Manual de instrucciones de Sigma Force Flow Heaters

Resumen del contenido incluido en la página 1

Force Flow Heaters



Installation and Operation Manual





MANUFACTURERS
OF HYDRONIC
HEATING
PRODUCTS
www.sigmaproducts.com Tel: (905) 453-0446 Fax: (905) 453-0675
Rev 3

Resumen del contenido incluido en la página 2

Force Flow Heaters Installation & Operation Manual GENERAL NOTES ADDITIONAL WARNINGS 1. Examine entire unit for damages in Familiarization with and adherence to shipping upon receipt of the unit. Any national electrical code and local/state codes shortages or damage should be noted on is highly recommended. the carrier's delivery document. After 1. Avoid contact with energized circuits inspection issue a purchase order for and/or rotating parts. Contact with operating necessary parts

Resumen del contenido incluido en la página 3

Force Flow Heaters Installation & Operation Manual GENERAL INSTALLATION MAINTENANCE All units are shipped fully assembled. If the Motors. Motors are a permanent split unit is a fully or semi-recessed model type capacitor type fitted with self lubricating then a wall seal trim will be included and sleeve bearings. In order to extend motor life must be installed as per the provided the bearing should be "recharged" with an instructions. annual lubrication. Use an SAE 10 non detergent oil a

Resumen del contenido incluido en la página 4

Force Flow Heaters Installation & Operation Manual FIGURE 2 UNIVERSAL FORCE FLOW COLLARS SIDES AND TOP A standard trim which is used on any semi- ALIGNED AND recessed or fully recessed model. Mounted READY TO BE on sight to allow for infinite mounting depth FITTED adjustment. Simply mark the depth location of the desired reveal minus 1/2" for the trim thickness and fasten the side bars centered with the front edge on the line. (Figure 4 shows sides being mounted to a fully r