of the Phase Before you begin, disconnect the battery (U.S.A. and Canada only.) Linear MP1311 Mobile AM/FM/CD/MP3/WMA negative terminal. Receiver. It’s a good idea to read all of the Tools and Supplies instructions before beginning the installation. The following tools and supplies are needed to We recommend having your P
Resumen del contenido incluido en la página 3
/ MONO CD1211 CD RECEIVER TUNE EQ / SCAN AUX IN CD1211 CD RECEIVER MONO TUNE EQ SCAN AUX IN MP1311 INSTALLATION INSTRUCTIONS This unit is designed for installation in cars, Universal Installation Using trucks and vans with an existing radio opening. Mounting Sleeve In many cases, a special installation kit will be 1. Remove the detachable front panel, if it is required to mount the radio to the dashboard. attached to the chassis, by pushing the These kits are available at electronics supp
Resumen del contenido incluido en la página 4
MP1311 9. Attach one end of the perforated support 2. Install the radio/mounting plate assembly Longer screws may damage components strap (supplied) to the screw stud on the to the sub-dashboard according to the inside the chassis. rear of the chassis using the hex nut instructions in the installation kit. provided. Fasten the other end of the 3. Attach the support strap to the radio and perforated strap to a secure part of the dashboard as described in the Universal dashboard, either above o
Resumen del contenido incluido en la página 5
MP1311 Remove Radio To remove the radio after installation, remove the trim ring by lifting in the center and pulling it off from either side. Insert the removal keys straight back until they lock, and then pull the radio out. If removal keys are inserted at an angle, they will not lock properly to release the unit. Removal Key 5
Resumen del contenido incluido en la página 6
15 MP1311 WIRING 1. Power Antenna (dark blue wire) - Connect 5 to power antenna or amplifier. If not used, tape bare end of wire. 2. Accessory/Ignition (red wire) - Connect to existing radio wire or radio fuse. 3. Ground (black wire) - Connect to ground terminal or clean, unpainted part of chassis. 4. Memory/Battery (yellow wire) - Connect to battery or 12 volt power source that is Dark Blue always live. The radio will not work if this 1 wire is not connected. 5. Antenna Connector - Conn
Resumen del contenido incluido en la página 7
MP1311 OPERATING INSTRUCTIONS Power Select clockwise or counter clockwise to adjust the bass from “-10” to “+10”. “00” represents a flat Press the power button (1) or any other button Press the AUDIO CONTROL button (4) to step response. The bass level is shown on the on the face of the receiver to turn the unit on through the menu of audio functions: volume display for five seconds or until another function when the ignition switch is on. Press the power (VOL), bass (BAS), treble (TRB), ba
Resumen del contenido incluido en la página 8
T T T T C C C C L L L L E E E E E E E E S S S S H H H H S S S S PU PU PU PU MP1311 Balance X-BASS (BAND) Equalizer Selector (EQ) Press the AUDIO CONTROL button (4) four Press and hold the BAND button (5) for two The equalizer function applies preset sound times until “BAL” appears in the display. Within seconds to activate the X-BASS feature. When effects to the unit’s audio output signal. Press five seconds, turn the AUDIO CONTROL (3) listening to music at low volume levels, this EQ (20) t
Resumen del contenido incluido en la página 9
CD1211 CD RECEIVER MONO TUNE EQ / AUX IN SCAN MP1311 Display (D) Front Panel Release that it is correctly engaged, then lightly press the left side of the panel until the mechanism When the unit is off, the LCD displays the time The front panel release button (10) releases the locks it into place. of day. When the unit is on, the LCD mechanism that holds the front panel to the automatically shows the tuner or CD display, chassis. Reset Button depending on which mode of operation is Detachi
Resumen del contenido incluido en la página 10
MP1311 TUNER OPERATION AM/FM Band Selector (BAND) Scan Tuning (SCAN) Preset Stations Press BAND (5) during radio play to switch Press SCAN (15) to scan upwards through all Up to six stations on each band can be stored between three FM bands and one AM band. the strong channels in the current band. The as presets and can then be instantly recalled by “F1”, “F2”, “F3” or “AM” will appear in the unit will pause and play each station for five pressing the associated preset button on the display t
Resumen del contenido incluido en la página 11
MP1311 Repeat for the remaining five presets on the Mono/Stereo Selector (MONO) current band and for all presets on the other Press MONO (18) during FM radio operation to three bands. select stereo reception of the broadcast signal. Under normal reception, the unit should be left Automatically Store / Preset in the stereo mode as indicated by the “ST” Scan (AS/PS) designation and the associated signal strength Automatically Store indicator that appear on the display panel when Select six
