Manual de instrucciones de Centurion

Resumen del contenido incluido en la página 1

฀
Martindale
Centurion Safety Products Ltd
21 Howlett Way, Thetford, Norfolk, IP24 lHZ, UK
Tel: +44(0)1842 754266 Fax: +44(0)1842 765590
USER INFORMATION AND INSTRUCTIONS
FOR USE & MAINTENANCE
We have made every effort to ensure that the information given in this catalogue is accurate, but
our policy of continuous product development means specifications are likely to change and such
information is for guidance only. Martindale will not accept liability for any loss, damage or
cons

Resumen del contenido incluido en la página 2

Technical Specification Flow rate testing of your Max helmet Products fitted with grey strongrings are Intrinsically safe (please see instructions specific to Prior to each use of your helmet, please check the manufacturers minimum design flow rate using hazardous installations). Products fitted with black strongrings are only intended for use in working the Max test flow indicator which is provided with your Max helmet. The indicator can also be areas where there is no possibility of explosive

Resumen del contenido incluido en la página 3

Ear Protection Meets acoustic performance of EN352-3 Face Seal If the visor face seal becomes torn or damaged in any way you must immediately replace the Attenuation data Mean attenuation and standard deviation as measured in face seal assembly. To fit, follow the instructions given for the P1 visor. For P2 face seal BS EN 24869-1: replacement, remove the black stud on either side by griping the face seal behind the stud and pulling away to de-snap. Carefully peel away the face seal from the vis

Resumen del contenido incluido en la página 4

STRONGRING MARKINGS To replace Reposition two cradle brackets through the two slots within the forehead section of the face (Intrinsically Safe) seal. Replace the two cradle brackets into the strongring slots at the front of the shell. Relocate Instructions specific to hazardous area installations (reference European ATEX both sides of the face seal onto the ear defender surrounding with the white studs. Locate the Directive 94/9/EC Annex II 1.0.6). The following instructions apply to eq

Resumen del contenido incluido en la página 5

be cut/modified to accommodate the spectacle arms. This can best be accomplished by cutting the face seal at the required level with a pair of scissors (see below). To fit 1. The EH1 is for mining applications only and is Category M1 equipment, i.e. may be Cut away the surplus material until a suitable fit is achieved with scissors. Carefully remove only a used irrespective of the presence of explosible concentrations of firedamp. little at a time, as a gap of more than 2mm will seriously reduc

Resumen del contenido incluido en la página 6

NAMES OF PARTS Fitting Instructions Foam Face Headband Seals Sweatband (P1 version) To adjust Adjust the headband by pressing the edge of the headband buckle and opening the headband to its Cradle Assembly fullest position. Then slightly pull the strap through the buckle and place the helmet on your head to Ear Defender Ring test the fit. Continue with this by pulling the strap through the buckle further each time until the helmet fits firmly on your head. To achieve adequate protection this hel