Resumen del contenido incluido en la página 1
Custom-Engineered, Low-Intensity
Infrared Heating Systems
Submittal: CRV-Series
Job:
Location:
Engineer:
Gas Specs:
Date:
QTY. MODEL NO. CRV UNIT INPUT BTU/HR
QTY. MODEL NO. CRV UNIT INPUT BTU/HR
QTY. MODEL NO. CRV UNIT INPUT BTU/HR
QTY. MODEL NO. CRV UNIT INPUT BTU/HR
TOTAL INPUT BTU/HR
Important
Before installation and operation of heating equipment, read and understand the
Installation, Operation and Service Manual.
Resumen del contenido incluido en la página 2
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET STANDARD PARTS LIST 0133580D 4" Coated 90° Elbow Contents of CRV-Series Burner Carton 01336101 4" Aluminized 45° Elbow Part No. Description Quantity 0133610D 4" Coated 45° Elbow 0270XXXX CRV-Series Burner (Rate and Fuel Varies) 1 91409300 16 Ga. Hot Rolled Steel 4" dia. 10' Tube 91412200 1/2" Flex Gas Line 1 91409403 16 Ga. Non-heat treated Aluminized 4" dia. 10' Tube 013676XX End Vent Plate 1 91409408 16 Ga. Heat Treated Aluminized 4" dia. 10' Tube
Resumen del contenido incluido en la página 3
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET 91903202 Turnbuckle with Eyebolt Thermostats 05023000 Load Relay Package 02712100 Universal Shield Support 02751800 Universal Shield with Holes 90417600 Transformer Relay - SPST (12A) 02751801 Universal Shield 90436300 Transformer Relay - DPDT (12A) 027518SS Universal Shield, Stainless Steel 90423000 24V Low Voltage Thermostat (Marked 1-5) 90424300 Thermostat Guard Control Packages and Accessories ® BZC700 Deco Grille(1' x 8') ROBERTS GORDON BZC 700 C
Resumen del contenido incluido en la página 4
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET Pump Packages and Accessories 02719105 EP-100 Pump Package 02719100 EP-100 Pump 02724700 Accessory Package 02716305 EP-201 Pump Package 01312001 EP-201 Pump 01317805 Accessory Package 02712034 EP-203 Pump Package 01312002 EP-203 Pump 01317805 Accessory Package 02723014 EP-301 Pump Package 4" 02730101 EP-301 Pump Assembly 02730104 Accessory Package 02723016 EP-301 Pump Package 6" 02730101 EP-301 Pump Assembly 02730106 Accessory Package Pump Accessorie
Resumen del contenido incluido en la página 5
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET GENERAL SPECIFICATIONS Suspension Specifications Material Specification Hang heater with materials with a minimum working Reflectors load of 75 lbs (33 kg). Controls Specifications .024 Mill Finish Aluminium (Optional - 024 Stainless Steel Type 304). Time switches, thermostats, etc. can be wired into Heater Specifications the electrical supply. External controls supplied as an Ignition option. Fully Automatic, Three-Try, Direct Spark, Electronic
Resumen del contenido incluido en la página 6
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET Pump Specifications Pump Dimensional Data (in.) Model ABC D E F G EP-100 17 14.5 21 3.75 10 4 4 % EP-201/203 17.75 17 18.75 3.25 10 4.5 4.5 5 4 EP-301 25.6 24.8 22.7 4.8 15.2 6 6 3 2 6 Pump Specifications Model EP-100 EP-201 EP-203 EP-301 Horsepower (Hp) 1/3 3/4 3/4 2* Phase 1 1 3 1 Hertz (Hz) 60 60 60 60 Voltage (V) 115/230 115/230 230 230 Full Load Amp (Amps) 4.8/2.4 6.6/3.3 3.0 11.5 R.P.M. 3450 3450 3450 3450 Motor Frame 56 56 56 90 Motor E
Resumen del contenido incluido en la página 7
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET CLEARANCES TO COMBUSTIBLES NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, elbows, tees and crosses. 2. Clearances B, C and D can be reduced by 50% after 25' (7.5 m) of tubing downstream from where the combustion chamber and the tube connect. 3. “-” indicates an unapproved application. Roberts-Gordon prohibits the installation of this heater for all unapproved applications. * Protective Grille clearances are the same as Standa
Resumen del contenido incluido en la página 8
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, elbows, tees and crosses. 2. Clearances B, C and D can be reduced by 50% after 25' (7.5 m) of tubing downstream from where the combustion chamber and the tube connect. 3. “-” indicates an unapproved application. Roberts-Gordon prohibits the installation of this heater for all unapproved applications. Universal Shield, Position 1 (inches) (centimeters) Model A B CDA BCD CRV-B-2 4
Resumen del contenido incluido en la página 9
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET NOTE: 1. All dimensions are from the surfaces of all tubes, couplings, elbows, tees and crosses. 2. Clearances B, C and D can be reduced by 50% after 25' (7.5 m) of tubing downstream from where the combustion chamber and the tube connect. 3. “-” indicates an unapproved application. Roberts-Gordon prohibits the installation of this heater for all unapproved applications. 2-Foot Deco Grille (inches) (centimeters) Model A BCD ABCD CRV-B-2 4 12 48 12 11
Resumen del contenido incluido en la página 10