Resumen del contenido incluido en la página 12
MP1311 CD PLAYER OPERATION Insert CD During either function, the elapsed time will Disc Scan (SCN) appear on the display. Release the button to With the label surface facing up, gently insert During disc play, press SCN (24) to play the resume CD play. the disc into the CD slot (21) until the soft- first 10 seconds of each track on the disc. “S-- loading mechanism engages and pulls the disc SCN” will appear in the display. When the Play/Pause in. Disc play begins, “CDP PLAY” will appear in de
Resumen del contenido incluido en la página 13
MP1311 Disc Repeat (RPT) CD Player Error Codes Press RPT (25) during disc play to continuously If a problem should develop while operating the repeat the selected track. “S--RPT” will appear CD player, an error code (ER-1, ER-2, etc.) in the display. Press RPT again to stop may appear on the display panel. This can repeating. “S--RPT” will disappear from the indicate a number of problems with the unit, display, and regular play will resume. The including a mechanical error or an error in the
Resumen del contenido incluido en la página 14
MP1311 MP3/WMA OPERATION MP3 and WMA (Windows Media Audio) music Acceptable Disc Formats MP3/WMA Encoder and CD files are digital audio files that are compressed Writer Settings The following formats are available for the to allow more files on a single CD. This unit can media used in this unit. The maximum number Use the following settings when compressing play MP3/WMA directly from files contained on of characters used for file name including the audio data in MP3 data with the MP3 enc
Resumen del contenido incluido en la página 15
9 2 5 27 28 17 MP1311 Entering ID3 Tag Writing Files into a Disc Electronic Shock Protection • 10 seconds for CDDA (CDA) This unit supports ID3 tag versions 1.0 and 1.1. When a disc containing MP3/WMA data is For the character codes, refer to the table loaded, the unit checks all data. If the disc • 100 seconds for MP3/WMA recorded at contains many folders or non-MP3/WMA files, below. 44.1kHz, 128kbps MP3/WMA play will be delayed, it may take Bit Rates time for the unit to move to the next
Resumen del contenido incluido en la página 16
MP1311 You may be able to set the order in which MP3/ Pause MP3/WMA File or Folder Search WMA are to be played by writing them onto a Press the 1/>/|| button (23) to suspend disc The unit offers four methods of searching for disc such as a CD-R with their file names play. Press the play/pause button again to files or folders on a disc. beginning with play sequence numbers such as resume play. Direct File Number Search "01" to "99". Track Select Press the AS/PS button (17) to enter Direct F
Resumen del contenido incluido en la página 17
MP1311 button (5) to begin the search, or wait a few Root Directory Search steps 2 and 3 to select a file for seconds for the search to begin automatically. 4. Press the AS/PS button (17) three times to playback. enter Root Directory Search mode. The • If a file is selected, playback begins You can also turn the rotary to access and file LCD will display the first folder or file name automatically. numbers sequentially. After locating the desired in the root directory. • Select the folder ic
Resumen del contenido incluido en la página 18
MP1311 REMOTE CONTROL The remote control will allow you to control the basic functions of the MP1311. The remote control sensor is located on the left side of the front panel to the right of the MONO button (18). S AMS = AS/PS VOL PEQ = EQ MOD = MODE VOL LOC = Local/Distant BND = BAND D U LOUD TR. UP TR. DN SCN = Scan, AM, FM BND SCN MOD MUT = MO = MONO LOC AMS PEQ DISP = Clock / Frequency MO MUT DISP PAU SCN RPT 12 3 5 4 6 SHUF DN UP 18
Resumen del contenido incluido en la página 19
MP1311 CARE AND MAINTENANCE CD Player Compact Discs CDs, as they can irreparably damage the disc’s surface. CD-R and CD-RW Capability The following guidelines will help you extend 3. Discs should be kept in their storage the life of your CD player: Depending on media type and method of cases when not in use. "recording/burning", some CD-R/RWs may be 1. When cleaning the vehicle interior, do not 4. Do not expose discs to direct sunlight, incompatible with this unit. After "recording/ get w
Resumen del contenido incluido en la página 20
MP1311 TROUBLESHOOTING Problem Cause Corrective Action Does not operate (display does not No power to yellow wire; no power to red wire Check connection with test light; check vehicle fuse with test light) light. Inline fuse blown Replace fuse. No power to unit Inline fuse blown Check/replace fuse. Not all speakers operate Incorrect splices or connections Check all splices and connections. Speaker wires shorting to chassis ground or to Check splices; insulate all bare wires. each other Blows fu