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET CRV-SERIES ASSEMBLY OVERVIEW Major Component Descriptions Tube Burner Hot Rolled, Heat Treated or Coated Aluminized Tube supplied in 10' (3 m) lengths. Reflector Reflector with Hole (Aluminum or (Aluminum or Stainless Steel) Stainless Steel) Alternate overlap as Alternate overlap as shown on overview. shown on overview. Minimum overlap is 7" Minimum overlap is 7" (18 cm). (18 cm). Flex Gas Line 90° Elbow 45° Elbow with shut-off cock Cross
Resumen del contenido incluido en la página 11
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET Major Component Descriptions (Continued) Reflector Joint Reflector End Cap Barrier Shield (Aluminum or Stainless Steel) Remove center section to accommodate heat exchanger tube when necessary. Tube and Reflector Hanger Reflector Side Extension with Clamp Package Position this hanger no more than 4" (10 cm) away from the burner. Tube and Reflector Hanger Suspend system from these hangers. Deco Grille Reflector Support Strap & Wire Form “S” Ho
Resumen del contenido incluido en la página 12
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET Major Component Descriptions (Continued) ® ® ROBERTS GORDON ROBERTS GORDON BZC Indoor Sensor ULTRAVAC™ Adjustable Indoor Sensor ® ROBERTS GORDON ULTRAVAC™ Controller EP-100 Pump Package - 4" dia. For more information, refer to the EP-100 Installation, ® ROBERTS GORDON Operation and Service Manual (P/N 127201NA). ULTRAVAC™ EP-201 Pump Package - 4" dia. Variable Frequency Drive For more information, refer to the EP-201/203 Installation, Opera
Resumen del contenido incluido en la página 13
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET CRV-Series Assembly Overview BEFORE INSTALLATIO N AND OPERATI ON OF HEATIN G EQUI PMENT, READ AND UNDERSTAND THE I NSTALLATION, O PERATION AND SERVICE MANUAL. © 2004 Roberts-Gordon ® APPLI CATIONS, ENGIN EERING AND DETAI LED GUIDANCE ON SYSTEMS DESI GN, I NSTALLATION AND PRODUCT PERFORMANCE I S AVAILABLE UPO N REQUEST. ROBERTS GORDON PRODUCTS ARE TO BE INSTALLED ONLY I N ACCOR DANCE WITH LOCAL LAW S, CODES AND REGULATIONS, AND ONLY BY A CONTRACTO
Resumen del contenido incluido en la página 14
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET HEATER INSTALLATION Critical Hanger Placement < 8 5 2
3 3 2 G 3
& 8
> (.-0'+ 2 F .-*,' G
$ (.-0'+ ' (,* + 'H'(!+ <
! I8J> & (< + /K,'( . + <
! >
$
8 ; <
6
; Run Length Typical Expansion Minimum “X” Length Description Part Number 50' (15 m) ±1" (3 cm) 12" (30
Resumen del contenido incluido en la página 15
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET Tube Installation = <!
E
*- '(*. +
K(, +
!
< <!
E
*'( , +
K(, +
!
4; 2 ! 2 !
G 3 8 <! <! /K,' ( 1 + >
<
! * K : (. + 2 ! 2 !
Description Part Number Tube 91409XXX Turnbuckle 91903201 Tube/Reflector Hanger 03090100 Coupling and Tube Assembly Close coupling w
Resumen del contenido incluido en la página 16
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET Coupling and Tube Assembly (Continued) Tighten Slide Bar as shown below. 5
8 3
4 8 3
!
! N '() + 6 > > Repeat A - D until all tubes are assembled. NOTE: If Coupling is not tight, loss of vacuum can occur. ELBOW PACKAGE CONFIGURATION Elbow Installation
Description Part Number Elbow Package 02718702 90° Elbow 013
Resumen del contenido incluido en la página 17
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET REFLECTOR INSTALLATION Reflector Installation with Hole $
> 8 $
7 ! !
$ >
<! Description Part Number 2 ! Tube/Reflector Hanger 03090100 2 !
Tube 91409XXX Reflector with Hole 02750304 Reflector Installation G
6
8 D $
8
<! $
8
8
7"2 (
Resumen del contenido incluido en la página 18
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET Reflector, U-Clip and Reflector Support Installation The pictorial drawings of the heater construction in tor supports and U-clips depend on the individual this Section are schematic only and provide a gen- installation. Use either pop rivets or sheet metal eral guideline of where hangers, reflector supports screws instead of u-clips when installing end caps and U-clips are to be installed. and joint pieces in areas where impact and high wind
Resumen del contenido incluido en la página 19
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET Burner Installation 3
3
2 ! 2 !
% 4 ; 2 ! 2 !
= 4; ! Description Part Number !
Bolt 94273914 Burner 0270XXXX Lock Washer 96411600 4; Gasket 01367800 ! End Vent 013676XX "#$% BEFORE INSTALLATIO N AND OPERATI ON OF HEATIN G EQUI PMENT, READ AND UNDERSTAND THE I NSTALLATION, O PERATION AND SERVICE MANUAL. © 2004 Roberts-Gordon ® A
Resumen del contenido incluido en la página 20
® ROBERTS GORDON CRV-SERIES SUBMITT AL SHEET OPTIONAL HEATER ACCESSORIES Tee Installation <! 2 < Description Part Number Tee 01330XXX Tube/Reflector Hanger 03090100 Tube 91409XXX Coupling 01312700 Reflector Joint Installation $
$
Q 64 8
! 2
*'( ) + : BEFORE IN STALLATI ON AND OPER ATI ON OF HEATI NG EQUIPMENT, READ AND U NDERSTAND THE INSTALLATION, OPERATIO N AND SERVICE MANUAL. © 2004 Roberts-Gordon ® APPLICATION S, ENGI NEERING AND D
